LINCOLN Mark VIII 1993-95 FORD Crown Victoria / LTD 1979-90 MERCURY Grand Marquis / Marquis 1979-90 1 2 1 2 "D" Fig. B Fig. A "F" "D" "F" Disconnect the negative battery terminal to Locate the Snap-in Bracket and Rounded prevent an accidental short circuit. Using Faceplate (see Fig. A) OR the Snap-in Metra's 86-5618, pull the factory head unit Bracket and Cornered Faceplate (see Fig. Disconnect the negative battery terminal to Cut and remove all mounting tabs on the from the dash and disconnect the wiring. B). Skip to the Installation Instructions for prevent an accidental short circuit. Open Radio Housing EXCEPT tabs "D" and "F". ALL VEHICLES on Page #21. the ashtray and remove (2) Phillips screws The mounting tabs can be identified by the securing the dash trim bezel. Remove (4) stamped letter on the back of each tab. screws securing the factory head unit and Locate Spacer Set #2. (The Spacers must disconnect the wiring. be placed behind the mounting tabs during installation in step #5). Skip to the Installation Instructions for ALL VEHICLES LINCOLN Town Car 1984-89 on Page #22. 1 2 FORD Crown Victoria 1991-94 MERCURY Grand Marquis 1991-94 "D" "F" 1 2 "D" Fig. B Fig. A "F" Disconnect the negative battery terminal to Cut and remove all mounting tabs on the prevent an accidental short circuit. Remove Radio Housing EXCEPT tabs "D" and "F". (3) #8 Phillips screws from the bottom of the The mounting tabs can be identified by the radio trim bezel. Unsnap the plastic strip stamped letter on the back of each tab. located above the bezel and remove (3) Locate Spacer Set #2. (The Spacers must Phillips screws exposed. Gently pull the be placed behind the mounting tabs during Disconnect the negative battery terminal to Locate the Snap-in Bracket and Rounded instrument cluster trim bezel away from the installation in step #5). Skip to the prevent an accidental short circuit. Using Faceplate (see Fig. A) OR the Snap-in dash and remove the radio trim bezel. Installation Instructions for ALL VEHICLES Metra's 86-5618, pull the factory head unit Bracket and Cornered Faceplate (see Fig. Remove (3) hex-head screws securing the on Page #22. from the dash and disconnect the wiring. B). Skip to the Installation Instructions for factory head unit and disconnect the wiring. ALL VEHICLES on Page #21. 16 5 FORD Econoline 1992-96 LINCOLN Continental 1985-87 1 2 1 2 "D" Fig. B "F" Fig. A "D" "F" Disconnect the negative battery terminal to Locate the Snap-in Bracket and Rounded Disconnect the negative battery terminal to Cut and remove all mounting tabs on the prevent an accidental short circuit. Remove Faceplate (see Fig. A) OR the Snap-in prevent an accidental short circuit. Remove Radio Housing EXCEPT tabs "D" and "F". the light switch knob and unscrew the Bracket and Cornered Faceplate (see Fig. (2) #8 Phillips screws below the radio The mounting tabs can be identified by the surrounding trim. Remove the cupholder B). Skip to the Installation Instructions for opening. Open the ashtray and remove (2) stamped letter on the back of each tab. and the screws exposed in the cupholder ALL VEHICLES on Page #21. #8 Phillips screws exposed (it is NOT Locate Spacer Set #2. (The Spacers must cavity. Unsnap the (2) trim bezel inserts and necessary to remove the center screw). be placed behind the mounting tabs during remove the screws exposed. Remove the Unclip and remove the dash trim bezel. installation in step #5). Skip to the lower steering column trim panel and unclip Remove (4) hex-head screws securing the Installation Instructions for ALL VEHICLES the dash trim bezel. Using Metra's 86-5618, factory head unit and disconnect the wiring. on Page #22. pull the factory head unit from the dash and disconnect the wiring. LINCOLN Mark VII 1984-89 FORD Escort / MERCURY Tracer 1991-96 1 2 1 2 "D" "F" Fig. B Fig. A "D" "F" Disconnect the negative battery terminal to Cut and remove all mounting tabs on the prevent an accidental short circuit. Gently Radio Housing EXCEPT tabs "D" and "F". pry out on the dash trim bezel and remove. The mounting tabs can be identified by the Disconnect the negative battery terminal to Locate the Snap-in Bracket and Rounded Remove (4) 5mm hex-head sheet metal stamped letter on the back of each tab. prevent an accidental short circuit. Using Faceplate (see Fig. A) OR the Snap-in screws securing the factory head unit and Locate Spacer Set #2. (The Spacers must Metra's 86-5618, pull the factory head unit Bracket and Cornered Faceplate (see Fig. disconnect the wiring. be placed behind the mounting tabs during from the dash and disconnect the wiring. B). Skip to the Installation Instructions for installation in step #5). Skip to the ALL VEHICLES on Page #21. Installation Instructions for ALL VEHICLES on Page #22. 