Save These Instructions

Save These Instructions

ENGLISH - Never operate this product if it has a damaged power cord, if it is not SAVE THESE working properly, after it has been MG5750 dropped or damaged, or dropped INSTRUCTIONS IMPORTANT into water while plugged in. For assistance call IMPORTANT: The power plug contains a SAFETY 1-800-243-3050. transformer. Do not cut off the power plug - Never immerse the product in water to replace it with another plug as this will INSTRUCTIONS or rinse under the tap. cause a hazardous condition. When using an electric product, basic - Keep the product, power cord and precautions should always be followed, any attachments away from heated Introduction including the following: surfaces. Congratulations on your purchase and Read all instructions before using this - Never drop or insert any object into welcome to Philips Norelco! product. any opening. To fully benefit from the support that - Do not use the adapter in or near a Philips Norelco offers, register your power outlet that contains an electric product at www.norelco.com/register. DANGER air freshener to prevent damage to To reduce the risk of electric shock: the power cord. Do not reach for a corded product 1 - - Do not operate, charge, clean or that has fallen into water. Unplug plug in product outdoors or operate immediately. 1 where aerosol (spray) products are 7 14 Use product only in dry condition. - being used or where oxygen is being 3/64in 1mm Do not use while bathing or in a 8 5/32in administered. 4mm shower. 2 5/64in 15 - Always check cutters, cutting unit 2mm Do not place or store the product 9 3/8in BC - and guards before using the product. 9mm 1/8in where it can fall or be pulled into a Do not use the product if cutters, 3mm 16 10 tub or sink. Do not place or drop the 3 cutting unit or guards are damaged, 15/32in product in water or other liquid. 12mm as injury may occur. 3/16in - Always unplug this product from the 5mm 11 17 Always attach power cord to product 9/32in 21/32in - 7mm electrical outlet immediately after first, then to power outlet. Be certain 18 16mm use, except when product is (re) plug is inserted firmly into product 4 charging. up to mark indicated on plug. To Unplug and remove power supply 12 - disconnect, turn product off then 5/32in – 3/8in 19 cord from this product before 13 4-9mm remove power cord from outlet. 5 cleaning. - Keep the power cord dry at all times. - The batteries used in this product Do not handle with wet hands. may present a fire or chemical burn 20 - Never put the product in direct hazard sunlight or store at a temperature 3/16in 21 if mistreated. Do not disassemble, 6 1/8in 5mm above 140°F (60°C). 3mm heat above 100°C (212°F) or - To prevent possible damage to the Manufactured for: incinerate. power cord, do not wrap power cord Philips Consumer Lifestyle A division of Philips Electronics around the product. North America Corporation - This product is for use on human hair General description (Fig. 1) P.O. Box 10313, Stamford, CT 06904 WARNING only. Do not use the product for any 1 Extra-wide hair trimmer To reduce the risk of burns, fire, other purpose. 2 Precision trimmer This symbol on the product’s nameplate means electric shock, or injury to persons: it is listed by Underwriters’ Laboratories, Inc. - Always store the product, 3 Nose trimmer - Close supervision is required attachments and power cord in 4 Full-size hair trimmer Norelco is a registered trademark of when this product is used by, on, Philips Electronics North America Corporation. a moisture-free area. Make sure 5 On/off button or near children, or persons with the cord is disconnected from the 6 Socket for small plug PHILIPS and Philips shield are registered trademarks of limited physical, sensory, or mental product. 7 Stubble guard 3/64in. (1mm) Koninklijke Philips N.V. capabilities or invalids. - Do not attempt to open the product 8 Stubble guard 5/64in. (2mm) ©2017 Philips Electronics North America - Use this product only for its intended to remove/replace the built-in 9 Beard guard 1/8in. (3mm) Corporation. All rights reserved. use as described in this manual. Do rechargeable battery. 10 Beard guard 3/16in. (5mm) not use attachments not specified - Only use the power cord and other 11 Beard guard 9/32in. (7mm) by Philips Electronics North America accessories supplied with the 12 Power plug Corporation. product. 13 Small plug www.philips.com 4222.002.8790.1 14 Hair guard 5/32in. (4mm) 15 Hair guard 3/8in. (9mm) Charging 2 To attach a cutting element, insert Guard inch mm 16 Hair guard 15/32in. (12mm) When the product has charged for 1 hour, the lug of the cutting element into the 17 Hair guard 21/32in. (16mm) guiding slot at the front and push the Stubble 3/64in. 1mm it has a cordless operating time of up to guard 18 Fading hair guard 5/32in.