Welcome to the world of Hytera and thank you for purchasing this product. This manual includes a description of the functions and step-by-step procedures for use. It also includes a troubleshooting guide. To avoid bodily injury or property loss caused by incorrect operation, please carefully read the Safety Information Booklet before use. This manual is applicable to the following product: PD562i Digital Portable Radio Copyright Information copied, modified, translated, or distributed in any manner without the prior written consent of the Company. Hytera is the trademark or registered trademark of Hytera Communications Corporation Limited (the Company) in the People's Republic of China (PRC) We do not guarantee, for any particular purpose, the accuracy, validity, and/or other countries or areas. The Company retains the ownership of its timeliness, legitimacy or completeness of the third-party products and trademarks and product names. All other trademarks and/or product names contents involved in this manual. that may be used in this manual are properties of their respective owners. If you have any suggestions or would like to receive more information, The product described in this manual may include the Company's computer please visit our website at: http://www.hytera.com. programs stored in memory or other media. Laws in PRC and/or other countries or areas protect the exclusive rights of the Company with respect FCC Statement to its computer programs. The purchase of this product shall not be deemed This equipment has been tested and found to comply with the limits for a to grant, either directly or by implication, any rights to the purchaser Class B digital device, pursuant to part 15 of FCC Rules. These limits are regarding the Company's computer programs. The Company's computer designed to provide reasonable protection against harmful interference in a programs may not be copied, modified, distributed, decompiled, or reverse- residential installation. This equipment generates and can radiate radio engineered in any manner without the prior written consent of the Company. frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. Disclaimer However, there is no guarantee that interference will not occur in a The Company endeavors to achieve the accuracy and completeness of this particular installation. Verification of harmful interference by this manual, but no warranty of accuracy or reliability is given. All the equipment to radio or television reception can be determined by turning it specifications and designs are subject to change without notice due to off and then on. The user is encouraged to try to correct the interference by continuous technological development. No part of this manual may be one or more of the following measures: 2 l Reorient or relocate the receiving antenna. Increase the separation l Institute of Electrical and Electronic Engineers (IEEE) C95.1:2005 between the equipment and receiver. Edition l Connect the equipment into an outlet on a different circuit to that of the receiver's outlet. RF Exposure Compliance and Control l Consult the dealer or an experienced radio/TV technician for help. Guidelines and Operating Instructions Operation is subject to the following two conditions: To control your exposure and ensure compliance with the occupational/controlled environmental exposure limits, always adhere to the l This device may not cause harmful interference. following procedures. l This device must accept any interference received, including interference that may cause undesired operation. Guidelines: Note: Changes or modifications to this unit not expressly approved by the l Do not remove the RF Exposure Label from the device. party responsible for compliance could void the user's authority to operate l User awareness instructions should accompany device when the equipment. transferred to other users. l Do not use this device if the operational requirements described herein Compliance with RF Exposure Standards are not met. Hytera's radio complies with the following RF energy exposure standards Operating Instructions: and guidelines: l Transmit no more than the rated duty factor of 50% of the time. To l United States Federal Communications Commission, Code of Federal transmit (talk), press the Push-To-Talk (PTT) key. To receive calls, Regulations; 47 CFR § 1.1307, 1.1310 and 2.1093 release the PTT key. Transmitting 50% of the time, or less, is important l American National Standards Institute (ANSI) / Institute of Electrical because the radio generates measurable RF energy only when and Electronic Engineers (IEEE) C95. 