3G UMTS W-CDMA Test Software Getting Started Guide Agilent Technologies Notices Copyright © 2001, 2002 Documentation Warranty Agilent Technologies, Inc. CAUTION All rights reserved. The material contained in this document is subject to change without notice. Agilent A CAUTION notice denotes a No part of this manual may be reproduced in Technologies makes no warranty of any kind hazard. It calls attention to an any form or by any means (including with regard to this material, including, but operating procedure, practice, or electronic storage and retrieval or not limited to, the implied warranties of the like that, if not correctly translation into a foreign language) without merchantability and fitness for a particular prior agreement and written consent from purpose. Agilent Technologies shall not be performed or adhered to, could Agilent Technologies, Inc. as governed by liable for errors contained herein or for result in damage to the product or United States and international copyright incidental or consequential damages in loss of important data. Do not laws. connection with the furnishing, proceed beyond a CAUTION notice performance, or use of this material. Manual Part Number until the indicated conditions are fully understood and met. 5971-5027 Warranty A copy of the specific warranty terms Edition applicable to your product and replacement parts can be obtained from your local Sales WARNING Second edition, March 2002 and Service Office. Software version: A WARNING notice denotes a Agilent Advisor 14.0.0 Technology Licenses hazard. It calls attention to an Agilent Network Analyzer 1.1.4 operating procedure, practice, or The hardware and/or software described in this document are furnished under a license the like that, if not correctly performed or adhered to, could Agilent Technologies, Inc. and may be used or copied only in 5070 Centennial Blvd. accordance with the terms of such license. result in personal injury or death. Colorado Springs, CO 80919 Do not proceed beyond a Product Support WARNING notice until the Trademarks Call your local Agilent Technologies indicated conditions are fully representative, or: understood and met. Microsoft ® is a U.S. registered trademark of Microsoft Corporation. Tel: 1-800-452-4844 Fax: 303-754-4802 Windows ® and MS Windows ® are U.S. registered trademarks of Microsoft or call your local Agilent Sales and Service Corporation. Office. Web: http://www.agilent.com/comms/ onenetworks 2 3G UMTS W-CDMA Getting Started Guide Certification General Safety Precautions be present even when the power cable is disconnected. Agilent Technologies certifies that this The following warnings and operating product met its published specifications at information are shown in English followed Do not perform internal servicing or the time of shipment from the factory. by the French translation. adjustment unless another person, capable Agilent Technologies further certifies that of rendering first aid and resuscitation is WARNING This product is a Safety Class I its calibration measurements are traceable present. instrument with a protective earth terminal. to the United States National Institute of Standards and Technology (formerly WARNING For protection from electric Hazardous Material National Bureau of Standards), to the extent shock hazard, power cord ground must not Should the LCD be damaged the liquid allowed by that organization’s calibration be defeated. crystal material can leak. Avoid all contact facility, and to the calibration facilities of with this material, especially swallowing. other International Standards Organization Operating Restrictions Use soap and water to thoroughly wash all members. The following general safety precautions skin and clothing contaminated with the must be observed during all phases of liquid crystal material. Restricted Rights Legend operation, service, and repair of this If Software is for use in the performance of instrument. Failure to comply with these Unauthorized Service a U.S. Government prime contract or precautions with specific warnings in this The installation of substitute parts or the subcontract, Software is delivered and manual violate safety standards of design, installation of any instrument modification licensed as ìCommercial computer manufacture, and intended use of this not authorized by Agilent Technologies is softwareî as defined in DFAR 252.227-7014 instrument. specifically forbidden. The performance of (June 1995), or as a ìcommercial itemî as such unauthorized service can negate the defined in FAR 2.101(a) or as ìRestricted Grounding instrument warranty or any maintenance computer softwareî as defined in FAR agreements. 