Carpentry/Cabinetmaking Tool List Hays Campus 2021-2022 Following are the required tools for the Carpentry/Cabinetmaking program. These tools can be purchased from the vendor of your choice. All tools are to be of the finest quality. Tools will be inspected prior to being used in the department. Any tools on the list may be supplemented for another if quality is equivalent. The department reserves the right to refuse the use of worn or defective tools or tools which do not conform to the specifications of this list and the department chairperson. Required Tools and Equipment Qty Item Brand Parts No. 1 Super Bar (Flat Bar) Vaughan B215 1 Needle nose pliers 1 Speed Square - Swenson - 7” 50101 or 39468 Swenson 50101 OR 39468 1 Stair Gage Clips - Johnson No. 405 Johnson 405 1 Framing Hammer Estwing 22oz, or comparable 1 Claw Hammer Estwing 14oz or 16oz finish hammer, or comparable 1 Set Spade Bits (Set of 6) Irwin No. 886R 1 Wood Chisels 1/2', 3/4', 1', & 1/4', 3/8', 1 1/2' - Great Neck Saw Mfg. Co Great Neck Saw Mfg Co 0251060K (6 piece set) 0251060K 1 Nail Apron or tool bag and belt Nicholas, or better 823 1 Framing Square - Stanley No. 302-3595 Stanley 1 Utility Knife - Stanley 10-309 Stanley 1 1/4" impact driver w/cordless drill, combo Makita, DeWalt, Milwaukee, Ridig, or Revised 2-19-21 comparable 1 Chalk Line Stanley ST 47-051 1 Tape - 25 ft. Stanley 33-525 1 Set Nail Set (Set of 3) - 1/16, 1/32, 3/32 Stanley 23771 1 Drill and drive set bit set 1 Safety Glasses Klein, or comparable 60050 1 Carpenter's Tool Box or Toolbox on wheels - Metal with tray-at least 30-32" long 1 Hard Hat 1 Nail puller (aka Cat’s paw bar) Screw Drivers 1 Standard Klein, or comparable 600-1 1 Standard Klein 600-4 1 Standard Klein 601-3 1 Phillips Klein 603-1 1 Phillips Klein 603-3 1 Phillips Klein 603-4 Estimated Cost: $766.00 Note: Estimated costs reflect current market value and are subject to change. Vendor Information: Tools may be purchased at Heartland Building Center, Ace Hardware, Home Depot or qualified center of student choice. Please contact the Department Chair with questions or for further information. Revised 2-19-21.