ACTA SCIENTIFIC NUTRITIONAL HEALTH (ISSN:2582-1423) Volume 4 Issue 10 October 2020 Research Article Physico-Chemical Analysis of Honey Produced in Bako-Tibe District, Western Showa Zone, Oromia Region, Western Ethiopia Million Chimdessa1* and Desalegn Begna2 Received: July 23, 2020 1Bule Hora Universities, College of Natural and Computational Science, Biology Published: September 11, 2020 Department, Ethiopia © All rights are reserved by Million 2Ambo University, Department of Animal Genetics and Breeding, Ethiopia Chimdessa and Desalegn Begna. *Corresponding Author: Million Chimdessa, Bule Hora Universities, College of Natural and Computational Science, Biology Department, Ethiopia. Abstract Honey production is a long-standing practice in the rural communities of Ethiopia in general and Oromia regional state in particu- lar. However, there is scanty information with regards to the quality of the honey produced in the most parts of Oromia. The study was conducted to assess the Physico-Chemical Analysis of honey produced around Bako Tibe district, western Showa, Ethiopia. A total of 13 fresh honey samples each weighing 50 gram were randomly collected from three agro-ecologies of the district. The collected honey samples were analyzed in the laboratory for their physico-chemical parameters. The average results indicated that 19.81%, 4.23, 21.43meq, 0.11 % for moisture, pH, free acidity and ash, respectively. According to this analysis, the results of all the samples fall within acceptable ranges for the national and international standards. This study investigated and availed the honey quality results of study area and ascertained all the values concur with local and international requisites. Owing to lack of testing facility, the informa- tion on the honey safety aspects still remain blurred, requiring further investigations. Keywords: Moisture; Honey; Acidity; Quality; Standards; pH Introduction ing parts of plants is considered as a natural sweet substance and Ethiopia is blessed with adequate water resources and various medicine. In terms of its uses honey is regarded as a nutrient and a drug [5] and source of carbohydrate. of beekeeping [1]. As a result, with over 10 million honeybee colo- honeybee floras, which create fertile ground for the development The chemical composition of honey is mainly depend on the nies, the country possesses the highest honeybee population in vegetation sources from which it derived, climate, harvesting and Africa and yearly produces about 54,000 metric tons of honey and storage conditions. Honey consists primarily of simple sugars, wa- this is only 10% of its production potential. With this, the country ter, minerals, and nitrogenous compounds [6]. ranks 4th and the 10th largest producers of beeswax and honey in the world, respectively [2]. Honey production is a long-standing The quality of honey is a key factor for both local and inter- practice in the rural communities of Ethiopia and appears as an- national markets for both to ensure premium prices and human cient practice [3] and dominantly run by the small-scale farmers. health. The physical and chemical properties of honey are the most commonly monitored parameters as international quality stan- poverty lessening in rural areas [4]. Beekeeping is significantly contributing to the off-farm income and dards for honey [6,7]. Sugars, water, proteins, enzymes, acids and minerals are the main constitutes of honey [6] and their quality According to Codex Alimentarius, 1989, honey that is produced affected by heating at high temperatures, high moisture content, by honeybees from the nectar of blossoms and/or secretion of liv- adulteration, poor packaging and poor storage conditions. Citation: Million Chimdessa and Desalegn Begna. “Physico-Chemical Analysis of Honey Produced in Bako-Tibe District, Western Showa Zone, Oromia Region, Western Ethiopia". Acta Scientific Nutritional Health 4.10 (2020): 10-15. Physico-Chemical Analysis of Honey Produced in Bako-Tibe District, Western Showa Zone, Oromia Region, Western Ethiopia 11 However, honey quality issue is largely disregarded by produc- Beehives and number of sampled Total ers and processors in most beekeepers of the country and reports Agro- honey No are available only for limited places. To this fact, only quality as- ecologies Traditional Transitional Frame pects of honey from Burie district of Amhara Region [8], honey beehive beehive beehive from Gomma district [9], and honey from Horo districts [10] and 1 Lowland 2 2 2 6 honey from Tigray region [11] have been studied so far. 2 Midland 2 2 - 4 3 Highland 3 - - 3 Therefore, the present study is aimed at determining the quality 4 Total 7 4 2 13 of honeys produced in three agro-ecologies of Bako-Tibe district by comparing with local and international honey quality param- Table 1: Honey samples from different agro-ecologies and eters and make an information contribution to what are available beehives. so far. Physico chemical analysis Materials and Methods The honey