Electric Power Steering (EPS) Module Connector Security MODELS

Electric Power Steering (EPS) Module Connector Security MODELS

NUMBER: 19-001-17 GROUP: Steering DATE: April 26, 2017 This bulletin is supplied as technical information only and is not an authorization for repair. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise, without written permission of FCA US LLC. SUBJECT: Electric Power Steering (EPS) Module Connector Security MODELS: 2015 - 2017 (LA) Dodge Challenger 2015 - 2017 (LD) Dodge Charger 2015 - 2017 (LX) Chrysler 300 2016 - 2017 (WD) Dodge Durango 2016 - 2017 (WK) Jeep Grand Cherokee 2017 (RU) Chrysler Pacifica 2014 - 2017 (KL) Jeep Cherokee 2015 - 2017 (UF) Chrysler 200 2012 - 2016 (PF) Dodge Dart NOTE: This bulletin applies to vehicles within the following markets/countries: NAFTA, APAC, EMEA and LATAM. NOTE: This bulletin applies to vehicles equipped with Electric Power Steering (Dual Wound Motor) (Sales Codes SBG) or Electric Power Steering (Sales Codes SBL). SYMPTOM/CONDITION: During EPS module electrical diagnosis and verification, DO NOT disconnect the (gray) EPS torque sensor connector on the EPS module. 19-001-17 -2- Fig. 1 LA LD and LX EPS Module Connector 1 - EPS Torque Sensor Connector Fig. 2 WD and WK EPS Module Connector 1 - EPS Torque Sensor Connector -3- 19-001-17 Fig. 3 RU EPS Module Connector 1 - EPS Torque Sensor Connector Fig. 4 KL UF and PF EPS Muodule Connector 1 - EPS Torque Sensor Connector 19-001-17 -4- DISCUSSION: If the torque sensor connector is disconnected, the following scenarios can take place: • If 1-2 ignition cycles occur while the torque sensor harness is disconnected: DTC C2217-00 will be Active in the EPS module. This code can be cleared. Proceed with applicable Diagnostic Procedures. • If 3 or more ignition cycles occur while the torque sensor harness is disconnected: DTC C15DB-00 will be Active. This code CAN NOT be cleared. The gear will need to be replaced. NOTE: Disconnecting the torque sensor harness while the EPS module is off the vehicle and not powered up will not generate any DTCs. Continue to follow all applicable Diagnostic Procedures. POLICY: Information Only.

View Full Text

Details

  • File Type
    pdf
  • Upload Time
    -
  • Content Languages
    English
  • Upload User
    Anonymous/Not logged-in
  • File Pages
    4 Page
  • File Size
    -

Download

Channel Download Status
Express Download Enable

Copyright

We respect the copyrights and intellectual property rights of all users. All uploaded documents are either original works of the uploader or authorized works of the rightful owners.

  • Not to be reproduced or distributed without explicit permission.
  • Not used for commercial purposes outside of approved use cases.
  • Not used to infringe on the rights of the original creators.
  • If you believe any content infringes your copyright, please contact us immediately.

Support

For help with questions, suggestions, or problems, please contact us