Cisco Ultra-Reliable Wireless Backhaul FM3500 Endo Installation and Configuration Manual (Formerly Fluidmesh) Model FM3500 | Edition 1.12 | Firmware 9.1.4 Copyright © Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word 'partner' does not imply a partnership relationship between Cisco and any other company. (1110R) © 2018–2020 Cisco Systems, Inc. All rights reserved. Table of Contents 1. HAZARDOUS CONDITION WARNINGS ........................................................... 7 1.1. Water Ingress Hazard ............................................................................. 8 1.2. Radio-Frequency Transmission Hazard .................................................... 9 1.3. Hot Surfaces Hazard ............................................................................. 10 2. Reporting Mistakes And Recommending Improvements .................................... 11 3. Getting Started .............................................................................................. 12 3.1. Introduction .......................................................................................... 12 3.1.1. Cisco FM3500 Endo ..................................................................... 12 The Cisco FM3500 Endo Radio Transceiver ...................................... 12 Introduction .................................................................................... 12 Data Throttling ................................................................................ 13 MPLS Protocol ................................................................................ 13 Unit Configuration ........................................................................... 13 Environmental Rating ...................................................................... 13 Product Specifications ..................................................................... 13 Transceiver And Gateway Unit Power Consumption .......................... 13 3.2. Fluidmesh Architecture ......................................................................... 15 3.2.1. Overview ..................................................................................... 15 Wireless Network Architectures ........................................................ 15 3.2.2. Fluidmesh Technologies ............................................................... 15 Prodigy .......................................................................................... 15 Fluidity ........................................................................................... 16 FM Racer ....................................................................................... 16 3.2.3. Point-To-Point Wireless Bridge ...................................................... 16 3.2.4. Mesh Network Architecture ........................................................... 17 3.3. Fluidmesh Network Addressing ............................................................. 18 3.3.1. Bridge IP Addressing ................................................................... 18 3.3.2. Unit Identification And Addressing ................................................. 19 Mesh- And Bridge-Capable Radio Transceiver Identification ............... 19 Operating The Unit In Mesh Point Mode Or Mesh End Mode .............. 20 Network Addressing ........................................................................ 21 Fluidmesh Radio Transceivers ................................................... 21 Connecting And Configuring An Ethernet Edge Device ...................... 21 Fluidmesh Radio Transceivers ................................................... 22 4. Installing The Radio ....................................................................................... 23 4.1. Installing The Radio Using Tie-Wraps Or Hose Clamps ........................... 23 4.2. Installation On A DIN Rail ...................................................................... 24 4.3. Installation Using The Sliding Bracket ..................................................... 25 5. Hardware Installation ..................................................................................... 27 5.1. Fluidmesh Hardware Installation ............................................................ 27 5.1.1. Installing The Cisco FM3500 Endo ................................................ 27 Environmental Rating And Unit Roles ............................................... 27 Installation Hardware ....................................................................... 27 Removable Bottom Housing ............................................................ 27 5.1.2. Best Practice For Shielded CAT5/6 Connectors .............................. 28 5.1.3. Cisco FM3500 Endo Status And Link LEDs ................................... 28 Unit And Link Quality Status ............................................................ 28 Boot Sequence ............................................................................... 29 5.1.4. Supplying Power To The Cisco FM3500 Endo ................................ 29 Connecting Power To The Cisco FM3500 Endo ................................. 30 Connecting Power Through A LAN Ethernet Port ......................... 30 © 2021 Cisco and/or its affiliates. All rights reserved. Page 3 of 177 5.1.5. Rebooting The Firmware And Resetting The Unit To Factory Defaults ............................................................................................... 31 Device Firmware Reboot ................................................................. 32 Resetting The Unit To Factory Settings ............................................. 32 5.1.6. Suitability For Outdoor Installation ................................................. 33 5.2. Connecting The Cisco FM3500 Endo To Networking And Communications Hardware .......................................................................... 34 5.2.1. Terminal Assignments For Power And Data Connectors .................. 34 RJ45 Ethernet ................................................................................ 34 5.2.2. Connecting LAN Cables To The Unit ............................................. 36 Bottom Housing And RJ45 LAN Cables ............................................ 36 5.2.3. Connecting The Antennas To The Cisco FM3500 Endo .................. 38 RPSMA Antenna Connections ......................................................... 38 6. Using The Fluidmesh Partner Portal ............................................................... 41 6.1. Accessing The Partner Portal ................................................................ 41 6.2. Enabling Two-Factor Authentication For Security .................................... 42 6.3. Administering Plug-In License Codes ..................................................... 44 6.4. Using The RACER™ Radio Configuration Interface ................................. 44 6.5. Viewing The Technical Documentation For Your Fluidmesh Device ........... 44 7. Device Configuration Using The Configurator Interface .................................... 46 7.1. Software And Hardware Prerequisites .................................................... 48 7.2. Accessing The Cisco FM3500 Endo For Device Configuration ................. 48 7.2.1. Local Access And Login For Initial Configuration ............................ 49 7.2.2. Initial Configuration With The Unit In Provisioning Mode .................. 52 7.3. Switching Between Offline And Online Modes ......................................... 58 Uploading A Device Configuration File From FM Racer ............................ 59 7.4. Viewing And Accessing The FM Monitor Settings .................................... 60 7.5. General Settings ................................................................................... 62 7.5.1. The General Mode Window .......................................................... 62 Changing The Operational Mode ...................................................... 63 Changing The Operational Mode On A Mesh Network-Capable Unit .......................................................................................... 63 Changing The Prodigy Version ......................................................... 65 Changing The LAN Parameters ........................................................ 66 7.5.2. Wireless Settings ......................................................................... 67 Modifying The Wireless Settings ...................................................... 67 Important Considerations For Wireless Settings ................................ 69 Co-Location Considerations ............................................................. 69 Channel Width Considerations ......................................................... 69 Dynamic Frequency Selection Considerations ................................... 70 7.5.3. Antenna-Alignment Tools And Physical Statistics ............................ 72 7.6. Network Control .................................................................................... 73 7.6.1. Ping Softdog ................................................................................ 73 7.6.2. FM-QUADRO .............................................................................. 75 FM-QUADRO For Mesh Network-Capable Devices ........................... 75 Plotting