Effects of Welding on Health IV Effects of Welding on Health IV An up-dated (December 1980-June 1982) literature survey and evaluation of the data recorded since the publication of the first report, to understand and improve the occupational health of welding personnel. By Winifred G. Palmer Submitted by: Tracor Jitco 1776 E. Jefferson Street Rockville, MD 20852 Submitted to: SAFETY AND HEALTH COMMITTEE AMERICAN WELDING SOCIETY 550 N.W. LeJeune Road Miami, FL 33126 International Standard Book Number: 0-87171-230-X American Welding Society, 550 LeJeune Road, Miami, FL 33126 ©1983 by American Welding Society. All rights reserved. This report is published as a service and convenience to the welding industry and is the product of an independent contractor (Tracor Jitco) which is solely responsible for its contents. The materials in this report have not been independently reviewed or verified and are only offered as information. AWS assumes no responsibility for any claims that may arise from the use of this information. Users must make independent investigations to determine the applicability of this information for their purposes. Printed in the United States of America Contents Personnel v Acknowledgements vii Preface ix Introduction xi Executive Summary xiii Technical Summary xv /. The Exposure 1 1.1 Fumes 1 1.2 Gases 5 1.3 Protective Coatings 7 1.4 Electromagnetic Radiation 9 1.5 Noise 10 2. Effects of Welding on Human Health 11 2.1 Respiratory Tract 11 2.2 Cancer 15 2.3 Effects on the Ear and Hearing 19 2.4 Effects on the Eye and Vision 19 2.5 Effects on the Skin 20 2.6 Effects on the Cardiovascular System 21 2.7 Effects on the Nervous System 21 2.8 Effects on the Liver 22 2.9 Effects on the Musculoskeletal System 22 2.10 Effects on the Urogenital Tract 23 2.11 Effects on the Teeth and Oral Cavity 23 2.12 Metal Fume Fever 23 2.13 Sensitivity to Fume Components 23 2.14 Biochemical Changes 24 2.15 Human Fatality 25 2.16 Occupational Medicine 25 3. Toxicologic Investigations in Animals and in Cell Cultures 25 3.1 Animal Studies 25 3.2 In Vitro Studies 29 References 31 Bibliography 37 III Personnel The author of the report by Tracor Jitco was: Winifred G. Palmer AWS Research Committee A.N. Ward, Chairman Caterpillar Tractor Company K.L. Brown, Vice Chairman Lincoln Electric Company M.E. Kennebeck, Jr., Secretary American Welding Society J.S. Gorski Kemper Insurance Companies E. Mastromatteo INCO Limited Acknowledgements The American Welding Society gratefully acknowledges the time and effort expended by the members of the Research Committee and the financial support of the program by industry contributions. Supporting Organizations Air Products and Chemicals, Inc. Airco Welding Products Allis-Chalmers Alloy Rods Division, The Chemetron Corporation AWS Detroit Section AWS New Orleans Section Arcos Corporation The Binkley Company Caterpillar Tractor Company Chicago Bridge and Iron Company Grove Manufacturing Company, Division of Kidde, Inc. General Electric Company The Heil Company Hobart Brothers Company Huntington Alloys, Inc. Lincoln Electric Company Miller Electric Manufacturing Company National-Standard Company A.O. Smith Corporation Teledyne-McKay, Inc. Trinity Industries, Inc. Truck Trailer Manufacturers Association Walker Stainless Equipment Company Weld Tooling Corporation Many other organizations have made contributions to support the ongoing program from May 1979 to the present. VII Preface This literature review has been prepared for the Safety and Health Committee of the American Welding Society to provide an assessment of current knowledge of the effects of welding on health, as well as to aid in the formulation of research projects in this area, as part of an ongoing program sponsored by the Society. Previous work has included studies of the fumes, gases, radiation, and noise generated during various forms of arc welding (see Bibliography). Conclusions based on this review and rec- comendations for further research are presented in the introductory portions of the report. Section 1 summarizes recent studies of the occupational exposures. Section 2 contains information related to the human health effects of exposure to byproducts of welding operations. Section 3 discusses studies of the effects of welding emissions on laboratory animals and in vitro cell systems. Referenced materials are available from Tracor Jitco, Inc. IX Introduction The health of workers in the welding environment is decreased fume exposures reduce the rate of degenera- a major concern of the American Welding Society. To tion of this hazardous gas. Much recent research has stay abreast of this subject, the health literature is focused on chromium and nickel, since exposure to periodically reviewed and published in the report certain chemical forms of these metals may cause Effects of Welding on Health. Three volumes have serious chronic health problems. been published to date (Refs. 135, 143, and 144); the In keeping with previous volumes, the health studies first covered data published prior to 1978, while the are organized