1:2005; Canada RSS102 Issue 5 transmitting (in terms of measuring for standards compliance). March 2015 3 l Keep the radio unit at least 2.5 cm away from the face. Keeping the l This device must accept any interference received, including radio at the proper distance is important as RF exposure decreases with interference that may cause undesired operation. distance from the antenna. The antenna should be kept away from the Le présent appareil est conforme aux CNR d'Industrie Canada applicables face and eyes. aux appareils radio exempts de licence. L'exploitation est autorisée aux l When worn on the body, always place the radio in a Hytera-approved deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, holder, holster, case, or body harness or by use of the correct clip for et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique this product. Use of non-approved accessories may result in exposure subi, même si le brouillage est susceptible d'en compromettre le levels which exceed the FCC's occupational/controlled environmental fonctionnement RF exposure limits. l Use of non-approved antennas, batteries, and accessories causes the EU Regulatory Conformance radio to exceed the FCC RF exposure guidelines. As certified by the qualified laboratory, the product is in compliance with l Contact your local dealer for the product's optional accessories. the essential requirements and other relevant provisions of the following IC Statement directives: 1999/5/EC or 2014/53/EU, 2006/66/EC, 2011/65/EU, and 2012/19/EU. The device has been tested and complies with SAR limits, users can obtain Canadian information on RF exposure and compliance. Please note that the above information is applicable to EU countries only. Après examen de ce matériel aux conformité aux limites DAS et/ou aux limites d’intensité de champ RF, les utilisateurs peuvent sur l’exposition aux radiofréquences et la conformité and compliance d’acquérir les informations correspondantes This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: l This device may not cause harmful interference. 4 Contents Selecting a Zone and Channel Contents Documentation Conventions 3 Selecting a Zone and Channel 9 Packing List Documentation Conventions4 Status Indications 10 Product Overview 5 LCD Icons 10 Product Controls 5 LED Indications 11 Programmable Keys 6 Call Services 11 Before Use 6 Call on Digital Channel 11 Charging the Battery 6 Call on Analog Channel 12 Attaching the Battery 7 Message Services 12 Attaching the Antenna 7 Viewing a Message 12 Attaching the Belt Clip 7 Sending a Message 13 Attaching the Audio Accessories 7 Deleting a Message 13 Basic Operations 8 Supplementary Features 14 Turning on or off the Radio 8 Basic Settings 14 Adjusting the Volume 8 Contact Management 15 Checking the Battery Power 9 Audio Optimization 15 Locking or Unlocking Keys and Knobs 9 One Touch Call 16 18 Scan 17 Roam 18 1 9 1 16 TalkScan Around 1817 TOTRoam 18 TalkVOX Around 18 1 TOTControl Services 18 VOXAnalog Services 1819 ControlPersonal Services Safety Services 1820 AnalogCommunication Services Security Services 1921 TroubleshootingPersonal Safety Services 2022 CareCommunication and Cleaning Security Services 2124 TroubleshootingProduct Care 2224 CareProduct and Cleaning Cleaning 24 OptionalProduct Accessories Care 24 AbbreviationsProduct Cleaning 24 Optional Accessories 24 Abbreviations 24 2 2 Documentation Conventions Item Description Example The screen displays "Invalid Icon Conventions Denotes messages, Battery!". Icon Description directories, file names, " " Open "PDT_PSS.exe". Indicates references that can further describe the related folder names, and Go to "D:/opt/local". topics. parameter values. In the Port text box, enter "22". Indicates situations that could cause data loss or equipment Directs you to access a damage. > Go to File > New. multi-level menu. Notation Conventions For details about using the DWS, Italic Denotes document titles. refer to Dispatch Workstation User Item Description Example Guide. To save the configuration, click To set the IP address, run the Denotes menus, tabs, Apply. Courier Denotes commands and following command: parameter names, window New their execution results. Boldface The Log Level Settings dialogue vos-cmd - m name IP names, dialogue names, and appears. hardware buttons. Press the PTT key. 3 Packing List Please unpack carefully and check that all items listed below are received. If any item is missing or damaged, please contact your dealer. Item Quantity (PCS) Item Quantity (PCS) Radio 1 Antenna 1 Battery 1 Belt Clip 1 Charger 1 Strap 1 Power Adapter 1 Documentation Kit 1 Check whether the frequency band marked on the antenna label matches that on the radio label. If not, please contact your dealer. 4 Product Overview Product Controls 5 Programmable Keys To determine the charging status, check the light-emitting diode (LED) You can request your dealer to program your radio to use the following indicator on the charger according to the following table: keys as shortcuts to radio features: SK1, P1 key, P2 key, P3 key, P4 key, LED Indicator Charging Status and P5 key. The battery fails to make proper contact with the Please consult your dealer for assignable radio features. Flashes red slowly charger. Glows red The battery is charging. Before Use Glows orange The battery is charged to 90% or above.