<p>BEKASTAR Traditional Post Top Luminaire</p><p>Specifications</p><p>TRADITIONAL POST TOP LUMINAIRE RANGE DESIGNED FOR DECORATIVE RESIDENTIAL ROAD LIGHTING AND GENERAL AREA LIGHTING WHERE THE ARCHITECTURE AND SURROUNDINGS ARE OF A TRADITIONAL PERIOD. </p><p>The luminaire shall consist of a spigot base, lamp compartment with integral control gear and top cover and shall be designed to operate compact fluorescent, 50/80/125W mercury vapour or 50/70/100W high pressure sodium/metal halide lamps. The cable entry grommet shall be designed for the connection of a 3 x 1.5mm2 cabtyre, of an overall diameter of 9mm.</p><p>The luminaire shall bear the SANS 475 performance mark and the SANS 60598-2-3 safety mark. Luminaire spigot entries comply with SANS 1088 - Table 1 for Type 2: ø76mm x 75mm.</p><p>The luminaire shall have a degree of protection that complies with SANS 60598-2-3:</p><p>Lamp compartment: IP 55</p><p>The IP rating shall be certified by an SABS test report.</p><p>The top cover shall be robustly constructed from die-cast aluminium, powder coated for added protection in the colour specified and shall be firmly secured with a single aluminium décor casting. White reflective paint shall be on the inside.</p><p>The spigot base shall be manufactured from high-pressure die-cast aluminium, powder coated for added protection in the colour specified. The luminaire shall be secured to the pole by three M8 stainless steel grub screws.</p><p>The high-impact non-discolouring acrylic diffuser bowl shall be hexagonal in shape and shall be smooth on the outside, but shall have internal prisms to reduce the direct glare component. A drip ridge shall be provided at the bottom edge to avoid direct rain water contact with the gasket.</p><p>The lampholder shall comply with VC 8011, and shall be rated to withstand 240°C/5kV and shall prevent possible loosening of the lamp caused by vibrations. The control gear shall be incorporated inside the luminaire and shall be mounted on a removable gear tray. It shall be suitable for operation with the specified rating of the lamp on a 230V +3%/-10%50Hz single phase system.</p><p>All control gear components shall be removable and bear the relevant SABS mark. All internal wiring shall be Teflon® coated with protective sleeving to prevent damage by possible abrasion.</p><p>All screws, bolts and metal parts shall be stainless steel or non-corrosive material. Mains connections shall be by means of a suitable screw terminal block with a wire clamping contact. Ignitors, where applicable, shall be of the superposed pulse type. The luminaire shall be power factor corrected to a minimum of 0,9.</p><p>1 | P a g e</p>