2A D1100 Digital Preamplifier Output Connections Diagram (when used as a DAC with an Analog only Preamplifier) Note: Refer to the D1100 Owner’s Manual page 8 for additional connection information. Connection Legend: Data Cable*- Digital Signal Cable - Sensor/Keypad Cable - RS232 Cable - Power Control Cable* - Ground Wire - Audio Signal Cable - AC Power Cords - Video Signal Cable - Loudspeaker Cable - RF Signal Cable - * 2 conductor shielded with 1/8 inch stereo mini phone plug on each end. Connect to AC Outlet Analog Preamplifier Connected to the Analog (Preamplifier) Controller TO CONTROLLER TO CONTROLLER Main Power Control Out RIGHT INPUT LEFT INPUT Jack Power Amplifier - Primary Room Right Loudspeaker Left Loudspeaker System System - + - + Connect to AC Outlet McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549 Part No. 04172600 2B D1100 Digital Preamplifier Output Connection Diagram (when used as a stand alone Preamplifier) Note: Refer to the D1100 Owner’s Manual page 9 for additional connection information. Connection Legend: Data Cable*- Digital Signal Cable - Sensor/Keypad Cable - RS232 Cable - Power Control Cable* - Ground Wire - Audio Signal Cable - AC Power Cords - Video Signal Cable - Loudspeaker Cable - RF Signal Cable - * 2 conductor shielded with 1/8 inch stereo mini phone plug on each end. Connect to AC Outlet From Phono Preamplifier PWR CTRL Trig Out Power Amplifier - Secondary Room Power Amplifier - Primary Room Right Loudspeaker Left Loudspeaker System System 6.6 Connect to Right Left AC Outlet Loudspeaker Loudspeaker System System - + - + - + + - Connect to AC Outlet McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549.