Chapter 1 System Tour Features Below is a brief summary of the computer’s many feature: NOTE: The features listed in this section is for your reference only. The exact configuration of the system depends on the model purchased. Operating System • Microsoft Windows 7 Home Basic (X64/X86) • Microsoft Windows 7 Home Premium (X64/X86) • Microsoft Windows Starter X86 • LinuxXW • LinuxCM • FreeDOS Processor • Socket Type:Intel Socket ,LGA 1156 pins • Socket Quantity: 1 • Processor Type: • Lynnfield Quad Core(95W) family mainstream processors • Clarkdale Dual Core(79W) with on boards Graphics 32nm Chipset • PCH:H57 PCB • DTX, 4 Layers • Size:9.6inchX8.0inch Memory subsystem • Socket Type: DDR III DIMM Slots • Socket Quantity: 4 • Memory Type:DDR III • Capacity support: • 1GB/2GB/4GB DDR3 1.5v 1066/1333 Un-buffered Non-ECC/ DIMM support. • 1 GB to 16GB Max memory support. • Speed 1333 MHZ • Design Criteria: • Must meet Intel Lynnfield and Clarkdale Chipset platform design guide. • Dual channel should be enabled always when plug-in 2 same memory size DDRIII memory module. Chapter 1 1 Hard disk drive • Support SATA interface • 3.5", 25.4mm, 160/320 or higher capacity • Capacity and models are listed on FRU list • The HDD out of AVLC asked by regional office is a special case and OMD is required to propose the test schedule Optical disk drive. • Support one SATA 5.25" standard ODD • Support DVD-ROM, DVD-SuperMulti, BD ROM, BD Combo • Models are listed on FRU list Graphics card • Intel H57 on die graphic solution • Meet Microsoft Windows7 graphic requirement • DVMT 5.0 technology support VGA • Integrated for Clarkdale SKU Audio • Realtek ALC662-VC0 • Rear 3 jack follow HD audio definition • Audio jacks color coding: should meet Microsoft Windows Logo Program Device Requirements: Audio- 0002 • 1 S/PDIF internal port for graphics card support • 1 front panel audio header (2*5) • S/N ratio: 90dB at rear output jack • Follow Packard Bell Audio spec v2.9 • BIOS should meet MS Pin Configuration Guidelines for High Definition Audio Devices Serial ATA controller • Connector Type: SATA connector • Connector Quantity:2(2 Reserve,MAX support 4 ports) • Storage Type support: • 3.5" SATA/SATAII HDD • DVD and SuperMulti • Default AHCI mode in normal BIOS and IDE mode in non-Windows BIOS LAN • Lan Chip:Realtek RTL8111E. • Support Giga LAN. USB ports • Controller: Intel H57 • Ports Quantity: 12 2 Chapter 1 • 4 rear on-board ports • On-board: 4 2*5 headers (8 ports) • Data transfer rate support: • All USB ports must be 2.0 certified • All USB ports must be boot-capable includes USB-ODD, USB-HDD, USB-FDD, and etc… • All USB ports must provide the over current protection. Extension slot • Support one PCI-E x 16 slot • Support one PCI-E x 1 slots • Defined in main board specification Rear I/O connectors • 1 VGA port • 4 USB ports • 1 RJ45 LAN port • Audio connector with 3 (Default 3 jacks) for 5.1 channel • 2 PS2 keyboard/mouse connector On-board connectors • 1 * 1156 CPU socket • 1 * PCI Express x16 slot • 1 * PCI Express x 1 slot • 1 * H2X2 Power Supply Connector • 1 * 24-pin ATX PWR connector • 4 * DIMM Socket • 2 * SATA • 4 * H2*5 USB Header • 1 * H2*5 1394 Header • 1 * Front Audio Pannel H5X2 header • 1 * Front Panel IO H7X2 Header for Packard Bell pin define • 1 * H1X4 CPU FAN header • 1 * H1X3 System FAN Header co-lay with 4pin • 1 * H1X4 SPDIFOUT Header for Packard Bell pin define • 1 * H3X1 Clear CMOS Header (with jumper) • 1 * onboard Buzzer System BIOS • Type:Use SPI Flash • Kernel:AMI Kernel with Packard Bell skin Chapter 1 3 Power supply • 220W and 250W power rating support by project • Active PFC for EMEA and China • Non-PFC 220V & 110V with select switch for other region • Support list will vary overtime 4 Chapter 1 System Components This section is a virtual tour of the system’s interior and exterior components. Front Panel 1 11 2 10 3 9 4 8 5 7 6 No. Component 1 SD/MMC(Secure Digital/MultiMedia Card)slot 2 XD(XD-Picture) slot 3 CF I/II (CompactFlash Type I/II) slot 4 MS/MS PRO slot 5 Optical drive 6 Packard Bell Logo 7 Optical drive button 8 Microphone-in jack 9 Headphone/Speaker-out/line-out jack 10 USB 2.0 ports 11 Power button 6 Chapter 1 Rear Panel No. Component 1 PS2 keyboard port 2 HDMI port 3 D-sub port 4 USB 2.0 ports 5 Microphone/speaker-out/line-in jack 6 Line-out jack 7 Expansion slot 8 Line-in jack 9 RJ45 LAN connector 10 Power connector 11 PS2 mouse port /Line-out jack 12 System FAN Chapter 1 7 Hardware Specifications and Configurations Processor Item Specification Processor Type Lynnfield(95W) and Clarkdale(79W) Socket Type Intel Socket ,LGA 1156 pins Socket quantity 1 BIOS Item Specification BIOS code programer AMI Kernel with Packard Bell skin BIOS version P01-A0 BIOS ROM type SPI ROM BIOS ROM size 16Mb Support protocol SMBIOS(DMI)2.4/DMI2.0 Device Boot Support Support BBS spec 1st priority: HDD 2nd priority: CD-ROM 3th priority: LAN 4th priority: USB device Support to LS-120 drive YES Support to BIOS boot block feature YES IOS Hotkey List Hotkey Function Description Del Enter BIOS Setup Utility Press while the system is booting to enter BIOS Setup Utility. Main Board Major Chips Item Specification North Bridge H57 Audio controller Realtek ALC662-VC0 LAN controller Realtek 8111E HDD controller H57 USB controller H57 8 Chapter 1 Memory Combinations Slot Memory Total Memory Slot 1 1MB,2GB,4GB 1G ~4GB Slot 2 1MB,2GB,4GB 1G ~4GB Slot 3 1MB,2GB,4GB 1G ~4GB Slot 4 1MB,2GB,4GB 1G ~4GB Maximum System Memory Supported 1G~16GB System Memory Item Specification Memory slot number 4 slot Support Memory size per socket 1GB/2GB/4GB Support memory type DDRIII Support memory interface DDRIII 1333MHz Support memory voltage 1.5V Support memory module package 240-pin DDRIII Support to parity check feature Yes Support to error correction code (ECC) feature No Memory module combinations You can install memory modules in any combination as long as they match the above specifications. Audio Interface Item Specification Audio controller Realtek ALC662-VC0 Audio channel codec 5.1 Audio function control Enable/disable by BIOS Setup Mono or stereo Stereo Compatibility Support host audio controller from the Intel ICH series chipset, and also from any other HDA compatible audio controller. With EAX/Direct Sound 3D/I3DL2/ A3D compatibility, and excellent software utilities like environment sound emulation, multiple