Lighting Grill Lighting Grill (cont.) Features Using Grill Before Lighting Grill This will allow accumulated gas to dissipate. After Lighting Side Burners Lighting Grill Burners with Flash Tubes Before You Begin Smoker Box Prior to turning on the gas, inspect the gas supply several failed attempts, the burner can be lit with a First, remove the burner cover or any cooking utensil If you have just attempted to light the burner with the 15 • Before each use, turn the control knob to “HIGH” Using the smoker box feature intensifies the flavor by tubing or hose. Look for evidence of abrasion, cuts, paper book match using the flash tubes. from the burner grate. ignitor, allow 5 minutes for any accumulated gas to 14 and preheat for 5-7 minutes. adding smoke to the grilling process. The additional wear and tear, or other damage which could require dissipate. Place the lit match through the grid next to • Check to be certain the drip tray is in place. smoke creates a “cloud” around the food which replacement prior to use. Make sure all burner control the flash tube of the burner being lit. Keep your face • Light the grill burners using the lighting instructions. permeates meats and vegetables for added smoky knobs are off. DO NOT attempt to light the burners if CAUTION as far away from the grill as possible. Make sure the • Place the food on the grill and cook to the desired flavor. In order to use the smoker box, remove the last the smell of gas is present. The side burner cover may be hot if the grill match is adjacent to the flash tube. Push and turn the 13 doneness. Adjust heat setting, if necessary. The set of porcelain grids on the right hand side of the burners are in operation. control knob until the “HIGH” position on the knob control knob may be set to any position between grill. Set the smoker box in the opening so that the Check the connection with a soap and water solution FFlashlash ttubeube aligns with the indicator line on the control panel. “HIGH” and “LOW.” front and rear tabs rest on the grill frame. after attaching the hose. Make sure there is gas in the Push and turn the control knob until the “HIGH” Make sure you are turning the control knob that • Allow grill to cool before cleaning. (Drip tray should tank and the tank is upright. position aligns with the indicator line on the control corresponds with the burner being lit. If the burner be cleaned after each use.) panel. Immediately press the electronic ignition does not light in 4 seconds, turn the knob to button corresponding to the burner(s) being lit “OFF,” wait 5 minutes, and try again. If the burner 12 Canopy Thermometers (If Applicable) CAUTION until the burner is lit or until 4 seconds pass. If the will not light after several attempts, see the Your outdoor grill is equipped with a thermometer on burner does not light after several attempts, wait Troubleshooting section. 1 the canopy. The thermometer is designed to aide in Wait at least five minutes before relighting a hot five minutes to allow any accumulated gas to the preheating of the grill and closed canopy grilling. grill to allow any accumulated gas to dissipate. Lighting Grill Burners with Flash Tubes dissipate. If the burner will not light after several Lighting Infrared Rotisserie Burner The estimated cooking temperatures with the canopy Keep a spray bottle of soapy water near the gas 11 If you have just attempted to light the burner with the attempts, then the burner can be lit by holding a lit (On Applicable Models ) 2 closed are: supply valve and check the connections for gas Smoker box leaks before each use. igniter, allow 5 minutes for any accumulated gas to match next to the burner ports. Push and turn the The location of the infrared burner makes it more dissipate. Place the lit match through the grid next to control knob until the “HIGH” position on the knob susceptible to strong wind conditions—more so than 10 WARM 150˚F (65˚C) the flash tube of the burner being lit. Keep your face aligns with the indicator line on the control panel. the protected grill burners. For this reason you should COLD SMOKE 150˚F – 200˚F (65˚C – 93˚C) Battery Ignition Models as far away from the grill as possible. Make sure the avoid using it during windy conditions. When lighting a burner, ALWAYS pay close attention match is adjacent to the flash tube. Push and turn the Lighting the Grill Burners SMOKE 200˚F – 300˚F (93˚C – 149˚C) to what you are doing. Be certain you are pressing control knob until the “HIGH” position on the knob (300 and 500 Series Models) Open