Instruction book IMPORTANT SAFETY INSTRUCTIONS This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. When using an electrical appliance, basic safety precautions should always be followed, including the following: This sewing machine is designed and manufactured for household use only. Read all instructions before using this sewing machine. DANGER— To reduce the risk of electric shock: 1. An appliance should never be left unattended when plugged in. Always unplug this sewing machine from the electric outlet immediately after using and before cleaning. 2. Always unplug before replacing a sewing machine bulb. Replace bulb with same type rated 15 Watts. WARNING— To reduce the risk of burns, fire, electric shock, or injury to persons: 1. Do not allow to be used as a toy. Close attention is necessary when this sewing machine is used by or near children. 2. Use this appliance only for its intended use as described in this owner’s manual. Use only attachments recommended by the manufacturer as contained in this owner’s manual. 3. Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return this sewing machine to the nearest authorized dealer or service center for examination, repair, electrical or mechanical adjustment. 4. Never operate the appliance with any air opening blocked. Keep ventilation openings of this sewing machine and foot controller free from accumulation of lint, dust and loose cloth. 5. Never drop or insert any object into any opening. 6. Do not use outdoors. 7. Do not operate where aerosol (spray) products are being used or where oxygen is being administered. 8. To disconnect, turn all controls to the off (“O”) position, then remove plug from outlet. 9. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord. 10. Keep fingers away from all moving parts. Special care is required around the sewing machine needle. 11. Always use the proper needle plate. The wrong plate can cause the needle to break. 12. Do not use bent needles. 13. Do not pull or push fabric while stitching. It may deflect the needle causing it to break. 14. Switch this sewing machine off (“O”) when making any adjustment in the needle area, such as threading the needle, changing the needle, threading the bobbin or changing the presser foot, and the like. 15. Always unplug this sewing machine from the electrical outlet when removing covers, lubricating, or when making any other adjustments mentioned in this owner’s manual. SAVE THESE INSTRUCTIONS Please note that on disposal, this product must be safely recycled in accordance with relevant National legislation relating to electrical/electronic products. If in doubt please contact your retailer for guidance. (European Union only) TABLE OF CONTENTS SECTION 1. NAMES OF PARTS SECTION 4. DECORATIVE STITCHES Names of Parts ...........................................2 Shell Tuck ..................................................25 Extension Table ...........................................3 Smocking ..................................................26 Standard Accessories ................................. 3 Applique ....................................................27 Carrying Handle ..........................................3 Box Stitch (3 dial model only) ....................27 Decorative Stitch Patterns .........................28 SECTION 2. GETTING READY TO SEW Stretch Stitch Patterns ..............................28 Connecting Machine to Power Supply ........4 Before Using Your Sewing Machine ............4 SECTION 5. CARE OF YOUR MACHINE For Your Safety ............................................4 Cleaning the Bobbin Case and the Shuttle Controlling Sewing Speed ...........................4 Race ........................................................29 Setting Spool Pins .......................................5 Cleaning the Feed Dog .............................29 Presser Foot Lifter .......................................5 Sewing Light ..............................................30 Changing Presser Foot ...............................5 Troubleshooting .........................................31 Changing Needles.......................................6 To Check the Needle ...................................6 Thread and Needle Chart ...........................6 Bobbin Winding ....................................... 7-8 Threading the Machine ......................... 9-10 Balancing Needle Thread Tension.............11 Stitch Pattern Selector ..............................12 Stitch Chart Panel .....................................12 Stitch Length Dial ......................................12 Adjusting Stretch Stitch .............................13 Stitch Width Dial (3 dial model only) Reverse Stitch Button................................13 Darning Plate ............................................13 SECTION 3. BASIC SEWING Straight Stitch ............................................14 To Change Sewing Direction .....................14 Variable Needle Position (3 dial model only) .........................................................15 Seam Guide Lines.....................................15 Tur ning a Square Corner...........................15 Basic Zigzag..............................................16 Tr icot Stitch................................................16 Straight Stretch Stitch ...............................17 Zigzag Stretch Stitch .................................17 Knit Stitch ..................................................18 Button Sewing ...........................................18 Buttonhole .................................................19 Corded Buttonhole ....................................20 Zipper Application .....................................21 Pin Tucking ................................................22 Free Hand Mending and Embroidery ........23 Blind Hem Stitch........................................24 1 u y SECTION 1. NAMES OF PARTS i o Names of Parts !0 t !1 q Stitch pattern selector dial !2 e w Stitch length dial e Stitch width dial (3 dial model only) r Reverse stitch control !3 t Bobbin winder stopper r y Bobbin winder spindle u Spool pins !4 w i Stitch chart panel q o Bobbin winding tension disc !5 !0 Thread guide !6 !1 Thread take-up lever !2 Thread tension dial !7 !3 Face cover !4 Needle plate !5 @1 Extension table (Accessory box) !8 !6 Carrying handle !7 Handwheel !8 Power switch @0 !9 Machine socket @0 Free-arm !9 @1 Presser foot lifter @3 @2 Needle @4 @3 Needle clamp screw @2 @4 Presser foot holder @5 @5 Setscrew @6 Presser foot @6 @7 Foot control @7 2 Extension Table • Detaching the table Pull the table away from the machine, as illustrated, for “free-arm” sewing of cuffs and sleeves. The extension table can be used as accessory box. • Attaching the table Push the extension table until it snaps into the machine. qw Standard Accessories q Bobbins w Needle set e Zipper foot r Blind hem stitch foot er t Sliding buttonhole foot y Buttonhole opener / Seam ripper u Screwdriver (small) t y i Darning plate u i Carrying Handle Press down the marks on the carrying handle to raise the carrying handle. q Carrying handle q 3 SECTION 2. GETTING READY TO SEW t Connecting Machine to Power q e r Supply CAUTION: Before connecting the power cord, make sure the voltage and frequency shown on the machine conform to your electrical power. 1. Turn off the power switch q. w 2. Insert the machine plug w into the machine socket e. 3. Insert the power supply plug r into the outlet t. 4. Turn on the power switch q to activate the power and sewing light. q Power switch w Machine plug e Machine socket r Power supply plug t Outlet Before Using Your Sewing Machine Before using your sewing machine for the first time, place a waste fabric under the presser foot and run the machine with thread for a few minutes. Wipe away any oil which may appear. For Your Safety * While in operation, always keep your eyes on the sewing area. Do not touch any moving parts, such as the thread take-up lever, handwheel or needle. * Always turn off the power switch and unplug from the power supply: - When leaving the machine unattended - When attaching or removing any parts - When cleaning the machine * Do not place anything on the foot control, when not sewing. Controlling Sewing Speed Sewing speed can be varied by the foot control. The harder you press on the foot control, the faster the machine runs. 4 Setting Spool Pins The spool pins are used for holding the spools of thread when feeding the thread to the machine. To use, pull up the spool pins. Push down for storage. q Upper thread w Hole e Tangle NOTE: q w When using thread which has tendency to tangle around a spool pin e, thread q through the hole w of spool pin as shown. The hole should face the thread spool. e Presser Foot Lifter The presser foot lifter raises and lowers the presser foot. You can raise it about 1/4˝ (0.6 cm) higher e than the normal up position to help place heavy fabric under the foot. ew q Presser foot lifter w Normal up position w e Highest position q Changing Presser Foot q Presser foot w Groove e Pin CAUTION: When attaching or removing presser foot, turn OFF the power switch. q •To