Exhibit 10 Contractor-Provided Equipment 1. Uniform Requirements The Contractor shall furnish uniform clothing items, as indicated below, to PSOs performing on this Contract. Badges, patches, and other approved devices worn on uniforms shall carry distinctive company markings and in compliance with applicable state and local laws. Note: Regional Directors, or designee, may authorize adjustments to uniform clothing items to account for varying climate zones. Uniform Components Type Color Minimum Body Armor Minimum, NIJ Level IIA with Concealed Carrier Black 1 *Boots Pair, Quarter Black 1 Cap Baseball Style Black 2 Cap Faux Fur Trooper Style Black 0 Double Magazine Case or Speed Loader Case Nylon, Compatible with Specified Weapon Black 1 Duty Belt “Keepers” Nylon Black 4 Expandable or Straight Police With Holder Black 1 Nylon, Slide on Belt Type, Holds Set of Single Use 1 Glove and MicroShield Disposable Gloves and One (1) Single Use Black Gloves Winter, Pair Black 1 Handcuff Case Nylon Black 1 Handcuffs and Keys Meets NIJ 0307.01 1 Jacket Winter, Patrol Type Black 1 Jacket Nylon Windbreaker Black 1 Key Strap with Flap Nylon Black 1 Retention Holster Minimum, Level II, Nylon, Slide on Belt Type with hammer safety strap (left/right as Black 1 required) MicroShield Single Use, Disposable 1 2-1/2” x 5/8” Metal Plate with Rounded Edges Gold Nameplate and Metal 1/4” Lettering Identifying First Initial and Last with Black 2 Name Lettering Necktie Clip-on Black 2 2.0-ounce Non-Flammable Flip Top Safety Oleoresin Capsicum (OC) Canister with Stream or Foam Spray Pattern 1 (or as designated by State or local) Exhibit 10 Contractor-Provided Equipment Uniform Components Type Color Minimum Oleoresin Capsicum (OC) Nylon, Slide on Belt Type Black 1 Case Pistol belt Nylon without Shoulder Strap Black 1 Shirt, long sleeve Insignia, Shoulder Patch Light Gray 4 Shirt, short sleeve Insignia, Shoulder Patch Light Gray 4 Trouser All Season Weight Black 4 Flashlight w/holder Portable Black 1 Optional/Regional Specific N/A *PSO must wear black low Quarter Boots* Exhibit 10 Contractor-Provided Equipment The contractor will provide all security officers, including part-time and reserve officers, with their own pistol. Select the firearm that will be used: Caliber 9mm X Caliber .40 Caliber .38 Caliber .357 Specifications 1. Caliber 9mm The overall size shall not exceed 7.5” long, 5.5” high, and 1.5” wide and weigh no more than 30 oz. excluding the magazine. The caliber authorized is 9MM and not any larger. The magazines (three for each pistol) shall hold a minimum of 10 rounds and not more than 17. The pistol must be able to be fired without a magazine inserted into the weapon. The magazine must fall free (unloaded) when the magazine catch is activated. The double action only trigger pull must not weigh more than 12 pounds and not less than 5 pounds. The pistol may be either a traditional double action only or a striker fired design. The pistol shall have a dark corrosive resistant finish and must be must be capable of being fired without the manipulation of an external safety or cocking lever. Passively operated grip or trigger safeties are acceptable. The normal function of the pistol shall be double action only. The pistol must be operable by a right or left-handed user. The use of a polymer-framed pistol is acceptable. There is not a requirement for an all-metal firearm. All safeties must be internal or passive. An inertial interlocked firing pin will be the primary safety to positively prevent movement of the firing pin unless the trigger is pulled completely through its entire length of travel. The sights must be drift adjustable and be luminous night sights, one (1) dot on the front sight, and two (2) dots on the rear sight, which appear as three (3) illuminated dots when the weapon is held at arm’s length. The illuminated dots must not be visible when viewed from the muzzle end of the pistol. The color of the illuminated dots must be green. The illumination materials for the night sight must comply with Nuclear Regulatory Commission standards. The following pistols are recommended: Smith & Wesson M&P 9 MM; 5900 Series in DAO 9MM Glock 17 & 19 9MM SIGARMS Sigpro 9MM; P226 and P228 in 9MM DAO Steyr M Series 9MM Springfield Armory XD in 9MM Ammunition type is authorized: 110- 147 grain Jacketed Hollow Points. (If local statutes permit) Exhibit 10 Contractor-Provided Equipment Recommended Brands: • Federal • Speer • Winchester • Remington Exhibit 10 Contractor-Provided Equipment 2. Caliber .38 SPECIAL The overall size shall not exceed 10.5” long, 5.5” high, and 1.55” wide and weigh no more than 42 oz. or less than 