Technical Data Sheet Aron Alpha Aerosol Accelerator Last Updated Sept. 11, 2008, Printed November 11, 2015 PRODUCT DESCRIPTION DIRECTIONS FOR USE ARON ALPHA Aerosol Accelerator (reorder # AA-705) provides the following product characteristics: Surface Activation: 1. Apply one coating of Aerosol Accelerator to the area to Technology Cyanoacrylate Activator be bonded by aerosol spray. Contaminated surfaces Chemical Type Amine (active ingredient) may need special cleaning or degreasing prior to Solvent Acetone activation to remove any soluble contamination Active Ingredient 2 2. Allow the solvent time to flash off until the surfaces are Concentration, % completely dry (approximately 30 seconds) Appearance Transparent colorless liquid 3. Apply the ARON ALPHA cyanoacrylate product Viscosity Very low (water-like) immediately after drying or not more than 45 seconds Cure N/A thereafter. Application CA adhesive cure accelerator 4. Setter can be re-applied if necessary if there is a delay of more than 45 seconds between original Setter and ARON ALPHA Aerosol Accelerator is used where increased cure adhesive application. speed of ARON ALPHA cyanoacrylate (instant) adhesives is required. It can be either pre- or post-applied to the bond. The Post Activation: product is especially suited for post-application on cyanoacrylate 1. Apply ARON ALPHA cyanoacrylate to the parts to be adhesive to ensure rapid fixturing. bonded or fixed. Typical applications include securing wires or coils to PC Boards, 2. Apply Setter over all exposed cyanoacrylate adhesive by tamper-proofing adjustable components, mounting stand-offs, edge aerosol spray. Typically use one puff of activator per guides and board stiffeners. drop of exposed adhesive. TYPICAL PROPERTIES TOAGOSEI MATERIAL SPECIFICATION Specific Gravity: 0.79 Aerosol Accelerator performance data is available for each batch. Viscosity, cps < 1 Toagosei test reports include selected QC test parameters Drying (evaporation) time, seconds ≤ 30 considered appropriate to specifications for customer use. On Part Life, minutes ≤ 1 Flash Point – See MSDS STORAGE TYPICAL PERFORMANCE This Setter is classified as HIGHLY FLAMMABLE and must be stored in an appropriate manner in compliance with relevant Fixture time and cure speed achieved as a result of using ARON regulations. Do not store near oxidizing agents or combustible ALPHA Aerosol Accelerator depends on the cyanoacrylate materials. The product is light sensitive and accordingly, adhesive used and the substrate bonded. translucent containers should be kept in a dark place when not in use. Store product in the unopened container in a dry location. HANDLING PRECAUTIONS Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater Aerosol Accelerator must be handled in a manner applicable to than 28 °C can adversely affect product properties. Material highly flammable and volatile materials and in compliance with removed from containers may be contaminated during use. Do relevant local regulations. not return product to the original container. Toagosei cannot assume responsibility for product which has been contaminated or The solvent can affect certain plastics and coatings. Plastics stored under conditions other than those previously indicated. If such as ABS, Polycarbonate, Polystyrene and Acrylic may additional information is required, please contact your local degenerate when brought in contact with Aerosol Accelerator. Technical Service Center or Customer Service Representative. The affected surface area may get cloudy or sticky. It is recommended to check all surfaces for compatibility before use. Toagosei America Inc. and KRAZY GLUE CO. Div. of Toagosei America Inc. 1450 West Main St. West Jefferson, OH 43162 Tel: (800)338-5192, Fax:(614)879-6959 .