Final draft ETSI EN 301 668-1 V1.1.2 (2000-05) European Standard (Telecommunications series) Intelligent Network (IN); Intelligent Network Capability Set 1 (CS1) extension; Intelligent Network Application Protocol (INAP); Part 1: Protocol specification for Camel Phase 2 2 Final draft ETSI EN 301 668-1 V1.1.2 (2000-05) Reference DEN/SPS-03053-1 Keywords IN, INAP, ISDN, mobile, protocol ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.:+33492944200 Fax:+33493654716 Siret N° 348 623 562 00017 - NAF 742 C Association à but non lucratif enregistrée à la Sous-Préfecture de Grasse (06) N° 7803/88 Important notice Individual copies of the present document can be downloaded from: http://www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http://www.etsi.org/tb/status/ If you find errors in the present document, send your comment to: [email protected] Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media. © European Telecommunications Standards Institute 2000. All rights reserved. ETSI 3 Final draft ETSI EN 301 668-1 V1.1.2 (2000-05) Contents Intellectual Property Rights................................................................................................................................6 Foreword ............................................................................................................................................................6 1 Scope........................................................................................................................................................7 2 References................................................................................................................................................7 3 Abbreviations ...........................................................................................................................................9 4 General .....................................................................................................................................................9 4.1 Definition methodology......................................................................................................................................9 4.2 Example physical scenarios................................................................................................................................9 4.3 INAP addressing.................................................................................................................................................9 4.3.1 Quality of service parameters .....................................................................................................................10 4.3.2 SCCP addressing ........................................................................................................................................10 4.4 Definition and usage of LegID .........................................................................................................................10 4.5 Detection Points ...............................................................................................................................................10 4.5.1 DP processing rules ....................................................................................................................................10 5 Reflection of TCAP Application Context (AC).....................................................................................11 6 Additional abstract syntax......................................................................................................................11 6.1 Operation types.................................................................................................................................................11 6.2 Operation timers...............................................................................................................................................12 6.3 Data types.........................................................................................................................................................12 6.4 Application Service Elements...........................................................................................................................18 6.4bis Application contexts.........................................................................................................................................18 6.5 Classes..............................................................................................................................................................19 7 Error procedures.....................................................................................................................................19 7.1 Operation related error procedures...................................................................................................................19 7.1.1 MissingCustomerRecord.............................................................................................................................19 7.1.1.1 Operations SSF->SCF...........................................................................................................................19 7.1.2 MissingParameter .......................................................................................................................................20 7.1.2.1 Operations SSF -> SCF.........................................................................................................................20 7.1.3 UnknownLegID ..........................................................................................................................................20 7.1.3.1 Operations SCF->SSF...........................................................................................................................20 7.2 Entity related error procedures .........................................................................................................................20 7.2.1 Expiration of TSSF ......................................................................................................................................20 7.2.1.1 Procedures SSF->SCF...........................................................................................................................20 8 Detailed operation procedures ...............................................................................................................20 8.1 ApplyCharging procedure ................................................................................................................................20 8.1.1 General description.....................................................................................................................................20 8.1.1.1 Parameters.............................................................................................................................................20 8.1.1.2 Normal procedure .................................................................................................................................21 8.1.1.3 Error handling .......................................................................................................................................21 8.2 ApplyChargingReport procedure......................................................................................................................22 8.2.1 General description.....................................................................................................................................22 8.2.1.1 Parameters.............................................................................................................................................22 8.2.2 Invoking entity (SSF)..................................................................................................................................23 8.2.2.1 Normal procedure .................................................................................................................................23 8.3 AssistRequestInstructions procedure................................................................................................................23 8.3.1 General description.....................................................................................................................................23 8.3.1.1 Parameters.............................................................................................................................................23 8.4 CallInformationReport procedure.....................................................................................................................23 8.4.1 General description.....................................................................................................................................23 8.4.1.1 Parameters.............................................................................................................................................24