CAUTION: To prevent malfunction of the player Connections DVD PLAYER Warnings, Cautions and Others • Do not block the ventilation openings or holes. (If the • There are no user-serviceable parts inside. If XV-N420B ventilation openings or holes are blocked by a newspaper anything goes wrong, unplug the power cord and Before making connections: Connecting to a TV with component jacks Connecting to a stereo audio amplifier (receiver) or cloth, etc., the heat may not be able to get out.) consult your dealer. • Do not connect the AC power cord until all other connections have been made. • Do not place any naked flame sources, such as • Do not insert any metallic objects, such as wires, • Connect VIDEO OUT of the player directly to the video input of your TV. Connecting VIDEO OUT of the PB XV-N422S PB Y RIGHT lighted candles, on the apparatus. hairpins, coins, etc. into the player. player to a TV via a VCR/an integrated TV/Video system may cause a monitor problem. XIAL Y RIGHT • When discarding batteries, environmental problems • Do not block the vents. Blocking the vents may LEFT TREAM LEFT INSTRUCTIONS VIDEO PR must be considered and local rules or laws governing damage the player. Connecting to a TV with SCART connector VIDEO PR VIDEO OUT AUDIO OUT the disposal of these batteries must be followed strictly. To clean the cabinet L OUT VIDEO OUT AUDIO OUT To analog ® NOTE audio input To analog audio input • Do not expose this apparatus to rain, moisture, dripping • Use a soft cloth. Follow the relevant instructions on TV SCART cable The VIDEO jack, AV OUT terminal, and VIDEO or splashing and that no objects filled with liquids, such the use of chemically-coated cloths. (not supplied) component (Y,PB, PR) jacks cannot be Connecting to a digital audio device as vases, shall be placed on the apparatus. • Do not use benzene, thinner or other organic solvents IN used at the same time. Caution: Proper Ventilation and disinfectants. These may cause deformation or IN To enjoy high-quality surround sound, connect the To component DIGITAL OUT (COAXIAL) jack to a Dolby Digital or DTS To avoid risk of electric shock and fire and to protect discoloring. S-VIDEO video input decoder or an amplifier with a built-in decoder. GNT0060-004B[EK] from damage, locate the apparatus as follows: VIDEO Front: No obstrucitons and open spacing. PB EN 0105MOC-MW-SC Playable discs To switch the scanning mode between Progressive and COAXIAL Y RIGHT Sides: No obstrucitons in 3 cm from the sides. ©2005 Victor Company of Japan, Limited LEF T Interlace, press and hold VFP-I/P on the remote control Top: No obstrucitons in 5 cm from the top. PCM/STREAM LEFT • DVD VIDEO, Audio CD, Video CD, SVCD AUDIO Region code of DVD VIDEO for a few seconds. VIDEO PR Back: No obstrucitons in 15 cm from the back. RIGH DIGITAL OUT VIDEO OUT AUDIO OUT T This player can play back DVD VIDEO discs Bottom: No obstrucitons, place on the level surface. NOTES whose region code numbers include “2.” VIDEO • Connect to a TV with composite jacks and set To analog Spacing 15 cm or more audio input Examples of playable DVD VIDEO discs: • DVD-R/-RW written in the DVD VIDEO format [CONNECTIONS] to [VIDEO COMPONENT] before XV-N420B/XV-N422S • DivX files on DVD-R/-RW written in the UDF format AV OUT connecting with component jacks. (See 1 2 1 23 • CD-R/RW written in the SVCD, Video CD or Audio CD “CONNECTIONS” in “Initial settings.”) ALL 2 5 Front The player 2 3 4 4 56 format • Connect “Y” to “Y,”“PB” to “PB(CB),”“PR” to “PR(CR)” To digital audio input Wall or • CD-R/RW written in MP3/WMA/JPEG/DivX in correctly. The player’s region code is printed on the rear of obstructions accordance with the “ISO 9660” format • The VIDEO jack, AV OUT terminal, and component NOTES the player Stand height • Depending on the disc, no signal may be outputted Supported Digital audio formats: (Y,PB, PR) jacks cannot be used at the same time. Note of Color system format 5 cm or more from the DIGITAL OUT. Make an analog connection Linear PCM, MPEG Multichannel, Dolby Digital, DTS (Digital About the scanning mode indicator This player accommodates the PAL system, and Theater Systems)* in this case. also can play back discs recorded with NTSC [PICTURE SOURCE] of Source type of DVD VIDEO • Set [DIGITAL AUDIO OUTPUT] in the [AUDIO] CAUTION Floor NOTES Connecting to a TV with composite jacks the PICTURE menu Film source Video source preference display correctly according to the system. (NTSC video signals are converted to an To reduce the risk of electrical shocks, fire, etc.: • If a disc gets dirty, scratched or warped, or due to the Precautions TV NOTES AUTO [DDP] [P] connected digital audio equipment. (See “DIGITAL PAL signal and output.) 