ANTENNA TRAINING LAB ATS04 Features: Description: • 270MHz-3.8 GHz Antenna Training Lab with 20 antennas ATS04 is the world’s most advanced Antenna • Fully Software controlled RF Transceiver with customizable Communication Training and Measurement Lab. It is the frequency and power world’s first Complete 3D measurement training system • Software-controlled 3D positioner along 3D plotting and providing True 3D pattern of an antenna. ATS04 complies measurement software with IEEE Std 149-1979, “Test Procedure for Antennas”. The • Transmit and receive any waveform, any modulation, any complete setup requires minimum space and can be used as frequency, any protocol using any antenna a benchtop system. • Calibrated Signal Generator with precise power, frequency • Calibrated Spectrum Analyser with precise power, The complete setup consists of: frequency • Directional Coupler & Coaxial Slotted line for Return loss, ➢ USB powered calibrated software-controlled Vector VSWR plotting Signal Generator and a calibrated software-controlled • -10dBm Transmit power & -100dBm Sensitivity Receiver Vector Signal Analyzer ➢ Software-controlled 3D positioner with very low RCS • All SMA connector antennas with RG316 cables ➢ Linux based Data Visualization and Management • Works seamlessly with Linux GNURadio, MATLAB, C++ Software and Python ➢ More than 20 different antennas consisting of • Open-licensing of experimentation and study material with narrowband, broadband, directional, Omni-directional No recurring cost! and different polarizations • Latest generation of ASIC architecture with integrated LNA, PA, RX/TX Mixers, PLL, Synthesizers, RX/TX Filters, RX Broadband calibrated reference antenna for gain Gain control, TX power control measurement and broadband directional coupler for return • Support for TDD and FDD configuration loss measurement. • Highly stable 1 ppm TCXO. The setup works as spectrum analyzer, vector signal source and vector signal analyzer. It Covers broadcast television, satellite TV communication. Future ready from simple FM to QPSK, QAM standard to whatever future may hold. Disclaimer: Images shown are Indicative only. Color or Model may differ from the picture shown (Features will remain same or More). Specifications are subject to change without notice. Mfd by: Amitec Electronics Ltd. Regd. Off: 504, Nilgiri, 9 Barakhamba Road, New Delhi-110001, India, Works: 4/32, Site-4, Industrial Estate Sahibabad, NCR-201010, India, [email protected], www.amitec.co +91-11-41505510, +91-120-4371276 ANTENNA TRAINING LAB ATS04 Hardware Technical Specifications: Transmit Receive Frequency Range 270MHz to 3.8GHz 3D Positioner RCS <-20dBsm 3D Software Compatibility MATLAB 3D Plot Compliance IEEE Standard 149-1979 Frequency Resolution 100Hz Transmit/receiver Modulation Bandwidth 160MHz analog interface, 96 MHz Digital SISO Compatibility Works with Linux GnuRadio, MATLAB, Simulink Accessibility OSI layers for signal processing and development Wireless transmission and reception Over the air transmission reception through antenna Modulations supported Any, Custom Modulations possible Mode Full Duplex, TDD, FDD Maximum RF Output Power -10dBm at 1GHz Typical Maximum