Intermediate Stop Replacement Product Series: A-Series, 400 Series Read these instructions before starting procedure. Product Type: Frenchwood® Patio Doors with For additional information visit www.andersenwindows.com. For questions call 1-888-888-7020. Blinds-Between-the-Glass Para obtener una versión en español de esta guía, visite el sitio www.andersenwindows.com Parts Included: Tools and Supplies Needed: (1) Intermediate (1) 1.5 mm Hex Key Safety Pencil Stop Glasses · Follow manufacturers’ instructions for hand and power tools. Always wear safety glasses. Failure to do so could result in injury, product or property damage. · Windows and doors have small parts (e.g. hole plugs, operator spline caps, fasteners, etc.). Small parts if swallowed could pose a choking hazard to young children. Dispose of unused, loose, or easily removed small parts. Failure to do so could result in injury. 1 2 End Cap Track Tilt Hex Key Operator Track Track Loosen set screw on end cap using hex key. Remove end cap Note orientation of tilt operator. Slowly slide tilt operator up and off of track from track and retain for reuse. and retain for reuse. “Andersen” and all other marks where denoted are trademarks of Andersen Corporation. ©2020 Andersen Corporation. All rights reserved. 9184899 BA-00 Revised 08/06/20 3 4 Pencil Intermediate Stop Loosen both set screws on intermediate stop. Note orientation of Mark end location of intermediate stop on track to identify its intermediate stop. Slide intermediate stop up and off of track and resting location. dispose of properly. 5 6 Tilt Operator Pencil mark End Cap barely visible. New Intermediate Stop Slide tilt operator and end cap back onto track. When flush with each other, Match orientation of new intermediate stop with the one previously tighten set screw using hex key. removed. Slide new intermediate stop onto track until pencil mark is barely visible. Tighten set screws until flush with intermediate stop. ▶ Procedure is complete. 9184899 2.