1. Do not remove screws, covers or cabinet. disc characteristics or recording conditions, the Notes on the power cord • If your TV has a monaural audio input FILM [DDP] [DDP] AUDIO OUTPUT” in “Initial settings.”) 2. Do not expose this appliance to rain or moisture. player may not be able to play back such discs. Supplied accessories • When you are away on travel or otherwise for an extended IN instead of stereo, use an optional VIDEO(NORMAL)/ • The player can play back audio signals recorded in [P] [P] If anything is missing, consult your dealer period of time, remove the plug from the wall outlet. A audio cable which converts stereo (ACTIVE) Caution –– STANDBY/ON button! MIX-MODE CD, CD-G, CD-EXTRA and CD TEXT. VIDEO immediately. small amount of power (1.0 W) is always consumed while audio output to monaural. NOTE • Remote control (x 1) Disconnect the mains plug to shut the power off • With some discs, operations may not be possible. the power cord is connected to the wall outlet. LEF • The VIDEO jack, AV OUT terminal, and Some progressive TV and High-Definition TV sets are * To play back DTS-encoded DVD VIDEO or DTS- T • R6(SUM-3)/AA(15F) battery (x 2) completely. The STANDBY/ON button in any AU • When unplugging the player from the wall outlet, DIO component (Y,PB, PR) jacks cannot be not fully compatible with the player. To check the position does not disconnect the mains line. The power encoded Audio CD discs correctly, connect the RIG always pull the plug, not the power cord. HT used at the same time. compatibility of your TV, contact your local JVC player to an amplifier with a built-in DTS decoder. can be remote controlled. • Do not handle the power cord with wet hands! customer service center. Otherwise, playback sound will be distorted. • Disconnect the power cord before cleaning the IMPORTANT FOR LASER PRODUCTS player or moving the player. Unplayable discs 1. CLASS 1 LASER PRODUCT • Do not alter, twist or pull the power cord, or put If you try to play back discs listed below, noise may be COAXIAL 2. CAUTION: Do not open the top cover. There are no anything heavy on it, which may cause fire, electric generated and causes damage to speakers. P Y R user serviceable parts inside the unit; leave all • DVD-RW written in the VR format PCM/STREAM shock, or other accidents. Yellow servicing to qualified service personnel. DIGITAL RIGHT • If the cord is damaged, consult a dealer and have the • DVD-ROM, DVD-RAM, DVD AUDIO, CD-ROM, OUT VIDEO P LEFT 3. CAUTION: Visible and invisible laser radiation when B VID power cord replaced with a new one. PHOTO CD, SACD Audio/video cable EO OUT open and interlock failed or defeated. Avoid direct Avoid moisture, water, dust, and high temperatures • Unfinalized discs (not supplied) AUDIO OUT The player exposure to beam. • Do not place the player in moist or dusty places. • Discs of irregular shape or discs with tape, seals or 4. REPRODUCTION OF LABEL: CAUTION LABEL, paste on either the label side or playback side. • If water gets inside the player, turn off the power and White PLACED INSIDE THE UNIT. remove the plug from the wall outlet, then consult Playing back these discs may damage the player. your dealer. Using the player in this state may cause Red a fire or electrical shock. The Non-DVD side of a “DualDisc” does not comply with • Do not expose the player to direct sunlight or place it the “Compact Disc Digital Audio” standard. near a heating device. Therefore, the use of Non-DVD side of a DualDisc on Notes on installation this product may not be recommended. • Select a place which is level, dry and neither too hot nor too cold between 5˚C and 35˚C. •Leave sufficient distance between the player and the TV. • Do not install the player in a place subject to vibrations. • Do not put heavy objects on the player. 1 2 3 4 Turning on the power Initial setup Basic Operations Advanced Operations When you turn on the player for the first time after Changing the language, sound Inserting the AC power plug purchase, the following message appears on the TV Turning on and off the player Changing the display window Changing the picture tone (VFP) and scene angle After all other connections have been made, insert the screen. Insert a disc contents The VFP (Video Fine Processor) STANDBY/ON AC power plug to the wall outlet firmly. OPEN/ Open/close the disc tray Each time you press DISPLAY, 1 Press the button.