Operator’s Manual Model: P0820B Reproduction for Not Important! It is essential that you read the instructions in this manual before operating this machine. Reproduction for Not 1 3 2 4 ReproductionFig. 1 for 5 Not 6 Fig. 2 Fig. 3 English (original instructions) SAFETY INFORMATION Indicates a potentially READ ALL INSTRUCTIONS CAREFULLY hazardous situation, WARNING WARNING which, if not To avoid serious personal injury, do not avoided, could attempt to use this product until you have result in death read this Owner’s Manual thoroughly and or serious understand it completely. If you do not injury. understand the warnings and instructions Indicates a in this Owner’s Manual, do not use this potentially product. Contact an authorized service hazardous center for assistance. situation, CAUTION which, if not WARNING avoided, may For use only with Briggs & Stratton result in minor batteries BSB2AH82 (2 amp-hour) or or moderate BSB4AH82 (4 amp-hour) or BSB5AH82 (5 injury. amp-hour) and Briggs & Stratton charger Indicates a BSRC82 or BSSC82. situation that may result in Battery-operated products do not have NOTICE damage to the to be plugged into an electrical outlet; product. therefore, they are always in operating condition. Be aware of possible hazards Some of the following symbols may be used when not using the powerhead. FollowingReproduction on this product. Please study them and this rule will reduce the risk of electric learn their meaning. Proper interpretation shock, fire, or serious personal injury. of these symbols will allow you to operate The following signal words and meanings the product better and safer. are intended to explain forthe levels of risk SYM- DESIGNATION/ associated with this product. BOL EXPLANATION SYMBOL SIGNAL MEANING V Voltage Indicates an A Current imminently Not Hz Frequency (cycles per second) hazardous situation, W Power DANGER which, if not Type of current avoided, will result in death Direct current or serious Double-insulated construction injury. 1 English (original instructions) Precautions that involve your TO START THE POWERHEAD safety. See Figure 2 Do not expose to rain or use in WARNING damp locations. Do not attempt to override the operation To reduce the risk of injury user of the safety lock-out button or bail lever. must read and understand operator’s manual before using ■ Press and hold the safety lock-out button. this product. ■ Pull the bail lever upward to the handle Beware of electric shock hazard. to start the powerhead and then release the button. SOFT-START SPECIFICATIONS This lithium-ion powerhead is equipped with a “soft-start” feature. When initially Powerhead P0820B starting up, the mower will take approx. 3 Battery 82V* Lithium Ion seconds to get up to full speed. Unit weight 13 lbs (6 kg) TO STOP THE POWERHEAD Disclaimer: *Maximum initial battery ■ Release the bail lever to stop the voltage (measured without a workload) is powerhead. 82 volts.Nominal voltage is 72. ■ Open the battery door. ■ Remove the safety key. OPERATION Reproduction■ Press the battery release button. This STARTING/STOPPING THE POWERHEAD will cause the battery to raise out of the TO INSTALL BATTERY battery port slightly. See Figure 1 ■ Remove battery. ■ Lift and hold up the batteryfor door. BATTERY & CHARGER ■ Place the battery in the powerhead. Align ribs on battery with grooves in the CHARGING PROCEDURE battery port. The battery is not shipped fully charged. ■ Make sure the battery release button It is recommended to fully charge before snaps inNot place and that battery is fully first use to ensure that maximum run time seated and secure in the powerhead can be achieved. This lithium-ion battery before beginning operation. will not develop a memory and may be ■ Insert the safety key. charged at any time. ■ Close the door. If the battery has been stored with little to no charge for a long period of time, the charger will go into recovery mode, which will take 20 hrs to fully charge the battery. 2 English (original instructions) This will enhance the life of the battery. and illuminate RED. If this occurs allow the Once it is fully charged, the next charge will battery to cool inside of the charger for up to return to standard charging. 