PREPARATION FOR USE CLIPPING CLEANING & MAINTENANCE OF CLIPPER BATTERY DISPOSAL MODEL HC900R LIMITED FIVE YEAR WARRANTY PROFESSIONAL • Always inspect the appliance for noticeable • Attach a comb guide as required. Note To maintain optimum performance, the This appliance contains Nickel Metal Hydride appliance should be cleaned after each use: batteries. To protect the environment this Conair will repair or replace (at our option) your signs of damage. Do not use if damaged. Comb Guides section for specific lengths. unit free of charge for 60 months from the date of • Always inspect the appliance before use • Switch on the clipper using the on/off • Remove the comb guide after use. Rinse the appliance and its batteries must be disposed 1 comb guide under running water and dry of safely. At the end of its life, please take purchase if the appliance is defective in workman- EVEN CUT to ensure the clipper blades are free sliding switch located on top of the clipper ship or materials. maintain a short, even cut – easily! from hair, debris etc. (see Cleaning & and the blades will start to move and the thoroughly before storage or use. this appliance to a recycling center, where Maintenance of clipper). green LED will illuminate. • Never place the clipper under running water. the internal rechargeable battery should Stainless 2 To obtain service under this warranty, return the • After each use ensure hair is emptied from be removed by a professional and recycled Steel Blades 3 4 defective product to the service center listed below, • Prior to use always inspect the head for • Begin cutting on the top of your head. the blade area and use the cleaning brush to separately. For more information about the warts, moles, spots and broken skin. If using Slowly and gently steer the clipper around together with your purchase receipt and $5.00 for clean thoroughly. recycling of electrical and battery operated 5 postage and handling. California residents need the clipper on yourself either use mirrors or the scalp, taking care on areas where there • It is highly recommended to apply a small appliances please contact your local council ask another person to check for you. Special may be warts, moles, spots and broken only provide proof of purchase and should call amount of oil (provided) to the blades before office or your household waste disposal ser- 1-800-366-0937 for shipping instructions. In the care should be taken when cutting hair skin and keep away from the ears. each use. vice. For specific enquiries regarding the re- in areas that have warts, moles, spots or absence of a purchase receipt, the warranty period • Again, remember you must have a shorter • Wipe the outside with a damp cloth and dry placement of batteries in this product please Ergonomic Design shall be 60 months from the date of manufacture. broken skin, to prevent injury. hair style, length to begin, as this item will thoroughly before use or storage. contact our Conair Customer Care Line. • Remove any head jewelry such as earrings not work on longer, layered hair. 6 ANY IMPLIED WARRANTIES, OBLIGATIONS, OR and necklaces before use. STORAGE CONTAINS NICKEL METAL LIABILITIES, INCLUDING BUT NOT LIMITED TO FOR BEST RESULTS USE IN A When not in use, allow clipper to cool and HYDRIDE BATTERIES. MUST BE THE IMPLIED WARRANTY OF MERCHANTABILITY • For best performance use on clean, dry hair CIRCULAR MOTION. COLLECTED, RECYCLED OR that has been combed until tangle-free. store in a safe, dry location and out of the DISPOSED OF PROPERLY. DO AND FITNESS FOR A PARTICULAR PURPOSE, • The clipper can be moved in any direction reach of children. Never pull, twist or wrap NOT DISPOSE OF IN SHALL BE LIMITED IN DURATION TO THE 60 • If hair is long, use the scissors and comb THE MUNICIPAL WASTE. to cut your hair. Only apply gentle pressure. the cord around the clipper. 1 Barber Comb MONTH DURATION OF THIS WRITTEN, LIMITED provided to cut the hair prior to using the Never force the clipper - if resistance is Screw WARRANTY. Some states do not allow limitations clipper. experienced lift clipper away from the head, 2 Scissors on how long an implied warranty lasts, so the above • Ensure the appliance is sufficiently charged empty hair from the clipper and resume 3 Neck Brush limitations may not apply to you. or plugged into the outlet. clipping. IN NO EVENT SHALL CONAIR BE LIABLE FOR NOTE: The appliance should not be used for 4 Oil • If using on areas where there are folds of ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL longer than 15 minutes when operated from skin, ensure the skin is stretched taught prior 5 Storage pouch Please register this product at the outlet. DAMAGES FOR BREACH OF THIS OR ANY to cutting hair in this