35 oz. empty with a 4 inch non-ported, semi or fully shrouded (lugged) barrel. The pistol may be capable of firing either 38 Special +P or .357 Magnum cartridges although the duty caliber authorized is .38 Special +P. The cylinder shall hold 6 rounds and be opened with the manipulation of just one release. The double action trigger pull must not weigh more than 12 pounds and not less than 5 pounds. The pistol shall have a blued or stainless-steel finish and must be capable of being fired without the manipulation of an external safety. The normal function of the pistol shall be double action with the capability of being fired in a single action mode. The pistol must be operable by a right or left-handed user. With the exception of grips and small internal parts, it shall be an all-metal firearm. All safeties must be internal and passive. A transfer bar type mechanism will be the primary safety to positively prevent contact between the hammer and firing pin or hammer and cartridge primer unless the trigger is pulled completely through its entire length of travel. The sights must be fixed front and fixed, drift or fully adjustable rear. The following pistols are recommended: • Smith & Wesson Model 686 K or L frame • Taurus Model 82 or 65 • Ruger GP 100 Series Ammunition type authorized: • 110 – 135 grains +P rated Jacketed Hollow Point. (If local statutes permit) Recommended Brands: • Federal • Speer • Winchester • Remington 3. Caliber .40 S&W The overall size shall not exceed 7.5” long, 5.5” high, and 1.5” wide and weigh no more than 30 oz. excluding the magazine. The caliber authorized is .40 S&W and not any larger. The magazines (three for each pistol) shall hold a minimum of 10 rounds and not more than 15. The pistol must be able to be fired without a magazine inserted into the weapon. The magazine must fall free (unloaded) when the magazine catch is activated. The double action only trigger pull must not weigh more than 12 pounds and not less than 5 pounds. The pistol may be either a traditional double action only or a striker fired design. Exhibit 10 Contractor-Provided Equipment The pistol shall have a dark corrosive resistant finish and must be must be capable of being fired without the manipulation of an external safety or cocking lever. Passively operated grip or trigger safeties are acceptable. The normal function of the pistol shall be double action only. The pistol must be operable by a right or left-handed user. The use of a polymer-framed pistol is acceptable. There is not a requirement for an all-metal firearm. All safeties must be internal or passive. An inertial interlocked firing pin will be the primary safety to positively prevent movement of the firing pin unless the trigger is pulled completely through its entire length of travel. The sights must be drift adjustable and be luminous night sights, one (1) dot on the front sight, and two (2) dots on the rear sight, which appear as three (3) illuminated dots when the weapon is held at arm’s length. The illuminated dots must not be visible when viewed from the muzzle end of the pistol. The color of the illuminated dots must be green. The illumination materials for the night sight must comply with Nuclear Regulatory Commission standards. The following pistols are recommended: • Smith & Wesson M&P .40 Cal. • Glock 22 & 23 .40 Cal. • SIGARMS Sigpro .40 Cal.; P226 and P229 • Steyr M Series .40 Cal. • Springfield Armory XD in .40 Cal. • H&K USP (Variant 7 DAO) .40 Cal. Ammunition type authorized: • 155-180 grain Jacketed Hollow Point Recommended Brands: • Federal • Speer • Winchester • Remington 4. Caliber .357 SIG The overall size shall not exceed 7.5” long, 5.5” high, and 1.5” wide and weigh no more than 30 oz. excluding the magazine. The caliber authorized is .357 SIG. The magazines (three for each pistol) shall hold a minimum of 10 rounds and not more than 15. The pistol must be able to be fired without a magazine inserted into the weapon. The magazine must fall free (unloaded) when the magazine catch is activated. The double action only trigger pull must not weigh more than 12 pounds and not less than 5 pounds. The pistol may be either a traditional double action only or a striker fired design. The pistol shall have a dark corrosive resistant finish and must be must be capable of being fired without the manipulation of an external safety or cocking lever. Passively operated grip or trigger safeties are acceptable. The normal function of the pistol shall be double action only. Exhibit 10 Contractor-Provided Equipment The pistol must be operable by a right or left-handed user. The use of a polymer-framed pistol is acceptable.