the canopy. Push in and turn the rotisserie GRILL 300˚F – 750˚F (149˚C – 399˚C) the battery ignition button corresponding to the aligns with the indicator line on the control panel. Make sure the unit is plugged into a properly control knob until the “HIGH” position on the knob 3 Wood Chip Use in Smoker Box burner you are lighting. Make sure you are turning the control knob that grounded receptacle. Turn the appropriate control aligns with the indicator line on the control panel and There are many wood chips available and selection is corresponds with the burner being lit. If the burner knob counter-clockwise to any position. This control is continue to hold in the knob. Press the electronic 9 Canopy based on personal taste. The most common chips does not light in 4 seconds, turn the knob to “OFF,” both a gas valve and an electric switch. Burners will ignition button which corresponds to the rotisserie 4 thermometer used are mesquite or hickory. ALWAYS soak the chips Electronic wait 5 minutes, and try again. If the burner will not ignite at any “ON” position with the automatic control knob. You will hear a clicking sound. After the 8 in water prior to putting them into the box. Use the ignitor Grill burnerburner light after several attempts, see the Troubleshooting recognition system. If the flame goes out for any burner lights, hold the rotisserie control knob in about “HIGH” position to start the chips smoking, then control knob section. reason, the burners will automatically reignite if the 5 seconds longer or until the burner remains lit. Once reduce the heat to a lower level to prevent them from 7 450 500 5 400 550 gas is still flowing. When gas is permitted to flow to lit, turn the control knob to the desired setting. If the 350 drying out and flaming. If the wood chips do flame Side burner 6 600 Lighting TruSear™ Infrared Burner the burners, the electric igniters start sparking. On all burner does not light within 4 seconds, release and 300 up, add a small amount of water to extinguish the control knob 650 (If Applicable) surface igniters, you should hear a clicking sound. If turn the control knob to “OFF”. Wait 5 minutes for 250 flame. Use caution when adding water to a hot box to Note : Control locations will vary according to model. 200 700 Rotisserie Before lighting the burner, remove the stainless steel you do not, turn off the control and check that the any accumulated gas to dissipate. If the burner does 150 750 avoid steam burns. This tray may also be filled with control knob cover. Push in and turn the TruSear™ infrared control unit is plugged in and that the fuse or circuit breaker not light after several attempts, then the burner can water to produce steam. Whether smoking or °F knob until the “HIGH” position on the knob aligns is not blown or tripped. be lit by holding a lit match to the burner (with the 1. Electronic ignition 8. Smoker box steaming, the grill should remain closed as much as Note: Control locations with the indicator line on the control panel. You will control knob pushed in at the light position). Push and 2. Rotisserie control knob 9. Rotisserie bracket possible to maximize the effect. will vary according to model. hear a clicking sound. Once lit, turn the control knob Within a few moments, enough gas will have traveled turn the control knob until the “HIGH” position on the to the desired setting. If the burner does not light to the burner to be able to light. When the burner knob aligns with the indicator line on the control 3. Pull out drip tray 10. Rotisserie motor During extended roasting periods, it is normal to within 4 seconds, release and turn the control knob lights, turn the burner control to any position to adjust panel. Make sure you are turning the control knob 4. Grill burner control knobs 11. Spit rod w/forks add fresh wood chips and water to the box several Lighting Grill Burners to “OFF.” Wait 5 minutes for any accumulated gas the flame size. If the burner does not light in 4 that corresponds with the burner being lit. If relighting 5. 9V battery—behind control 12. Warming rack times. Limit the amount of times the canopy is Open the hood or remove covers. Push and turn the to dissipate and try again. After several failed seconds, turn the knob to “OFF” and wait 5 minutes a hot burner, wait 5 minutes. NEVER leave the panel (100 Series models) (if applicable) opened—each peek adds about 15 minutes to the control knob until the “HIGH” position on the knob attempts, the burner may be lit by turning the control before trying again.