<p> HOT TUB INSTRUCTIONS</p><p>ON/OFF Power Button. Switch on to use the blower and pumps. Switch off when finished to allow heater to maintain the temperature. TEMPERATURE. The temperature is automatically set to 34 which is actually 38 degrees. The heater only works when the tub is switched off. BLOWER. Turns the small air jets on and off.</p><p>PUMP 1. Turns the waterfall, fountain and lounger (seat 1) jets on and off PUMP 2. Turns the jets for seats 2 and 3 on and off. The diverter in between controls the flow. PUMP 3. Turns the jets for seats 4 and 5 on and off. The diverter in between controls the flow. LIGHTS. Turns the LED lighting system on and off.</p><p>PRE HEAT. Switch on to heat the water when the tub is not in use.</p><p>1. Carefully remove the cover using the lift provided 2. Press MEM/Locked button 2 or 3 times until the padlock disappears from the display, then switch on the tub with the Power Button 3. Turn on desired combination of Blower and Pumps 4. Use the diverter controls to adjust the flow between seats When Finished 5. Press the Power Button to switch OFF the tub, Blower and Pumps 6. Press the Power Button to switch the tub back ON 7. Press the PRE HEAT Button to start the heat cycle 8. Top up the water level ensuring it is half to one inch above the top jets 9. Carefully replace the cover, making sure it is positioned correctly in order to retain the heat IMPORTANT – If you do not follow the above instructions then the tub will not maintain temperature ready for your next use. Pump 3 will run continuously until the water is up to temperature, after which it will only come on for five minutes every half an hour. If Pump 3 does not come on shortly after Step 7 then go back to Step 5. The owners accept no responsibility for the tub if it is not left in PRE HEAT mode between uses. All other buttons have functions only specific to the maintenance of the tub and should not be experimented with as they may have undesired results!</p>