30 minutes. Charging should automatically For best results, the battery should be start once battery has cooled. charged in a location with a temperature between 6°C and 40°C. STORAGE 1. Plug the charger into an AC power ■ Remove the battery and store it in a outlet. cool dry location, if possible. Charge the battery every two months when not in 2. Insert the battery into the charger. use in order to increase its life. 3. When the battery is fully charged, ■ Remove the battery and store in a secure unplug the charger and remove the location out of the reach of children. battery. This is a diagnostic charger. The Charger For battery storage longer than 30 days: LED Lights (See Figure 3) will illuminate in ■ Store the battery where the temperature specific order to communicate the current is below 80°F and away from moisture. battery status. They are as follows: ■ Store battery in a 30%-50% charged Make sure the battery is fully inserted into condition. the charger before charging. ■ Every two months of storage, charge the The battery will become slightly warm to battery as normal. the touch while charging. This is normal and does not indicate a problem. WARNING To reduce the risk of electric shock, CHARGING FAULT fire, or serious personal injury, always remove the battery when servicing or When the battery is inserted intoReproduction the transporting the powerhead. charger and the status LED blinks RED, remove the battery from the charger for SERVICE 1 minute, then reinsert. If the status LED blinks GREEN, then the batteryfor is properly Servicing requires extreme care and charging. If the status LED is still blinking knowledge and should be performed RED, remove the battery and unplug the only by a qualified service technician. For charger for 1 minute. After 1 minute, plug in service we suggest you return the product the charger and reinsert the battery. If the to your nearest AUTHORIZED SERVICE status LEDNot blinks GREEN, then the battery CENTER for repair. When servicing, use is properly charging. If the status LED is only identical replacement parts. still blinking RED, the battery is defective and needs to be replaced. OVER TEMPERATURE If the battery is inserted into the charger when warm or hot, the CHARGING LED indicator light on the charger may switch on 3 English (original instructions) DISPOSAL This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling. TROUBLESHOOTING Problem Possible cause Solution The safety key is not Insert the safety key. inserted. Check the connection between the The battery is not fully battery and the battery port. Make inserted. sure the battery clicks into place. The battery is not charged. Charge the battery. The powerhead The lock-out button is ReproductionReplace the lock-out button. does not start. defective. Battery may require service Replace the battery. or replacement.for Grass build-up blocking the Remove battery. Clean grass build- Notblade. up from mower deck. Stop the powerhead, and inspect for The motor shaft is bent. The powerhead damage. is excessively noisy and Repair before restarting. If vibration The tool or accessory is vibrates. persists, contact an authorized unbalanced. service center. 4 English (original instructions) LIMITED WARRANTY WARRANTY PERIOD Commercial Briggs & Stratton warrants that, during Consumer Use Use the warranty period specified below, it will repair or replace, free of charge, any part Powerhead 36 months 3 months that is defective in material or workmanship Battery and or both. Transportation charges on product Battery 24 months none submitted for repair or replacement Charger under this warranty must be borne by ** In Australia - Our goods come with purchaser. This warranty is effective for guarantees that cannot be excluded under and is subject to the time periods and the Australian Consumer Law. You are conditions stated below. For warranty entitled to a replacement or refund for a service, find the nearest Authorized major failure and for compensation for Service Dealer in our dealer locator map any other reasonably foreseeable loss or at www.BRIGGSANDSTRATTON.com. damage. You are also entitled to have the The purchaser must contact the Authorized goods repaired or replaced if the goods Service Dealer, and then make the product fail to be of acceptable quality and the available to the Authorized Service Dealer failure does not amount to a major failure. for inspection and testing. For warranty service, find the nearest There is no other express warranty. Authorized Service Dealer in our dealer Implied warranties, including those of locator map at BRIGGSandSTRATTON. merchantability and fitness for a particular COM, or by calling 1300 274 447, or by purpose, are limited to the warranty period emailing or writing to salesenquires@ listed below, or to the extent permitted by briggsandstratton.com.au, Briggs & law. Liability for incidental or consequential Stratton Australia Pty Ltd, 1 Moorebank damages are excluded to the exReproductiontent Avenue, NSW, Australia, 2170. exclusion is permitted by law. Some states The warranty period begins on the date of or countries do not allow limitations on purchase by the first retail or commercial how long an implied warranty lasts, and consumer.