DoorKing Part Number 1603-210is s 2” Conduit Nut (3) 3/4” Conduit Nipple and Conduit Nut Hardware: 2” Threaded Elbow 5/8” Cover Bracket bolt and lockwasher (2 sets) U-Bolt Clamp with lockwashers and nuts TRAFFIC LIGHT AND MOUNTING KIT (2 sets) This kit is designed forKit the Includes: 1600 model barrier gate operators. Recommended for the 1603 auto spike system. The traffic signal synchronized with thePlastic gate operator’sTraffic Light up/down Assembly cycle. (Factory The red wired) light stays on and only changes to green when the operator’s arm i Support Post Assembly fully raised. 2” Threaded Support Post Support Post Bracket Bracket Cover. 2 lt U-Bo Installation Clamp Shut off AC power to operator. Turn off DC power switch on certain models. Assemble Support Post Mount Support Post Assembly to OperatorSupport t Post 1 Traffic Light Use existing Bracket U-Bolt Assembly Clamp Bracket circuit board Cover to moun bracket bolts bracket. support post Route wire through conduit. Moving Gate Can Cause Serious Injury or Death Use 2” conduit KEEP CLEAR! Gate may move at any time without prior warning. Do not let children operate the gate or play in the gate area. nuts to secure This entrance is for vehicles only. Pedestrians must use separate entrance. traffic light Drill 7/8” hole assembly to centered where support post. elbow touches U.S.A. operator housing (Approximately 18” down from the top of operator). 120 S. Glasgow Avenue Support Post Secure 3/4” conduit nipple in drilled hole with Inglewood, California 90301 conduit nut . Route wire through support post. 2” conduit nut to secure elbow. 2” Elbow Wire Traffic Light to Operator DoorKing Part Number 3 1603-210 Note: This light has been designed to wire to operators that use 115 volt power and a FORM C dry relay contact that activates when the operator is fully open. Traffic Light Terminal White 115V Neutral Red Relay Com Black 115V Hot Brown Relay N.O. Green Ground Circuit Board Bracket Bolt TIME DELAY UP LOOP ON 1 2 3 4 5 6 7 8 SW 1 ON 1 2 3 POWER 4 5 6 7 8 SW 2 Circuit Board Bracket Circuit REVERSE SENSITIVITY DOWN LOOP Red Wire (Com) C NC NO Brown Wire (N.O.) NC NO Note: To reverse light sequence 1234567891011121314 Chassis Ground change to N.C. DANGER ON ON UP Circuit Board Bracket Bolt HIGH VOLTAGE! AUTO NEU HOT OFF OFF DOWN (Ground) Green Wire 115 VAC AC POWER DC POWER (Neutral) White Wire (Hot) Black Wire 3/4” Conduit nipple installed in operator housing. Keep wire clear of all moving parts. See installation on previous page 120 S. Glasgow Avenue 1603-265-C-8-16 Copyright 2016 DoorKing, Inc. All rights reserved. Inglewood, California 90301 U.S.A..