DV58AV_KU_EN.book 1 ページ ２００７年８月３０日 木曜日 午後３時２０分 Operating Instructions DVD Player DV58AV_KU_EN.book 2 ページ ２００７年８月３０日 木曜日 午後１時６分 Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. IMPORTANT CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead, within CAUTION: The exclamation point within an equilateral an equilateral triangle, is intended to alert TO PREVENT THE RISK OF ELECTRIC triangle is intended to alert the user to the the user to the presence of uninsulated SHOCK, DO NOT REMOVE COVER (OR presence of important operating and "dangerous voltage" within the product's BACK). NO USER-SERVICEABLE PARTS maintenance (servicing) instructions in the enclosure that may be of sufficient INSIDE. REFER SERVICING TO QUALIFIED literature accompanying the appliance. magnitude to constitute a risk of electric SERVICE PERSONNEL. shock to persons. D1-4-2-3_En IMPORTANT NOTICE – THE SERIAL NUMBER FOR THIS EQUIPMENT IS LOCATED IN THE REAR. PLEASE WRITE THIS SERIAL NUMBER ON YOUR ENCLOSED WARRANTY CARD AND KEEP IN A SECURE AREA. THIS IS FOR YOUR SECURITY. D1-4-2-6-1_En NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Consult the dealer or an experienced radio/TV technician for help. D8-10-1-2_En CAUTION : USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. CAUTION : THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT WILL INCREASE EYE HAZARD. D6-8-2-1_En Information to User Alteration or modifications carried out without appropriate authorization may invalidate the user’s right to operate the equipment. D8-10-2_En WARNING – TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. D1-4-2-1_En WARNING: Handling the cord on this product or cords associated with accessories sold with the product will expose you to lead, a chemical known to the State of California and other governmental entities to cause cancer and birth defects or other reproductive harm. Wash hands after handling D36-P4_En This product contains mercury. Disposal of this material may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronics Industries Alliance : www.eiae.org. K057_En 2 En DV58AV_KU_EN.book 3 ページ ２００７年８月３０日 木曜日 午後１時６分 READ INSTRUCTIONS — All the safety and GROUNDING OR POLARIZATION OBJECT AND LIQUID ENTRY — Never push operating instructions should be read before the • If this product is equipped with a polarized objects of any kind into this product through product is operated. alternating current line plug (a plug having one openings as they may touch dangerous voltage RETAIN INSTRUCTIONS — The safety and blade wider than the other), it will fit into the points or short-out parts that could result in a operating instructions should be retained for outlet only one way. This is a safety feature. If fire or electric shock. Never spill liquid of any future reference. you are unable to insert the plug fully into the kind on the product. HEED WARNINGS — All warnings on the product outlet, try reversing the plug. If the plug should SERVICING — Do not attempt to service this and in the operating instructions should be still fail to fit, contact your electrician to replace product yourself as opening or removing covers adhered to. your obsolete outlet. Do not defeat the safety may expose you to dangerous voltage or other FOLLOW INSTRUCTIONS — All operating and use purpose of the polarized plug. hazards. Refer all servicing to qualified service instructions should be followed. • If this product is equipped with a three-wire personnel. CLEANING — The product should be cleaned only grounding type plug, a plug having a third DAMAGE REQUIRING SERVICE — Unplug this with a polishing cloth or a soft dry cloth. Never (grounding) pin, it will only fit into a grounding product from the wall outlet and refer servicing clean with furniture wax, benzine, insecticides type power outlet. This is a safety feature. If you to qualified service personnel under the or other volatile liquids since they may corrode are unable to insert the plug into the outlet, following conditions: the cabinet. contact your electrician to replace your obsolete • When the power-supply cord or plug is ATTACHMENTS — Do not use attachments not outlet. Do not defeat the safety purpose of the damaged. recommended by the product manufacturer as grounding type plug. • If liquid has been spilled, or objects have fallen they may cause hazards. POWER-CORD PROTECTION — Power-supply into the product. WATER AND MOISTURE — Do not use this cords should be routed so that they are not likely • If the product has been exposed to rain or water. product near water — for example, near a to be walked on or pinched by items placed • If the product does not operate normally by bathtub, wash bowl, kitchen sink, or laundry upon or against them, paying particular following the operating instructions. Adjust only tub; in a wet basement; or near a swimming attention to cords at plugs, convenience those controls that are covered by the operating pool; and the like. receptacles, and the point where they exit from instructions as an improper adjustment of other ACCESSORIES — Do not place this product on an the product. controls may result in damage and will often unstable cart, stand, tripod, bracket, or table. OUTDOOR ANTENNA GROUNDING — If an require extensive work by a qualified technician The product may fall, causing serious injury to a outside antenna or cable system is connected to to restore the product to its normal operation. child or adult, and serious damage to the the product, be sure the antenna or cable • If the product has been dropped or damaged in product. Use only with a cart, stand, tripod, system is grounded so as to provide some any way. bracket, or table recommended by the protection against voltage surges and built-up • When the product exhibits a distinct change in manufacturer, or sold with the product. Any static charges. Article 810 of the National performance — this indicates a need for service. mounting of the product should follow the Electrical Code, ANSI/NFPA 70, provides REPLACEMENT PARTS — When replacement parts manufacturer’s instructions, and should use a information with regard to proper grounding of are required, be sure the service technician has mounting accessory recommended by the the mast and supporting structure, grounding of used replacement parts specified by the manufacturer. the lead-in wire to an antenna discharge unit, manufacturer or have the same characteristics CART — A product and cart combination should be size of grounding conductors, location of as the original part. Unauthorized substitutions moved with care. Quick stops, excessive force, antenna-discharge unit, connection to may result in fire, electric shock, or other and uneven surfaces may cause the product grounding electrodes, and requirements for the hazards. and cart combination to overturn. grounding electrode. See Figure A. SAFETY CHECK — Upon completion of any service LIGHTNING — For added protection for this or repairs to this product, ask the service product during a lightning storm, or when it is technician to perform safety checks to left unattended and unused for long periods of determine that the product is in proper time, unplug it from the wall outlet and operating condition. disconnect the antenna or cable system. This WALL OR CEILING MOUNTING — The product will prevent damage to the product due to should not be mounted to a wall or ceiling. lightning and power-line surges. HEAT — The product should be situated away from POWER LINES — An outside antenna system heat sources such as radiators, heat registers, should not be located in the vicinity of overhead stoves, or other products (including amplifiers) power lines or other electric light or power that produce heat. circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken VENTILATION — Slots and openings in the cabinet to keep from touching such power lines or are provided for ventilation and to ensure circuits as contact with them might be fatal. reliable operation of the product and to protect OVERLOADING — Do not overload wall outlets, it from overheating, and these openings must extension cords, or integral convenience not be blocked or covered. The openings should receptacles as this can result in a risk of fire or never be blocked by placing the product on a electric shock. ANTENNA bed, sofa, rug, or other similar surface. This LEAD IN product should not be placed in a built-in WIRE installation such as a bookcase or rack unless proper ventilation is provided or the GROUND manufacturer’s instructions have been adhered CLAMP to.