Heat Flux Sensors.Cdr

Heat Flux Sensors.Cdr

Heat Flux Sensor A heat flux sensor is a transducer that generates an electrical signal proporonal to the total heat rate applied to the surface of the sensor. The measured heat rate is divided by the surface area of the sensor to determine the heat flux. careful design, rugged quality construcon and versale mounng configuraons. Each transducer will provide a self- generated 10-millivolts (nominal) output at the design heat flux level. Heat Flux gauge absorb heat in a thin metallic circular foil and transfer the heat radially (parallel to the absorbing surface) to the heat sink welded around the periphery of the foil. The emf output is generated by a single differenal thermocouple between the foil center temperature and foil edge temperature. Technical Parameters Parameters Cooled Uncooled Heat Flux (maximum) 10, 30 W/cm² 10, 30 W/cm² Sensor Output Linear output, 10mv nominal at full range Linear output, 10mv nominal at full range Over Range 25% of Rated Heat Flux 25% of Rated Heat Flux Accuracy ±5% or Better ±5% or Better Repeatability 1% 1% Measurement Duration 60s for 10 W/cm² 60s for 10 W/cm² Sensor Differential Thermocouple Differential Thermocouple Dimension Diameter 25mm, Length 25mm Diameter 25mm, Length 25mm Mounting Flange Flange Standard Features Ÿ Linear Output Ÿ Output Proporonal to Heat Transfer Rate Ÿ Accurate, Rugged, Reliable Ÿ Convenient Mounng Ÿ Measure Total Heat Flux Ÿ Measure Radiant Heat Flux www.tempsens.com Heat Flux Sensor Standard configuraon of cooled/uncooled models Ÿ The sensor is provided with or without provision for water cooling of transducer body. Ÿ Basic uncool sensor nominal temperature will be 200°C. Ÿ Water cooled should be specified if cooled sensor expected to achieve above 400°F or 200°C. 42 Applicaons Ÿ Main applicaon is like in ground and flight aerospace tesng 5 25 Ÿ Fire tesng, flammability tesng Ÿ Heat transfer research Ÿ Material development and furnace 40 development Heat Flux Sensor Calibraon Method Ÿ It works on the principle of axial one-dimensional heat flow. Ÿ It measures the temperature difference across a thin, thermally insulang layer to determine the incident heat flux. Due to the axial flow of heat, the temperature distribuon across the sensing surface is uniform. Ÿ The maximum body temperature is limited to about 200°C when the sensor is not water-cooled. Ÿ All of the calibraons show a linear response of the sensor, with regression factors close to unity. Tempsens Instruments (I) Pvt. Ltd. B-188A, Road No.5, Email: [email protected] M.I.A., Udaipur - 313003 (Rajasthan) INDIA Ph. 91-294-3507700, Fax .91-294-3507731 .

View Full Text

Details

  • File Type
    pdf
  • Upload Time
    -
  • Content Languages
    English
  • Upload User
    Anonymous/Not logged-in
  • File Pages
    2 Page
  • File Size
    -

Download

Channel Download Status
Express Download Enable

Copyright

We respect the copyrights and intellectual property rights of all users. All uploaded documents are either original works of the uploader or authorized works of the rightful owners.

  • Not to be reproduced or distributed without explicit permission.
  • Not used for commercial purposes outside of approved use cases.
  • Not used to infringe on the rights of the original creators.
  • If you believe any content infringes your copyright, please contact us immediately.

Support

For help with questions, suggestions, or problems, please contact us