Minor Change / Minor Repair easa.europa.eu EASA Rev. Associated Technical Date of Certificate Application Nature Certificate Holder Models Description Certification basis Limitations/Conditions Status level Documentation Issue Number 10073014 MINOR CHANGE 21JAERODESIGN CFM56-3 VSV System - Installation of Feedback The Certification Basis for the original Design Change Document None 15/04/2020 Active LIMITED Coupling.Replacement VSV Feedback product as amendedby thefollowing DCD-0112M issue 1, 19 Mar Coupling P/N 2028M21P01AP for the additional or alternative 2020<(>,<)>Aircraft Manual CFM56-3C-1Engine. airworthiness requirements:the Supplement: AMS-ALL- following paragraph(s) at a later CFM56-3-EIPC Rev 1, 19 Mar amendment: CS-E amdt 5 paras: 2020or later revisions of the 10,20, 25, 50, 90, 100, 110, 510.The above listed document(s) requirements for environmental approved/acceptedunder the protection and the associatedcertif... EASA system. 10073411 MINOR CHANGE ADANAIR S.L. P.68 "OBSERVER" Installation of ASIVE CONSOLE in the interior The Certification Basis (CB) for the MASTER DATA LIST MDL001- Prior to installation of this change/ 05/06/2020 Active of Vulcanair P.68 ObserverThe modification original product remains applicableto Revision 1<(>,<)>Or later repair it must be determined involves the introduction in aircraft this certificate/ approval.The revisions of the above listed thatthe interrelationship between PARTENAVIAS P68of a console for reading of requirements for environmental document(s) approved/ this change/repair and any radio signals in a determined GPS protection and the acceptedunder the EASA otherpreviously installed change position.These signals will be usedfor associatedcertified noise and/ or system. and/ or repair willintroduce no checking the accuracy of ground emissions levels of the product are adverseeffect upon the equipmentcalibration. unchangedand remain applicable to airworthiness of the product. this certificate/approval without any im... 10077231 MINOR CHANGE ADANAIR S.L. B200 Installation of an ASIVE CONSOLE for The Certification Basis (CB) for the Installed and maintained in This design change only covers the 09/09/2021 Active calibration of external instruments original product remains applicableto accordance with ASIVE SB002 installation of the this certificate/ approval.The Revision 1<(>,<)>or later SIVEconsole,wiring and antennas requirements for environmental revisions of the above listed are installed in accordance with protection and the document(s) approved/ STC EASA 10077176.The approval associatedcertified noise and/ or acceptedunder the EASA holder shall fulfill the obligations emissions levels of the product are system. of Part 21, Point21A.109.Prior to unchangedand remain applicable to installation of this change/repair it this certificate/approval without any must be determined thatthe im... interrelatio... 10072968 MINOR CHANGE AERO AT Sp. z.o.o. AT-3R100 Removal of the errors noted in AFM The Certification Basis for the original Revision No 24 dated 04.03 None 03/04/2020 Active product remains applicable tothis 2020 to Airplane Flight certificate/ approval.The Manual (AFM) Doc. requirements for environmental NoATL3.03 (Polish language protection and the version) and Doc. No ATL3.04 associatedcertified noise and/ or (English languageversion)< emissions levels of the product are (>,<)>Or later revisions of the unchangedand remain applicable to above listed document(s) this certificate/ approval without any approved/acceptedunder the impact... EASAsystem. 10075129 MINOR CHANGE AEROCLUB LOUIS DR 400/140 B Avionics upgrade on DR 400/140B aircraft S/ The Certification Basis for the original Definition of modification in This modification only applies to 10/12/2020 Active BONTE N 2086Installation of Garmin GTN650 and product as amendedby thefollowing accordance with section 3 of aircraft S/N 2086.The approval related modifications for VFRoperations additional or alternative ACLB_MC_001Revision holder shall fulfill the obligations airworthiness requirements:- The 1.1Installation in accordance of Part 21, Point21A.109. following paragraph(s) at a later with section 4 of amendment:23.1301(a),23.1301(b), ACLB_MC_001 Revision 23.1301(c), 23.1301(d), 23.1309(e), 1.1Instruction for continued 23.1361(a), 23.1365,23.1367(d), airworthiness in accordance 23.1431(b), 23.1519 from CS23... with section 5 ofACLB_MC_001 Revision 1.1Operation in accordance with section 6 and Appendix 1R... 10074228 MINOR CHANGE AERO CLUB PA-28-181 (ARCHER III) Installation of four (4) Cylinder Head The Certification Basis (CB) for the Minor change description F- This design change approval does 10/09/2020 Active NATIONAL DU Temperature (CHT) and Exhaust original product remains applicableto GYNN, compiled