Pli-Dek Flash Coat 2.0 - PDFC2 ICP Building Solutions Group Version No: 1.4 Issue Date: 10/13/2020 Safety Data Sheet according to OSHA HazCom Standard (2012) requirements Print Date: 10/13/2020 S.GHS.USA.EN SECTION 1 Identification Product Identifier Product name Pli-Dek Flash Coat 2.0 - PDFC2 Synonyms Not Available Other means of identification Not Available Recommended use of the chemical and restrictions on use Relevant identified uses Flash Coat Name, address, and telephone number of the chemical manufacturer, importer, or other responsible party Registered company name ICP Building Solutions Group Address 956 S US Highway 41 Inverness FL Not applicable Telephone 352-344-8741 Fax Not Available Website www.icpgroup.com Email Not Available Emergency phone number Association / Organisation Chemtel Emergency telephone 800-255-3924 numbers Other emergency telephone 813-24800588 numbers SECTION 2 Hazard(s) identification Classification of the substance or mixture Note: The hazard category numbers found in GHS classification in section 2 of this SDSs are NOT to be used to fill in the NFPA 704 diamond. Blue = Health Red = Fire Yellow = Reactivity White = Special (Oxidizer or water reactive substances) Eye Irritation Category 2A, Acute Aquatic Hazard Category 3, Carcinogenicity Category 1A, Reproductive Toxicity Category 1B, Chronic Aquatic Classification Hazard Category 3 Label elements Hazard pictogram(s) Signal word Danger Hazard statement(s) H319 Causes serious eye irritation. H350 May cause cancer. H360 May damage fertility or the unborn child. H412 Harmful to aquatic life with long lasting effects. Page 1 continued... Version No: 1.4 Page 2 of 15 Issue Date: 10/13/2020 Print Date: 10/13/2020 Pli-Dek Flash Coat 2.0 - PDFC2 Hazard(s) not otherwise classified Not Applicable Precautionary statement(s) General P101 If medical advice is needed, have product container or label at hand. P102 Keep out of reach of children. Precautionary statement(s) Prevention P201 Do not handle until all safety precautions have been read and understood. P281 Use personal protective equipment as required. Precautionary statement(s) Response P308+P313 IF exposed or concerned: Get medical advice/attention. P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Precautionary statement(s) Storage P405 Store locked up. Precautionary statement(s) Disposal P501 Dispose of contents/container to authorised hazardous or special waste collection point in accordance with any local regulation. SECTION 3 Composition / information on ingredients Substances See section below for composition of Mixtures Mixtures CAS No %[weight] Name 84-74-2 <1 dibutyl phthalate 25265-77-4 1-5 2,2,4-trimethyl-1,3-pentanediol monoisobutyrate 1317-80-2 1-5 titanium dioxide (rutile) 7632-00-0 <1 sodium nitrite 64-17-5 1-5 ethanol 67-56-1 <1 methanol 1313-27-5 <1 molybdenum(VI) oxide 14807-96-6 5-10 talc The specific chemical identity and/or exact percentage (concentration) of composition has been withheld as a trade secret. SECTION 4 First-aid measures Description of first aid measures If this product comes in contact with the eyes: Immediately hold eyelids apart and flush the eye continuously with running water. Ensure complete irrigation of the eye by keeping eyelids apart and away from eye and moving the eyelids by occasionally lifting the upper Eye Contact and lower lids. Continue flushing until advised to stop by the Poisons Information Centre or a doctor, or for at least 15 minutes. Transport to hospital or doctor without delay. Removal of contact lenses after an eye injury should only be undertaken by skilled personnel. If skin contact occurs: Immediately remove all contaminated clothing, including footwear. Flush skin and hair with running water (and soap if available). Seek medical attention in event of irritation. For thermal burns: Decontaminate area around burn. Consider the use of cold packs and topical antibiotics. For first-degree burns (affecting top layer of skin) Hold burned skin under cool (not cold) running water or immerse in cool water until pain subsides. Use compresses if running water is not available. Skin Contact Cover with sterile non-adhesive bandage or clean cloth. Do NOT apply butter or ointments; this may cause infection. Give over-the counter pain relievers if pain increases or swelling, redness, fever occur. For second-degree burns (affecting top two layers of skin) Cool the burn by immerse in cold running water for 10-15 minutes. Use compresses if running water is not available. Do NOT apply ice as this may lower body temperature and cause further damage. Do NOT break blisters or apply butter or ointments; this may cause infection. Protect burn by cover loosely with sterile, nonstick bandage and secure in place with gauze or tape. To prevent shock: (unless the person has a head, neck, or leg injury, or it would cause discomfort): Lay the person flat. Continued... Version No: 1.4 Page 3 of 15 Issue Date: 10/13/2020 Print Date: 10/13/2020 Pli-Dek Flash Coat 2.0 - PDFC2 Elevate feet about 12 inches. Elevate burn area above heart level, if