Receiver Sensitivity -120 dBm at 1GHz Typical TX/RX SMA Impedance 50 Ohm TX/RX Gain Control Range & Step >6 0dB & 1dB Typical Minimum Rx Noise Figure < 6dB at 1GHz Nominal IQ Amplitude Error 0.5dB/-70dBc Image Typical PLL Settling time <20us Typical ADC/DAC Resolution & SFDR 12 bits & >60dBc SFDR Typical Power USB Powered THETA Start/ Stop Angle & Resolution 0 to 360 degrees in 0.1 degree PHI Start/ Stop Angle 0 to 180 degrees in 0.1 degree Power 24 V Positioner Control Software control via USB Cable Loading Capacity 0.5 kg Shipping List Deliverable ATS04 Transceiver Unit, 3D Positioner, 20 Antennas and Accessories RF Cable RG316 SMA-SMA X 4 Frequency Band Upgradable Other 5G bands 3.8-12.4 GHz optional, 18-26GHz optional, 26-40GHz Optional Reference Antennas Planar Reference Horn 0.8GHz – 4 GHz X 2 Disclaimer: Images shown are Indicative only. Color or Model may differ from the picture shown (Features will remain same or More). Specifications are subject to change without notice. Mfd by: Amitec Electronics Ltd. Regd. Off: 504, Nilgiri, 9 Barakhamba Road, New Delhi-110001, India, Works: 4/32, Site-4, Industrial Estate Sahibabad, NCR-201010, India, [email protected], www.amitec.co +91-11-41505510, +91-120-4371276 ANTENNA TRAINING LAB ATS04 1. Microstrip Yagi 6. Endfire Phased array Fc : 3.8 + 0.1 GHz S11: >10dB S11 : 10 + 2dB Bandwidth: 3.6 + 0.1GHz Polarisation : Linear Gain: 3dBi Gain : 3dBi Beamwidth : E plane 600 Feed : Microstrip balun Beamwidth : H Plane 1200 Impedance : 50 Ohms Polarisation : Linear Connector : SMA Front to Back Ratio: 0dB Masking: Selective Connector : SMA Plating: Gold Masking: Selective Plating: Gold 2. Folded Dipole 7. Broadside phased array S11: >10dB S11: >10dB Bandwidth: 3.6 + 0.2GHz Bandwidth: 3.6 + 0.1GHz Gain: 2dBi Gain: 3dBi Beamwidth : E plane 700 Beamwidth : E plane 600 Beamwidth : H Plane 1800 Beamwidth : H Plane 1200 Polarisation : Linear Polarisation : Linear Front to Back Ratio: 0dB Front to Back Ratio: 0dB Connector : SMA Connector : SMA Masking: Selective Masking: Selective Plating: Gold Plating: Gold 3. Microstrip Dipole 8. Coplanar waveguide CPW Bow tie slot Antenna Fc : 3.6 + 0.1 GHz Fc : 3.6 + 0.1 GHz S11 : 10 + 2dB S11 : 10 + 2dB Polarisation : Linear Polarisation : Linear X Pol discrimination : 20dB Gain : 2dBi Gain : 2dBi Impedance : 50 Ohms Feed: Microstrip balun Connector : SMA Impedance : 50 Ohms Masking: Selective Connector : SMA Plating: Gold Masking: Selective Plating: Gold 4. Microstrip Slot 9.Wideband Bow tie Dipole Antenna Fc : 3.8 + 0.1 GHz Fc : 3.8 + 2 GHz S11: >10dB S11 : 10 + 2dB Gain: 2dBi Polarisation : Linear Beamwidth : E plane 600 Gain : 2dBi Beamwidth : H Plane 1800 Impedance : 50 Ohms Polarisation : Linear Connector : SMA Front to Back Ratio: 0dB Substrate: Glass Epoxy Connector : SMA Masking: Selective Masking: Selective Plating: Selective Gold Plating: Gold 5. Loop 10.Reference Logperiodic S11: >10dB S11: >10dB Bandwidth: 3.8 + 0.1GHz Bandwidth: 1 to 6GHz Gain: 2dBi Gain: 4dBi Beamwidth : E plane 700 Beamwidth : E plane 600 Beamwidth : H Plane 1800 Beamwidth : H Plane 1800 Polarisation : Linear Polarisation : Linear Front to Back Ratio: 0dB Front to Back Ratio: 10dB Connector : SMA Connector : SMA Masking: Selective Plating: Gold Disclaimer: Images shown are Indicative only. Color or Model may differ from the picture shown (Features will remain same or More). Specifications are subject to change without notice. Mfd by: Amitec Electronics Ltd. Regd. Off: 504, Nilgiri, 9 Barakhamba Road, New Delhi-110001, India, Works: 4/32, Site-4, Industrial Estate Sahibabad, NCR-201010, India, [email protected], www.amitec.co +91-11-41505510, +91-120-4371276 ANTENNA TRAINING LAB ATS04 11. Left Circularly Polarized Patch 16. Vivaldi (Planar Horn: Aperture Antenna) Fc : 3.8 + 0.1 GHz S11 : >6dB S11 : 10 + 2dB Bandwidth : 3 + 2 GHz Polarisation : LHCP Gain : 1dBi Gain : 3dBi Beamwidth : E plane 800 Impedance : 50 Ohms Beamwidth : H Plane 1800 Connector : SMA Polarisation : Linear Masking: Selective Front to Back Ratio : 0dB Plating: Gold Connector : SMA 12. Right Circularly Polarized Patch 8. Microstrip Circular Patch Array 2 X 2 Fc : 3.8 + 0.1 GHz Fc :2.4 + 0.1 GHz S11 : 10 + 2dB S11 : 10 + 2dB Polarisation : RHCP Polarisation : Circular Gain : 3dBi Gain : 7dBi Impedance : 50 Ohms Impedance : 50 Ohms Connector : SMA Connector : SMA Masking: Selective Plating: Gold 21. Spiral Slot 18. Patch Array 2X2 Fc : 3 + 1 GHz Fc : 2.4 + 0.1 GHz S11 : 10 + 2dB S11 : 10 + 2dB Polarisation : Linear Polarisation : Linear Gain : 2dBi Gain : 8dBi Impedance : 50 Ohms Impedance : 50 Ohms Connector : SMA Connector : SMA Masking: Selective Masking: Selective Plating: Gold Plating: Gold 22. Log Spiral 19. Dual Rectangular Patch Fc : 3 + 1 GHz Fc : 3.8 + 0.1 GHz S11: >10dB S11 : 10 + 2dB Gain: 2dBi Polarisation : Linear Beamwidth : E plane 800 Gain : 5dBi Beamwidth : H Plane 1200 Impedance : 50 Ohms Polarisation : Circular Connector : SMA Front to Back Ratio: 0dB Masking: Selective Connector : SMA Plating: Gold Masking: Selective Plating: Gold 15. Monopole 20. Series fed patch array S11: >10dB S11 : >6dB Bandwidth: 3.6 + 0.2GHz Bandwidth : 3.6 + 0.3GHz Gain: 1dBi Gain : 4dBi Beamwidth : E plane 700 Beamwidth : E plane 400 Beamwidth : H Plane 1800 Beamwidth : H Plane 400 Polarisation : Linear Polarisation : Linear Front to Back Ratio: 0dB Front to Back Ratio : >8dB Connector : SMA Connector : SMA Masking: Selective Plating: Gold Disclaimer: Images shown are Indicative only. Color or Model may differ from the picture shown (Features will remain same or More). Specifications are subject to change without notice. Mfd by: Amitec Electronics Ltd. Regd. Off: 504, Nilgiri, 9 Barakhamba Road, New Delhi-110001, India, Works: 4/32, Site-4, Industrial Estate Sahibabad, NCR-201010, India, [email protected], www.amitec.co +91-11-41505510, +91-120-4371276 ANTENNA TRAINING LAB ATS04 21. Directional Coupler 24. Coaxial Slotted Line & OSL Bandwidth: 1 - 6 GHz S11: >15dB, S12: <1.5dB Insertion S12 : 1.5 + 0.5 Resolution: 0.05mm/ dB Coupling S13 : 20 + 0.15degree at 1.5GHz 2dB Coupling factor:-20dB Isolation S14: 20 + 2dB Connector : SMA Directivity S23: 15 + 3dB Residual VSWR : <1.2 Impedance : 50 Ohms Velocity propagation : Connector : SMA 1.818X108m/s Usage: Antenna forward & Wavelength/3600 phase : reverse power & VSWR 121mm at 1.5GHz measurements. Total Length : 200mm 50Ohms,