by Patrick not allow replacement of PERSONNELDES GasTemperature (EGT) probes along with this certificate/ approval.The Bezault, Revision0, dated 9 existingengine instruments.This INDUSTRIES cabling anda circuit breaker tosupport requirements for environmental September 2020or later design change approval excludes ELECTRIQUE ET installation of a graphic engine monitoring protection and the revisions of the above listed installation of any graphic GAZIER(ANEG) instrument. associatedcertified noise and/ or document(s) approved/ enginemonitoring emissions levels of the product are acceptedunder the EASA instrument.Graphic engine unchangedand remain applicable to system. monitoring instrument may be this certificate/approval without any installed if specificallyapproved by im... an EASA design approval or allowed by CS-... This report lists certificates issued during the period 01/01/2020 until 28/09/2021. In case you need a certificate not included, please contact [email protected]. Page 1 of 62 An agency of the European Union Minor Change / Minor Repair easa.europa.eu EASA Rev. Associated Technical Date of Certificate Application Nature Certificate Holder Models Description Certification basis Limitations/Conditions Status level Documentation Issue Number 10073818 MINOR CHANGE AERODESIGN AND ATR 72-212 A Installation of TELEX boomsets in ATR72 The Certification Basis for the original INSTALLATION INSTRUCTIONS The approval holder shall fulfill the 16/07/2020 Active MANUFACTURINGTE Cockpit for the observer seat product remains applicable tothis MOBT-1828-INS01, Revision obligations of Part 21, Point21.A. CHNOLOGY S.L. certificate/ approval.The 3CMM SUPPLEMENT 109.Prior to installation of this requirements for environmental MOBT-1828-CMMS01 change/repairit must be protection and the Revision 1Or later revisions of determined thatthe associatedcertified noise and/ or the above listed document(s) interrelationship between this emissions levels of the product are approved/acceptedunder the change/repair and any unchangedand remain applicable to EASA system. otherpreviously installed change this certificate/ approval without any and/ or repair will introduce no impact... adverseeffect upon the airworth... 10077177 MINOR CHANGE AERODESIGN AND ATR 72-212 A Introduction of Alternative Boomsets for the The Certification Basis for the original MASTER DATA LIST This approval is only applicable to 02/09/2021 Active MANUFACTURINGTE ATR 72-212 Flight Crew product remains applicable tothis MOBT-2015-MDL Rev.01 the following Aiprlanes:AIRPLANES CHNOLOGY S.L. ATR 72-211 certificate/ approval.The (31/08/2021)Or later ATR 72 Series; MSN 234, 171, 192, ATR 72-202 requirements for environmental revisions of the above listed 204, 207, 330, 416, 147,150, 274, ATR 72-201 protection and the document(s) approved/ 446, 494, 498, 550, 568, 595, 763, associatedcertified noise and/ or acceptedunder the EASA 809, 824AIRPLANES ATR 42 Series; emissions levels of the product are system. MSN 141, 218, 231, 242, 254, 321 unchangedand remain applicable to (ATR-42)The approval holder shall this certificate/ approval without any fulfill the obligations of2... impact... 10072386 MINOR CHANGE AERO ENGINEERING ATR 72-212 A Owner and Registration Plates Installation The Certification Basis for the original - Project Opening Sheet ATR 42 and ATR 72 all MSN.The 05/02/2020 Active SERVICES ATR 72-101/-102/-211/-212 product as amendedby thefollowing P00968-POS-001 Revision 00 approval holder shall fulfillthe ATR additional or alternative dated 04February2020- obligations of Part 21, Point21A. 42-200/-300/-320/-400/-500 airworthiness requirements:The Certification Report P00968- 109.Prior to installation of this following paragraph(s) at a later CR-001 Revision 00 dated 04 change/repair it must be amendment: CS 25 Amdt 4 - CS25.29; February 2020- Master Data determined thatthe CS 25.561(b); CS 25.603; CS 25.1529; List P00968-MDL-001 Revision interrelationship between this CS 25.1541 and CS 25.1557(b)& (c) 00 dated 04 February 2020- change/repair and any The requirements for environ... Service Bulletin P00968- otherpreviously installed change SB-001 Revision 00 dated 04 and/ or repair will introduce no February 2020or later advers... revisions ofu... 10073317 MINOR CHANGE AERO ENGINEERING CL-600-2E25 (RJ SERIES 1000) Live Animals Cargo Stowage Installation The Certification Basis for the original - Project Opening Sheet CL-600-2C10 MSN 10032; 10036; 29/05/2020 Active SERVICES CL-600-2C10 (RJ 700, 701, product as amendedby thefollowing P00592-POS-001 Revision 00 10037; 10089; 10093; 10096; 702) additional or alternative dated 19May 2020- Service 10198; 10245;10263 to 10265 airworthiness requirements:The Bulletin P00592-SB-001 included, and<(>,<)>CL-600-2E25