Installation Instructions for VLTOR’s KeyMod™ Accessories VLTOR Weapon Systems Phone: 520-408-1944 3735 N. Romero Road Fax: 520-293-8807 Tucson, Arizona 85705 Email: [email protected] Improper installation can result in damage. Do not attempt installation if your are not familiar with the firearm, tools and techniques involved. You are responsible for any damage or injury resulting from the improper use or installation of this product. Copyright 2014 - VLTOR Weapon System, all rights are reserved. These instructions apply to all of VLTOR’s KeyMod™ Grip Panels, Rail Sections and QD Mounts, including the following: • KM-RAILSKeyMod™ Rail Kit • KM-SR9 KeyMod™ Slimline Single • KM-RAIL2KeyMod™ 2” Rail Section Rail 9” Grip Panel • KM-RAIL4KeyMod™ 4” Rail Section • KM-DR12KeyMod™ Slimline Double • KM-RAIL6KeyMod™ 6” Rail Section Rail 12” Grip Panel • KM-MG6KeyMod™ Modular 6” • KM-QDF KeyMod™ Quick Detachable Grip Panel Sling Swivel Mount, Rotational • KM-MG8KeyMod™ Modular 8” • KM-QDLKeyMod™ Quick Detachable Grip Panel Sling Swivel Mount, Anti-Rotational ****** ALWAYS ENSURE THAT THE FIREARM IS UNLOADED PRIOR TO ****** ****** INSTALLATION****** 1. With the screws loosened but not removed, place the mount onto the handguard section desired. Drop the screws into the large end of the KeyMod™ slot. The foot of the KeyMod™ screw will be facing the small end of the KeyMod™ slot. 2. Slide the mount forward until it stops. Press down on the mount to ensure it is flush to the handguard and tighten down the screws. Installation Tips • When installing multiple KeyMod™ accessories, start with the forward most accessory. • Note- the KM-QDF will not install into the forward most position. .