<p>Word Processing Practice Test</p><p>Open the file Tarzan.docx. Then do the following.  [1] Save it to your account with the name Tarzan-FirstName-LastName.docx using your name.  [1] Change the page orientation to landscape.  [1] Change all four margins (top, bottom, left, and right) to .75".  [1] Change the font for the entire document to 10-point Verdana.  [1] Replace the text "The Beasts of Tarzan" with WordArt. Use Blue, accent 1, Plastic Bevel, Reflection.  [1] Center the WordArt between the margins. You will have to do this manually.  [1] Insert a continuous section break at the left edge of the "Chapter Page" line (the first such line – not the second one).  [1] Set the number of columns in section 2 to two columns (leave section 1 – the title -- with one column).  [1] Display a line between the two columns.  [1] Insert a column break before the paragraph that begins "The entire affair is shrouded in mystery"  [1] For the first 11 lines in column 1 (from the "Chapter" line to the "Swede" line), set a left tab stop at the .75" mark.  [1] For the first 11 lines in column 1, set a right tab stop at the 4" mark.  [1] Add a dot leader to the tab stop at the 4" mark.  [1] For the 11 lines of text at the bottom of column 1 (from the "Chapter" line to the "Swede" line), convert the text (including the "Chapter/Page" line) into a 3-column table, using the existing tabs to indicate where one column ends and another begins.  [1] Adjust the widths of the table columns so that each column in the table is approximately the same width as the 11 lines of text above the table. (make columns 1 and 3 narrower, and column 2 wider).  [1] Make the text in the first row of the table bold.  [1] Shade the background of the first row of the table a light gray.  [1] Find a picture of Tarzan on the web that is approximately square and put it at the bottom of the first column. Make it 1 inch tall by 1 inch wide.  [1] Add your name to the right part of the header. Move the existing right tab stop in the header to the 9" mark and use a tab to position your name.  [1] Move the existing center tab stop in the footer to the 4.75" mark.  [1] Add automatic page numbers to the middle part of the footer.  [1] In column 2, set the font size for all of the text to 8-point.  [1] In column 2, set the first line indent for all of the paragraphs to .25". If you have problems with the first paragraph, just insert a blank line above it.  [1] In column 2, set the alignment for all of the text to justified.  [1] In column 2, set the line spacing for the first paragraph to double-spaced. Leave the remaining paragraphs single-spaced.  [1] In column 2, set the spacing after each paragraph (except the first paragraph) to 6 points.  [1] In column 2, remove the quotation marks from the beginning of the first line. Then make the "T" into a drop cap. Use the dropped style.  [1] Insert a text box in column 2 between the second and third paragraphs. Insert the text Tarzan was written by Edgar Rice Burroughs.  [1] Set the fill color of the text box to Orange, Accent 6, Lighter 80%.  [1] Set the border color of the text box to Orange, Accent 6, Darker 25%.  [1] Set the size of the border of the text box to 2.25 points.  [1] In column 2, insert a citation at the end of paragraph 1. The citation source should be Book, Edgar Rice Burroughs, The Beasts of Tarzan, 1911, New York, BCU Publishing.  [1] Add a bibliography of the Works Cited type to the end of your document. Make the text small enough to avoid spilling over onto a new page.  [1] Add a cover page. Choose the Perspective style.  [1] On the cover page, change the title to The Beasts of Tarzan.</p>