according to the organ system affected. latter two covered the periods 1978 to May, 1979 and The respiratory tract, the primary route of entry of June, 1979 to December 1980, respectively. The welding fumes and gases into the body, also is a major current report included information that was pub- target organ of a number of components of these lished between December, 1980 and June, 1982, and emissions. Acute (e.g., metal fume fever, cadmium should be read in conjunction with the previous poisoning) as well as potential chronic respiratory volumes for a comprehensive treatment of the litera- effects (e.g., emphysema, cancer) of welding emissions ture on the Effects of Welding on Health. are of concern. The latter are far less well understood Included in this volume are studies of the charac- and whether or not there is an excess risk of cancer teristics of welding emissions that may have impact from these exposures has not been established. Con- on the control technologies necessary to protect the tinued research in the form of epidemiologic studies, welding worker (Section 1). Considerable discussion investigations with laboratory animals, and in vitro is devoted to ozone which may become a greater genotoxicity studies will help to resolve this question. problem to welders as improved ventilation and XI Executive Summary A problem inherent in research concerning the magnetopneumography enables rough estimates to be health effects of welding is that there is a great deal of made of the quantities of metals retained in the lungs. variability in both welding processes and in working However, the association between this retention of conditions which makes it difficult to perform studies metals and impaired lung function is not clear. For on homogeneous populations of sufficient size to this reason, it is important to develop more accurate permit statistical analysis. These variations may be less methods for the determination of lung function. Of the critical when examining causes of acute physiological six studies using pulmonary function tests of welders responses to welding exposures (e.g., metal fume fever, which appeared during this report period, three burns, photokeratitis). However, the association indicated impaired lung function among welders, and between chronic exposures to welding emissions and three reported no differences between welders and disease conditions whose causes are less well under- controls. stood, or which occur at a low incidence, remains Four epidemiologic studies of the lung cancer ambiguous in many cases. incidence among welders have appeared in the recent literature. Two of these indicated an elevated lung The Respiratory Tract cancer risk. One of these two studies focused on Of the five metals (Cr, Ni, As, Be, and Cd) that have welders of stainless steel, but the size of the study been shown by epidemiologic studies to be related to cohort was too small for the results to be considered an increased cancer incidence in workers in certain conclusive. The second was a death record study of industries, chromium and nickel are present in signifi- welders selected from the rosters of a trade union in cant quantities in fumes released during welding Seattle, Washington. A significant increase certain metals (e.g., stainless steel and nickel alloys). (SMR*=174) in the lung cancer rate was found when However, only some chemical compounds containing deaths that occurred more than 20 years from the these metals are carcinogenic, and it is not known if initial date of exposure were considered. A study of these compounds are present in welding fumes. The welders exposed to nickel-rich welding fumes did not available epidemiologic evidence is insufficient to indicate an elevated lung cancer risk; however, the determine whether or not welders are at an increased investigator emphasized the need for a follow-up study risk of developing lung cancer from exposure to of this cohort to allow more time for the appearance chromium and nickel in welding fumes. of tumors. There is a great need for further well- Most of the reports of the effects of welding on planned epidemiologic studies of welders. Because of health which appeared during the period of this review the high cost of these studies and the limited resources dealt with effects of welding on the respiratory tract. available to the welding community, Stern suggested Metal deposits have frequently been found in welders' lungs by chest X-rays and at autopsy. The use of •Standardized mortality ratio XIII that such studies focus on exposure to welding technologies. In conjunction with devices that collect processes in which it is suspected that genotoxic or personal air samples for determining the welder's carcinogenic materials, such as nickel and chromium actual exposure, biological monitoring affords a compounds, are released (Ref. 122). means for estimating the actual dose of contaminants taken up by the body.
Details
-
File Typepdf
-
Upload Time-
-
Content LanguagesEnglish
-
Upload UserAnonymous/Not logged-in
-
File Pages60 Page
-
File Size-