bands of software equalizer and dynamic range control, optional Dolby, Digital Live, DTS CONNECT, and Dolby Home Theater programs, provides an excellent home entertainment package and game experience for PC users. Sampling rate 192 KHz (max.) Microphone/Headphone jack Supported Chapter 1 9 SATA Interface Item Specification SATA controller H57 Number of SATA channel SATA X 2 Support mode AHCI/IDE mode option USB Port Item Specification Universal HCI USB 2.0/1.1 USB Class Support legacy keyboard for legacy mode USB Connectors Quantity 4 rear on-board ports On-board: 4 2*5 headers (8 ports) Environmental Requirements Item Specification Temperature Operating +5°C ~ +35°C Non-operating -20 ~ +60°C (Storage package) Humidity Operating 15% to 80% RH Non-operating 10% to 90% RH Vibration Operating (unpacked) 5 ~ 500 Hz: 2.20g RMS random, 10 minutes per axis in all 3 axes. 5 ~500 Hz: 1.09g RMS random, 1 hour per axis in all 3 axes. Power Management Devices S1 S3 S4 S5 Power Button V V V V USB Keyboard/Mouse V V N/A N/A PME Disabled Disabled Disabled Disabled RCT Disabled Disabled Disabled Disabled WOR Disabled Disabled Disabled Disabled • Devices wake up from S3 should be less than. • Devices wake up from S5 should be less than 10 seconds. 10 Chapter 1 Chapter 5 Jumper and Connector Information M/B Placement Chapter 5 54 No Label Description No Label Description 1 CPU Socket LGA1156 socket for CPU 12 FRONT_PAN FRONT_PANEL1 header EL1 2 PWR2 CPU Power connector 13 BIOS_WP BIOS write protect header 3 REAR_FAN System Fan power 14 TPM Trusted platform module Header interface header 4 CPU_FAN CPU fan power header 15 CLR_CMOS Clear CMOS jumpers 5 DIMM CONN,DIMM,DDRIII,1.5 16 PCH_ME_EN PCH_ME_ENABLE V,V/T,Blu,15u,G,DIP-240 ABLE jumpers 6 PWR1 M/B main power 17 SPDIF_OUT SPDIF out header connector 7 F~USB1~2~4 Card reader USB 18 SPEAKER1 Internal speaker header headers 8 F~USB3 ront panel USB header 19 F_AUDIO Front panel audio header 9 SATA1~2 SATA data transfe 20 PCI-E1_16X PCIE_x16socket connector 10 GPIO1~2 GPIO1~2 Reserve 21 PCI-E1-1X PCIE_X1socket headers 11 BIOS_FLASH BIOS_FLASH Header 55 Chapter 5 Jumper Setting The section explains how to set jumper for correct configuration of the mainboard. Setting Jumper Use the motherboard jumpers to set system configuration options. Jumpers with more Than one pin are numbered. When setting the jumpers, ensure that the jumper caps are Placed on the correct pins. CLR_CMOS Jumper Symbol Description Function 1-2 close Clear CMOS 2-3 close Normal (Default) ME Jumper Jumper Symbol Description Function 1-2 close Enable ME(Default) 2-3 close Disable ME Internal header pin definition Header Name Function Definition CPU FAN HEADER 1: GND 2: +12V 3: SENSE 4: PWM CONTROL FRONT PANEL HEADER 1: SATALED+ 2: ACPI_LED 3: SATALED- 4: PWR_LED 5: GND 6: PWR_SW 7: RESET 8: GND 9: NC 10: Key 11: NC 12: VCC 13: NC 14: -ACTIVE_C Chapter 5 56 Header Name Function Definition F_USB1 FRONT USB HEADER 1: USBVCC_1 1 2 VCC VCC 2: USBVCC_1 3 4 USB0- USB1- 3: USB0_XN 5 6 4: USB1_XN USB0+ USB1+ 7 8 5: USB0_XP GND GND 9 10 6: USB1_XP KEY OC0 7:GND H5X2-P9E-Y 8: GND 9: KEY 10: GND F_USB2 1: USBVCC_2 1 2 VCC VCC 2: USBVCC_2 3 4 USB0- USB1- FRONT