Building Technologies & Solutions Training Facility Corropoli (TE) - Italy Road Map General Welcome to the Tyco Security Products EMEA Training Centre in Corropoli. This document contains important information and advice for those attending a training course with us. The training centre has a modern, well-equipped and air-conditioned room. This allows training for 8 delegates, depending on the course. Two delegates share one workstation with the necessary training equipment All delivered training courses in Corropoli are part of the training schedule. You can view this schedule on our web page, or ask your responsible contact person: https://training.tycosecurityproducts.com/ All training enrolments and associated enquiries can be emailed to [email protected] Deadline for enrolment is 14 days before the course commences, Should you need to cancel a course please send us an email immediately. Please note that each course is chargeable and a no show carries a full course fee penalty. Address: We are based on our Bentel office at the following address: Bentel Security Products Zona Industriale Santa Scolastica Via Gabbiano 22 64013 Corropoli Teramo Italia Phone: +39.340.6517223 (contact, Massimo Lamonaca) Time: Unless otherwise stated; all courses start as 09:30am and finish at 06:00pm. Please ensure that your travel arrangement accommodate arrival and departure so that you do not miss out on any training intervention time. Page 2 Road Map Corropoli is a small village on the Adriatic cost, around 20 KM at south of San Benedetto del Tronto. There are not big airports really close: the closer, international, is Roma Leonardo Da Vinci. Or you can fly to Ancona, Pescara or Milano. Then you would need to rent a car. Tyco Page 3 Road Map – from Milano Malpensa (around 600 Km) 1. Leave the airport and take the highway A7, Milano’s direction 2. Cross Milano’s ring (south direction) and take the l’A1, Bologna’s direction 3. At Bologna, follow the A14, Ancona’s direction 4. Keep following Ancona and once passed it, follow Pescara (same highway). 5. Take the exit Val Vibrata. At the round-about take the right and follow Corropoli 6. At the end of the road with trees on the sides, take the right and go up to the Zona Industriale 7. After 300 meters, Tyco is on your left hand side. Page 4 Road Map – from Roma Fiumicino (around 250 Km) 1. Leave the airport and take the ring, east Roma direction (A24) 2. At Roma, take the highway A24, l’Aquila direction 3. After l’Aquila, keep following the A24, Teramo/Giulianova’s direction 4. Follow Ancona. 8. Take the exit Val Vibrata. At the round-about take the right and follow Corropoli 9. At the end of the road with trees on the sides, take the right and go up to the Zona Industriale 5. After 300 meters, Tyco is on your left hand side. Page 5 Road Map – from Ancona (around 110 Km) 1. Take the A14, Pescara’s direction. 10. Take the exit Val Vibrata. At the round-about take the right and follow Corropoli 11. At the end of the road with trees on the sides, take the right and go up to the Zona Industriale 2. After 300 meters, Tyco is on your left hand side Page 6 Road Map – from Pescara (around 60 Km) 1. Take the highway A14, Ancona’s direction. 12. Take the exit Val Vibrata. At the round-about take the right and follow Corropoli 13. At the end of the road with trees on the sides, take the right and go up to the Zona Industriale 2. After 300 meters, Tyco is on your left hand side Page 7 Accommodation Recommendation We do NOT make any bookings or hotel reservations. However, here are some hotel recommendations near the training centre. Hotel Baffo Rosso Address: Via Amerigo Vespucci 1 – 64013 Corropoli (TE) Phone: (+39) 0861 83222 http://www.bafforosso.it Hotel Casa Rossa Address: Via Ascolana 58 – 64011 Alba Adriatica (TE) Phone: (+39) 0861 711899 http://www.hotelristorantecasarossa.it Page 8 In front of the edge of the sea there are many others hotel, at less than 20 minutes driving from our office. Page 9 .