Installing Our Rudder Hardware

Installing Our Rudder Hardware

Duck Trap Woodworking P.O. Box 88 Lincolnville Beach, Maine 04849 Installing our Rudder Hardware We designed this rudder hardware for use on our own boats, because frankly, we were less than pleased with what was generally available. Pintles have a nasty habit of coming unhinged– unhandy in the best of circumstances and dangerous in the worst. To remedy that hazard we dispensed with pintles entirely. Instead, our rudder gudgeons (that fi t on the rudder) and the transom and sternpost gudgeons (that fasten to the boat) are connected with a 5/16” bronze rod that acts as a hinge pin. Better yet, with this arrangement, should your rudder strike bottom, it can slide up the rod without becoming unhinnged, and drop right back down into place. Is it foolproof? No, nothing is, but it’s an arrangement that we have never seen fail. The trick is to make certain that the rudder slides freely up and down the rod. If it doesn’t, a little attention with a fi ne toothed round fi le can be used to open up the holes in the rudder gudgeons. The bend in the top of the rod is so that it doesn’t drop through, and makes a good handle as well. The lower end of the rod has a rounded point. Installations vary, but generally, the rod wants to extend 5- 6” below the lowest fi tting. Photo: Installation on a Duck Trap Wherry (before the rudder cheeks are installed). On this particular boat we used a rudder gudgeon and a transom gudgeon above and below. If we wanted the bottom set lower, we would have used a sternpost gudgeon. © 2012 W. J. Simmons, Duck Trap Woodworking phone: 207-789-5363 email [email protected] website: www.duck-trap.com.

View Full Text

Details

  • File Type
    pdf
  • Upload Time
    -
  • Content Languages
    English
  • Upload User
    Anonymous/Not logged-in
  • File Pages
    1 Page
  • File Size
    -

Download

Channel Download Status
Express Download Enable

Copyright

We respect the copyrights and intellectual property rights of all users. All uploaded documents are either original works of the uploader or authorized works of the rightful owners.

  • Not to be reproduced or distributed without explicit permission.
  • Not used for commercial purposes outside of approved use cases.
  • Not used to infringe on the rights of the original creators.
  • If you believe any content infringes your copyright, please contact us immediately.

Support

For help with questions, suggestions, or problems, please contact us