area. OTHER WARRANTY, EXPRESS OR IMPLIED, www.conair.com/registration 6 2 Adjustable Comb Guides • If you experience any discomfort stop using WHATSOEVER. Some states do not allow the exclu- Instruction Booklet WARNING - The clipper is for use only immediately. For your safety and continued enjoyment on the head. Never use the clipper on the face Screw sion or limitation of special, incidental, or conse- of this product, always read the instruction or any other area of the body. • NOTE - Hair will collect in the area inside Removing the Battery quential damages, so the above limitation may not ©2011 Conair Corporation booklet carefully before using. the blade ring. This may need to be emptied IMPORTANT - Do not attempt to trim hair close apply to you. Service Center before all the hair has been cut. Switch the Cord/Cordless Clipper Conair Corporation to your ears with the clipper. Never allow ears clipper off and remove any hair by simply This warranty gives you specific legal rights, and you to enter the ring of the clipper blade. may also have other rights, which vary from state Service Department tapping gently on the top of the clipper. 7475 North Glen Harbor Blvd. to state. • If you require a grade 0 cut, the clipper can Glendale, AZ 85307 be used without a comb guide attached for Battery an ultra close, even cut. 11PG121622 IB-10691 Model HC900R 11. Do not short the polarity (output cord). • Ultra sharp stainless steel blades for fast, For the best results we advise you start • Ensure the appliance is switched off. PRESERVING THE BATTERIES ATTACHING A COMB GUIDE CHANGING THE COMB GUIDE IMPORTANT SAFETY DO NOT REACH Ensure jack is plugged into the unit before precise cutting. cutting the back of the head and with a • Insert the small plug on the charging adaptor In order to maintain the optimum capacity of To attach a comb guide, make sure the LENGTH SETTING INTO THE WATER plugging the adapter into outlet. • Ergonomic design – it fits into the palm of sweeping motion run from the back to the into the socket on the side of the appliance. the rechargeable batteries, the appliance has appliance is switched off. Hold the clipper with Comb guide 1 for grades 1-3, will lock into 3 INSTRUCTIONS 12. This power unit is intended to be correct your hand. front of your head concentrating on one area • Plug the charging unit into a suitable outlet to be fully discharged and then recharged for the blades facing downwards and place the different positions, providing 3 cutting length When using electrical appliances, especially until you reach the desired length. when children are present, basic safety precau- WARNING – To reduce the risk of as per instruction booklet. • 2 adjustable comb guides for grades 1-4 socket. 16 hours every 3 months approximately. comb guide over the top of the clipper with the grade settings. Comb guide 2 for grade 4, tions should always be taken, including burns, electric shock, fire, or injury to persons: 13. For connection to a supply not in the (comb guide 1 cuts lengths 1/8", 1/4" and Once you have completed this over your • The red charging indicator light on the power COMB GUIDES teeth of the comb facing downwards. Release locks into 1 position and provides 1 cutting the following: 1. Never leave a plugged-in appliance U.S.A., use an attachment plug adapter of the 3/8" and comb guide 2 cuts lengths 1/2"). whole head you should then finish using handle will illuminate when the appliance is This appliance is supplied with 2 adjustable the comb guide locking mechanism, located length grade setting. The comb guide will on the side of the appliance, by sliding it away be marked with its grade settings (Fig.3). In unattended. proper configuration for the power outlet. • Includes barber’s comb, neck brush, circular motions as this ensures you achieve correctly connected to the outlet. comb guides that provide 4 cutting lengths a perfect even finish. Please note that when from the comb guide. Line up the dot indicator order to change the grade setting release the 14. Always attach plug to appliance first, then scissors, storage pouch, oil, and barber • A full charge will supply enough power for from grades 1-4. READ ALL INSTRUCTIONS 2. This appliance should not be used by you first begin cutting your hair you may on the comb guide (Fig. 1) with the grade comb guide locking mechanism found on the children or individuals with certain disabilities. to outlet. To disconnect, turn all controls to cape. approximately 20 minutes of use. BEFORE USING "OFF", then remove plug from outlet. notice that some hair is being cut and other CUTTING LENGTH GRADE setting marker on the clipper (Fig. 1) then gently side of the clipper (Fig.4) and rotate the comb 3.