6 15 JEEP Wrangler 1986-96 FORD Escort / MERCURY Lynx 1985-90 1 2 1 2 "B" "B" "B" "B" Disconnect the negative battery terminal to Cut and remove all mounting tabs on the Disconnect the negative battery terminal to Cut and remove all mounting tabs on the prevent an accidental short circuit. Remove Radio Housing EXCEPT tabs "B". The prevent an accidental short circuit. Remove Radio Housing EXCEPT tabs "B". The (6) Phillips screws from the face of the dash mounting tabs can be identified by the (4) screws from the top edge of the dash trim mounting tabs can be identified by the trim bezel. Remove the bezel. Remove (2) stamped letter on the back of each tab. bezel. Remove (2) screws from the bottom stamped letter on the back of each tab. screws securing the factory head unit and Mount Bracket Set #1 to the back of the edge of the dash trim bezel. Remove the Mount Bracket #2 to the bottom of the disconnect the wiring. mounting tabs with (2) #8 x 1" Phillips climate control knobs and remove the bezel. Housing with (2) #8 x 1" Phillips Screws screws supplied. Skip to the Installation Remove (4) hex-head screws securing the supplied. Skip to the Installation Instructions for ALL VEHICLES on Page factory head unit and disconnect the wiring. Instructions for ALL VEHICLES on Page #22. #22. LINCOLN Continental 1988-94 / Mark VII 1990-92 Town Car 1990-94 FORD F-Series Pickup / Bronco 1992-96 1 2 1 2 Fig. B Fig. B Fig. A Fig. A Disconnect the negative battery terminal to Locate the Snap-in Bracket and Rounded Disconnect the negative battery terminal to Locate the Snap-in Bracket and Rounded prevent an accidental short circuit. Using Faceplate (see Fig. A) OR the Snap-in prevent an accidental short circuit. Using Faceplate (see Fig. A) OR the Snap-in Metra's 86-5618, pull the factory head unit Bracket and Cornered Faceplate (see Fig. Metra's 86-5618, pull the factory head unit Bracket and Cornered Faceplate (see Fig. from the dash and disconnect the wiring. B). Skip to the Installation Instructions for from the dash and disconnect the wiring. B). Skip to the Installation Instructions for ALL VEHICLES on Page #21. ALL VEHICLES on Page #21. 14 7 FORD Festiva 1988-93 JEEP Cherokee 1996 1 2 1 2 "E" "E" "E" "E" Disconnect the negative battery terminal to Cut and remove all mounting tabs on the Disconnect the negative battery terminal to Cut and remove all mounting tabs on the prevent an accidental short circuit. Remove Radio Housing EXCEPT tabs "E". The prevent an accidental short circuit. Remove Radio Housing EXCEPT tabs "E". The (4) Phillips screws from the bottom of the mounting tabs can be identified by the (3) torx-head screws from the steering mounting tabs can be identified by the dash trim bezel. Remove the bezel. stamped letter on the back of each tab. column trim panels. Unscrew the tilt stamped letter on the back of each tab. Skip Remove (2) screws securing the factory Locate Spacer Set #1. (The Spacers must steering lever and unsnap the trim panels. to the Installation Instructions for ALL head unit and disconnect the wiring. be placed behind the mounting tabs during Remove (4) screws from the dash trim bezel VEHICLES on Page #22. installation in step #5). Skip to the and remove the bezel. Remove (2) screws Installation Instructions for ALL VEHICLES securing the factory head unit and on Page #22. disconnect the wiring. JEEP Grand Wagoneer 1987-95 FORD Mustang 1994-00 1 2 1 2 "E" "E" Disconnect the negative battery terminal to Cut and remove all mounting tabs on the prevent an accidental short circuit. Gently Radio Housing EXCEPT tabs "E". The Disconnect the negative battery terminal to Locate the Snap-in Bracket and Rounded unclip the dash trim bezel. Remove (2) mounting tabs can be identified by the prevent an accidental short circuit. Using Faceplate. Skip to the Installation screws securing the factory head unit and stamped letter on the back of each tab. Skip Metra's 86-5618, pull the factory head unit Instructions for ALL VEHICLES on Page disconnect the wiring. to the Installation Instructions for ALL from the dash and disconnect the wiring. #21. VEHICLES on Page #22. 8 13 FORD Windstar 1995-98 FORD Probe 1993-97 1 2 1 2 Disconnect the negative battery terminal to Locate the Snap-in Bracket and Rounded Disconnect the negative battery terminal to Locate the Snap-in Bracket and Rounded prevent an accidental short circuit.