Porsche 2001 996 Twin Turbo Installation

World’s Finest Automotive Bra Installation Instructions: C5 (Convertible Only) Rear Noise Cover

Tools required: Sharp scissors

Parts included: hook-tape

Pre Installation

1)Carefully read and follow instructions to ensure optimal performance

2)Find a comfortable, well-lighted place to work.

3)Take your time.

Hook-tape Installation

1)Start on the driver side.

2)Open the driver side car door.

3)Put down the convertible top. Leave the lid for the convertible top in the “up” position.

4)Note! The inside edge of the convertible top lid has a factory installed bumper cushion glued in place to protect the lid from the convertible top frame when the top is down. The SpeedLingerieTM has a ‘cut-out’ at the top edge of the panel. The SpeedLingerieTM cut-out aligns with the factory installed bumper.

5)Affix the long strip of adhesive backed hook-tape to the inside edge of the convertible top lid.

a)Start at the INSIDE edge of the bumper, and work toward the center of the vehicle.

6)Repeat step #5 with the short strip of adhesive backed hook-tape.

a)Trim ¼” from the width of the hook-tape so it is ¾” wide.

b)Start at the OUTSIDE edge of the bumper, and work towards the outside of the vehicle.

7)Repeat steps #2-6 on the passenger side.

SL Rear Noise Cover Installation

1)Start on the driver side

2)Orient the panel for the driver side correctly (body-color side facing forward, cut-out “up” and towards the outside edge of the vehicle).

3)Align the notch in the SpeedLingerieTMwith the bumper on the inside edge of the convertible top lid.

4)Mate the hook and loop tape.

5)Adjust as needed.

6)Repeat steps #2-4 on the passenger side.

7)Close convertible top lid.

Final Adjustment

1)For full effect of SpeedLingerieTM design and glove-like fit, allow 72 hours for material(s) to relax and conform.

2)Park in a warm sunny spot with the SpeedLingerieTMon for a few days, to help the process.

3)You may apply a quality vinyl conditioner if you so desire.

Care & Maintenance

1)For best results, be sure that vehicle surfaces are clean and dry before installing SpeedLingerieTM.

2)Clean outer vinyl surfaces of SpeedLingerie with a high quality conditioner during routine car maintenance.

Congratulations again on the purchase of your SpeedLingerie.

Installation Questions? Call 1(800) 570-1579 for assistance.

Page 1

rev0304