ACQUISITION CARDS DATA PROTO-1 PC Bus Development Tool PROTO-1 provides a means of rapidly developing I/O mapped PC bus cards. It is ideal for prototyping I/O cards and other interfacing cards. The full length PC card includes the logic necessary to interface with the PC bus. A selectable base address can be set in the range 0-3FFF Hex and the board can occupy up to 32 ports from this base port. Both Data bus and Address bus are buffered and decoded D0-D7 and A0-A4 respectively. Control lines I/O Read/Write (IORD, IOWR) and Memory Read/Write (MRD, MWR) are also provided together with all voltage rails. An extensive patch are with 1.0mm holes is Technical Specification available to mount IC’s resistors and other components. Electrical Specification Number of Ports Used: 16 8-bit ISA bus prototyping card Power Requirement: 5V D.C. Power Dissipation: 150mW Up to 32 ports Physical Specification Selectable base port address Height: 107 mm Width: 11 mm Buffered data bus (D0-D7) Length: 335.5 mm Buffered address bus (A0-A4) Photocopying Area Control lines (IORD, IOWR, Component Points (2000): 1 mm MRD, MWR) Pads: 1.5 mm Full size card with large patch area Pitch: 2.54 mm Note: The total width of the card should not exceed 12.7 mm 3 YEAR WARRANTY BS EN ISO 9001 Certificate No 33069 Chowley Oak, Tattenhall, Chester, Cheshire, CH 9EX, UK Tel: +44 (0) 1829 772000 Facsimile: +44 (0) 1829 772001 E-mail: [email protected] Web: http://www.bluechiptechnology.co.uk All trademarks and registered trademarks are acknowledged as the property of their respective owners. Specifications are subject to change without notice. All information is believed to be accurate and reliable however Blue Chip Technology accept no liability whatsoever for any event or action resulting from its use..