<p> Instructions for Installing your new Ultra Soft Kisser Button from Flex-Fletch</p><p>Placement Closing the Split Anchoring the Kisser Button Open the split and place the kisser This requires gluing the split closed, The quick and easy way to button on the string using your best Flex-Fletch recommends Zing! HD a accomplish this is to use string guess as to where it should be. Draw quick-set adhesive, or Flex-Bond, a nocks. These are small, plastic lined, the bow, aim and note where the solvent based flexible adhesive. Flex- brass "C" shapes that clamp on the kisser touches your face. Let the bow Bond should be allowed no less than string and are available in three down and adjust the position of the 24 hours to cure. Other acceptable sizes. String nocks are available at kisser. Do this until you have found a glues include Goat Tuff impact glue your local archery shop. Archery comfortable place where the kisser or any superglue advertised as shops use special pliers for this but button rests, depending on your "Toughened" or "Rubberized"; these you may use standard pliers if you particular form this will usually be glues have an additive that allows are careful to clamp the string nock the corner of the mouth or general the glue some degree of flexibility evenly. vicinity. Mark the spot above and when cured. Place a small amount of below the kisser with masking tape glue in the split and close, holding or a magic marker. the kisser button closed until it remains closed on its own. You may also hold the kisser button closed using tape. You may also serve the kisser button in place. This technique is too involved to describe here so I would suggest searching www.youtube.com for how to serve a peep sight or kisser button. The technique used is the same for both</p>