possible. Cover the person with coat or blanket. Seek medical assistance. For third-degree burns Seek immediate medical or emergency assistance. In the mean time: Protect burn area cover loosely with sterile, nonstick bandage or, for large areas, a sheet or other material that will not leave lint in wound. Separate burned toes and fingers with dry, sterile dressings. Do not soak burn in water or apply ointments or butter; this may cause infection. To prevent shock see above. For an airway burn, do not place pillow under the person's head when the person is lying down. This can close the airway. Have a person with a facial burn sit up. Check pulse and breathing to monitor for shock until emergency help arrives. If fumes or combustion products are inhaled remove from contaminated area. Lay patient down. Keep warm and rested. Prostheses such as false teeth, which may block airway, should be removed, where possible, prior to initiating first aid procedures. Inhalation Apply artificial respiration if not breathing, preferably with a demand valve resuscitator, bag-valve mask device, or pocket mask as trained. Perform CPR if necessary. Transport to hospital, or doctor, without delay. Immediately give a glass of water. Ingestion First aid is not generally required. If in doubt, contact a Poisons Information Centre or a doctor. Most important symptoms and effects, both acute and delayed See Section 11 Indication of any immediate medical attention and special treatment needed Treat symptomatically. For acute and short term repeated exposures to methanol: Toxicity results from accumulation of formaldehyde/formic acid. Clinical signs are usually limited to CNS, eyes and GI tract Severe metabolic acidosis may produce dyspnea and profound systemic effects which may become intractable. All symptomatic patients should have arterial pH measured. Evaluate airway, breathing and circulation. Stabilise obtunded patients by giving naloxone, glucose and thiamine. Decontaminate with Ipecac or lavage for patients presenting 2 hours post-ingestion. Charcoal does not absorb well; the usefulness of cathartic is not established. Forced diuresis is not effective; haemodialysis is recommended where peak methanol levels exceed 50 mg/dL (this correlates with serum bicarbonate levels below 18 meq/L). Ethanol, maintained at levels between 100 and 150 mg/dL, inhibits formation of toxic metabolites and may be indicated when peak methanol levels exceed 20 mg/dL. An intravenous solution of ethanol in D5W is optimal. Folate, as leucovorin, may increase the oxidative removal of formic acid. 4-methylpyrazole may be an effective adjunct in the treatment. 8.Phenytoin may be preferable to diazepam for controlling seizure. [Ellenhorn Barceloux: Medical Toxicology] BIOLOGICAL EXPOSURE INDEX - BEI Determinant Index Sampling Time Comment 1. Methanol in urine 15 mg/l End of shift B, NS 2. Formic acid in urine 80 mg/gm creatinine Before the shift at end of workweek B, NS B: Background levels occur in specimens collected from subjects NOT exposed. NS: Non-specific determinant - observed following exposure to other materials. for irritant gas exposures: the presence of the agent when it is inhaled is evanescent (of short duration) and therefore, cannot be washed away or otherwise removed arterial blood gases are of primary importance to aid in determination of the extent of damage. Never discharge a patient significantly exposed to an irritant gas without obtaining an arterial blood sample. supportive measures include suctioning (intubation may be required), volume cycle ventilator support (positive and expiratory pressure (PEEP), steroids and antibiotics, after a culture is taken If the eyes are involved, an ophthalmologic consultation is recommended Occupational Medicine: Third Edition; Zenz, Dickerson, Horvath 1994 Pub: Mosby For acute or short term repeated exposures to ammonia and its solutions: Mild to moderate inhalation exposures produce headache, cough, bronchospasm, nausea, vomiting, pharyngeal and retrosternal pain and conjunctivitis. Severe inhalation produces laryngospasm, signs of upper airway obstruction (stridor, hoarseness, difficulty in speaking) and, in excessively, high doses, pulmonary oedema. Warm humidified air may soothe bronchial irritation. Test all patients with conjunctival irritation for corneal abrasion (fluorescein stain, slit lamp exam) Dyspneic patients should receive a chest X-ray and arterial blood gases to detect pulmonary oedema. SECTION 5 Fire-fighting measures Extinguishing media There is no restriction on the type of extinguisher which may be used. Use extinguishing media suitable for surrounding area. Special hazards arising from the substrate or mixture Fire Incompatibility Avoid contamination with oxidising agents i.e. nitrates, oxidising acids, chlorine bleaches, pool chlorine etc. as ignition may result Special protective equipment and precautions for fire-fighters Alert Fire Brigade and tell them location and nature of hazard. Fire Fighting Wear breathing apparatus plus protective gloves in the event of a fire.