Channels as of April 2020 1 5 9 13 17 2 6 10 14 18 3 7 11 15 19 4 8 12 16 20 21 35 49 63 77 22 36 50 64 78 23 37 51 65 79 24 38 52 66 80 25 39 53 67 81 26 40 54 68 82 27 41 55 69 83 28 42 56 70 84 29 43 57 71 85 30 44 58 72 86 31 45 59 73 87 32 46 60 74 88 33 47 61 75 89 34 48 62 76 QUICK OPERATION TIPS ATTENTION: This TV has been preloaded with all your favourite Freeview/Sky channels and satellite information by RSE. It has then been fully tested. Please ensure you do not scan channels or factory default. If you are receiving no signal please check dish alignment or LNB setting or position. This TV has a built in low voltage warning. Should the voltage input drop below 11.8A the TV speakers will turn off. Should this occur please have the voltage tested. To bring up the channel list press ENTER and scroll through using “page up” or “page down” then the up and down arrow buttons to select required channel. DISPLAY BUTTON Press once for Channel and Time Press twice for Current program and Next program Press three times for Program Synopsis EPG BUTTON Electronic Programming Guide for both Freeview and Sky including program synopsis. DVD OPERATION To operate the DVD function both loading and ejecting on this TV you must be on DVD mode. Press the INPUT button and use the arrows to scroll down to DVD and press ENTER You are now on DVD mode, please wait for the loading screen to fully load and the disc option to appear in the top left hand corner of the screen. From here you can insert, play, eject and operate the DVD via the remote. Please note attempting to load a DVD when it is not in the DVD mode can cause damage to the disc and the DVD loader and will not be covered under warranty. FM TRANSMITTER OPERATION Press the FM/SW button on the remote to turn the function on. The words FM Off will appear on the TV screen. Press the FM/SW button a second time to select an FM transmission frequency i.e. 88.0 if you continue to press the FM/SW button you can select up to 7 frequencies. Once you have selected a frequency then you can tune camper radio to the same frequency and the TV audio sound will play through the stereo speakers. The stereo volume will then control the sound. Once you have gone past the final frequency selection (89.2) the FM function will automatically turn off. If you turn the TV off and back on again the FM function will default back to the TV speakers. FM HEADPHONE OPERATION Set FM to 88 MHZ as per instructions above. Turn headphone on and use volume control on headphones to listen to TV audio. Note: The headphones contain a built in FM Radio if you press the scan button and receive a radio station press the reset button and turn the headphones off then on again to return to TV audio. SIGNAL BARS To show the signal bars on the screen when aligning a manual satellite dish press the MENU button then key in 0000 to access a hidden menu. Highlight “Satellite Finder” and press ENTER, a bar graph will stay on the screen along with satellite reception information. Please note it is the signal quality that is the important information required. Press EXIT to remove from screen. Freephone: 0800 639 822 www.rse.co.nz .