-3/8in. 3 hours. back of the cutting element onto the (4-9mm) product (‘click‘) (Fig. 4). - Charging, recharging or using the product Stubble 5/64in. 2mm 19 Fading hair guard 5/32in.-3/8in. at temperatures below 40°F (4,5°C) or Detaching the nose trimmer guard (4-9mm) higher than 95°F (35°C) adversely affects 1 Place your finger on the arrow at the Beard guard 1/8in. 3mm 20 Body guard 1/8in. (3mm) the lifespan of the battery. back of the attachment and push it off 21 Body guard 3/16in. (5mm) - If the product is subjected to a major the handle in the direction of the arrow Beard guard 3/16in. 5mm Not shown: cleaning brush, pouch change in temperature, pressure or (Fig. 5). Beard guard 9/32in. 7mm humidity, let the product acclimatize for Attaching and detaching guards 1 Attach the guard to the full-size hair 2 3 4 30 minutes before use. 1 Make sure the product is switched off. 1 To attach any type of guard onto a trimmer. 2 2 Insert the small plug into the product cutting element, slide the front part of 2 To trim the most effective way, move the guard against the direction of hair 1 and put the power plug in any 120V AC the guard onto the teeth and push the 1 growth (Fig. 11). Make sure the surface 2 outlet (Fig. 2). projection at the back of the guard into 3 After charging, remove the power plug the product (‘click‘) (Fig. 6). of the guard always stays in contact from the wall outlet and pull the small 2 To detach any type of guard from the with the skin. 5 6 7 plug out of the product. cutting element, carefully pull its back Attachments for use on body 1 Note: An adapter plug may be necessary part off the product and then slide it off the cutting element (Fig. 7). - Use the green body guards to trim for cord usage in some foreign countries. body hair. 2 Use an attachment plug adapter of the Note: When trimming for the first time, - When you trim for the first time, use the proper configuration for power outlet. start by using the guard with the maximum 5mm/3/16in. body guard to familiarize trimming length setting to familiarize yourself with the product. Quick charge yourself with the product. 8 9 10 - Make sure hair is clean and dry as wet After approx. 5 minutes of charging, the hair tends to stick to the body and, product contains enough power for one Switching the product on and off when trimming sensitive areas, always cordless trimming session. 1 Press the on/off button once to turn the use a body guard. product on or off (Fig. 8). Since all hairs do not grow in the same Using the product - Attachments for use on beard direction, you may want to try different Always check the product and all trimming positions (i.e. upwards, 11 12 13 accessories before using. Do not use the Full-size hair trimmer downwards, or across). Practice is best product or any accessory if it is damaged, Use the full-size hair trimmer without a for optimum results. as this may cause injury. Always replace a guard to trim hair close to the skin - Always make smooth and gentle damaged part with one of the original type. (to a length of 1/32in (0.5mm) or to create movements and be sure the surface of clean lines around your beard, neck and the guard always stays in contact with Note: This product can be used without sideburns. your skin. cord or directly from the power outlet. 1 To trim hair close to the skin, place the When too many hairs have accumulated 14 15 16 - Note: Switch off and clean the product flat side of the cutting element against on the product, blow the hairs out and attachments after each use. your skin and make strokes against the before use, for best trimming results. direction of hair growth (Fig. 9). - Use this product for its intended Body guards household use as described in this 2 For contouring, hold the cutting Attach a body guard to the full-size hair manual. element perpendicular to the skin and trimmer to trim hairs below the neckline. move it upwards or downwards with - For hygienic reasons, the product The product comes with 2 body guards. 17 18 19 should only be used by one person.

View Full Text

Details

  • File Type
    pdf
  • Upload Time
    -
  • Content Languages
    English
  • Upload User
    Anonymous/Not logged-in
  • File Pages
    4 Page
  • File Size
    -

Download

Channel Download Status
Express Download Enable

Copyright

We respect the copyrights and intellectual property rights of all users. All uploaded documents are either original works of the uploader or authorized works of the rightful owners.

  • Not to be reproduced or distributed without explicit permission.
  • Not used for commercial purposes outside of approved use cases.
  • Not used to infringe on the rights of the original creators.
  • If you believe any content infringes your copyright, please contact us immediately.

Support

For help with questions, suggestions, or problems, please contact us