compositions that included moisture content pH, Description of the study area acidity, ash (mineral) of the honey samples were determined ac- Bako Tibe district is situated Ethiopia within Latitude: 9° 00’ cording to the Harmonized Methods of the International Honey 0.00” N and Longitude: 37° 09’ 60.00” E (Figure a). The district Commission done at Ethiopia quality standard Authority of Ethio- is categorized in to three agro-ecologies namely, highland (2400m pia, Addis Ababa. to 3000 meter above sea levels), midland (1800m to 2400 masl), Moisture content of honey and lowland (1650 - 1800 masl) and each agro-ecology accounts The moisture content of all the collected honey samples were 12%, 37% and 51% of the district, respectively. With cool to warm, determined using digital Abbe refractometer (ATAGO ®1211 NAR- the mean annual temperature of the district is 21.2oC with mean 1T Liquid Abbe refractometer with Refractive Index 1.3000 to annual rainfall 1266 mm (Bako-Tibe district Agriculture and rural 1.7000nD, Brix 0.0% to95.0%, accuracy of refractive index (nD) ± 0.0002 and Brix ± 0.1%, made of Japan), thermo stated at 200C and development office). regularly calibrated with distilled water (Figure 1). The refractive indexes after two minutes were read the corresponding moisture content and the content of each sample measured twice and the average value recorded [12]. Figure a: Map of the study area. Sample size and sampling technique A total of 13 fresh honey samples each 0.5gr were purchased from the three agro ecologies harvested from different beehive types (Table 1). The honey collections were done from November to December at the times of peak honey harvesting season of the Figure 1: Measuring moisture content of honey using digital year. Abbe refractometer. Citation: Million Chimdessa and Desalegn Begna. “Physico-Chemical Analysis of Honey Produced in Bako-Tibe District, Western Showa Zone, Oromia Region, Western Ethiopia". Acta Scientific Nutritional Health 4.10 (2020): 01-15. Physico-Chemical Analysis of Honey Produced in Bako-Tibe District, Western Showa Zone, Oromia Region, Western Ethiopia 12 pH content of honey the accepted range (17.5% - 21%). Moisture content of honey can The pH of each honey sample was determined using digital pH ranges from 13% - 23% [14]. Separate analysis of honey samples meter (3100Janeway, England). A 10g of honey sample was dis- from different beehives indicated 18.57%, 20.25%, 23.75% mois- solved in 75 ml of distilled water in 250 ml beaker. The solution ture contents for the honey from traditional, transitional and im- was stirred with magnetic stirrer and the pH value was recorded proved box beehives, respectively and the difference is statistically [12]. on the moisture content of honey [14]. The higher honey moisture significant (P < 0.000). This suggests the impact of beehive type Acidity of honey contents in modern beehive might be attributed to harvesting of Ten grams of honey were weighed with the help of electrical [14]. unripe honey and this influence honey moisture content water. The solution was titrated against 0.1 N NaOH solutions in Likewise, the moisture contents of honey samples varied based sensitive balance and poured in conical flask and 75 ml of distilled burette using phenolphthalein as indicator. The titration was car- agro ecologies and 18%, 19.38%, 21.17 % were recorded for the ried out till the solution turns pink from colour less. The acidity highland, midland and lowland, respectively (Table 3). Environ- was determined using the formula that is developed by Agbagwa., mental temperature and moisture content of original plant affect et al [13]. the honey moisture content [14]. Total Acidity = Titration reading x Normality of NaOH x 9 pH Weight of Sample Lower content of pH in honey inhibits the presence and growth Ash content of micro-organisms and makes honey compatible with many food Two grams of honey were weighed and taken in a silica crucible products in terms of pH and acidity. This parameter is of great im- OC for 3-4 hours. The weights of the ash were the texture, stability and shelf life of honey. with 3-4 drops of olive oil added to avoid fluttering and kept in portance during the extraction and storage of honey as it influences determined by deducting the weight of empty crucible from the to- muffle furnace at 600 tal weight of empty crucible and ash and the percentage of ash was The overall mean result is 4.23 ± 0.14 pH content with 4.0 mini- calculated using the formula developed by Agbagwa., et al 2011. mum and 4.40 maximum values for the honey samples collected from different beehives in the study areas (Table 2). There are Data analysis variations among the honey samples in their pH based on the bee- All the data on the honey quality parameters were coded and hive types. To this fact, 4.26 ± .13, 4.15 ± 0.17 and 4.3 ± 0.00 were recorded for the honey from traditional, intermediate and modern differences among variables, one way ANOVA was computed and beehives, respectively.