52.227-19 (June 1987) or any equivalent To minimize shock hazard, the instrument agency regulation or contract clause. Use, chassis and cabinet must be connected to Return the instrument to an Agilent Sales an electrical ground. The instrument is duplication or disclosure of Software is and Service Office for authorized service subject to Agilent Technologiesí standard equipped with a three-conductor AC power and repair. commercial license terms, and non-DOD cable compatible with an approved three-contact electrical outlet. The power Departments and Agencies of the U.S. Government will receive no greater than jack and mating plug of the power cord Restricted Rights as defined in FAR must meet International Electrotechnical Commission (IEC) safety standards. 52.227-19(c)(1-2) (June 1987). U.S. Government users will receive no greater than Limited Rights as defined in FAR Environment 52.227-14 (June 1987) or DFAR Do not operate the instrument in the 252.227-7015 (b)(2) (November 1995), as presence of flammable gases or fumes. applicable in any technical data. Operation of any electrical instrument in Before you use this instrument, read the such an environment constitutes a definite "General Safety Precautions" and safety hazard. "Additional Safety Information" sections. Failure to comply with the precautions or Service and Adjustment with specific warnings in this book violates Dangerous voltages exist within this safety standards of design, manufacture, instrument. Service and adjustment of this and intended use of this instrument. Agilent instrument is to be performed only by Technologies assumes no liability for the trained service personnel. customer's failure to comply with these Do not replace components with the power requirements. cable connected. Dangerous voltages may 3G UMTS W-CDMA Getting Started Guide 3 Additional Safety Information Electric Shock Hazard Do not remove the system covers. To avoid A product marked with this symbol electric shock, use only the supplied power indicates it is a laser product. When cords and connect only to properly necessary, this symbol will be included in grounded (3-pin) wall outlets. the instruction book for the user to refer to in order to protect against personal injury Explosion Hazard and/or correct product handling. Do not operate in the presence of flammable gases. Fire Hazard Indicates potential for electrical shock. For continued protection against fire hazard This is an Installation Category II product. replace only with fuse of same type and This is a Pollution Degree 2 product. rating. This product is designed for indoor use only. Cleaning FCC Part 68 Disclaimer To clean the product, use a damp cloth moistened with a mild solution of soap and This equipment must not be connected to water. Do not use harsh chemicals. Do not the telephone network unless it is let water get into the product. connected through protective circuitry that is registered pursuant to Part 68 of the Product Damage Federal Communications Commission rules. Do not use this product when the product shows visible damage, fails to perform, has been stored in unfavorable conditions, or has been subject to severe transport stresses. Whenever this product has become damaged or wet, make the product inoperative and secure it against any unintended operation. Contact your nearest Agilent Sales office for assistance. Instruction book symbol - the product will be marked with this symbol when it is necessary for the user to refer to the instruction book in order to protect against damage. 4 3G UMTS W-CDMA Getting Started Guide ATTENTION. USE OF THE SOFTWARE IS SUBJECT TO THE AGILENT TECHNOLOGIES SOFTWARE LICENSE TERMS SET FORTH BELOW. USING THE SOFTWARE INDICATES YOUR ACCEPTANCE OF THESE LICENSE TERMS. IF YOU DO NOT ACCEPT THESE LICENSE TERMS, YOU MAY RETURN THE SOFTWARE FOR A FULL REFUND. IF THE SOFTWARE IS BUNDLED WITH ANOTHER PRODUCT, YOU MAY RETURN THE ENTIRE UNUSED PRODUCT FOR A FULL REFUND. AGILENT TECHNOLOGIES SOFTWARE LICENSE TERMS The following License Terms govern your use of the accompanying Software unless you have a separate signed agreement with Agilent Technologies. License Grant. Agilent Technologies grants you a license to Use one copy of the Software. "Use" means storing, loading, installing, executing or displaying the Software. You may not modify the Software or disable any licensing or control features of the Software. If the Software is licensed for "concurrent use", you may not allow more than the maximum number of authorized users to Use the Software concurrently. Ownership. The Software is owned and copyrighted by Agilent Technologies or its third party suppliers. Your license confers no title to, or ownership in, the Software and is not a sale of any rights in the Software. Agilent Technologies’s third party suppliers may protect their rights in the event of any violation