<p> Origami Dollar Bill Bow Tie Instructions</p><p>1. Fold a dollar bill in half through the long sides. President Washington’s face should be visible.</p><p>2. Fold it in half again through the short sides.</p><p>3. Push the “D” in DOLLAR from the top right hand corner down to the fold crease forming a right isosceles triangle.</p><p>4. Turn over and repeat with step 3 with the other side. There will be separation (like 2 legs) below the triangles.</p><p>5. Insert your fingers between the 2 surfaces that make up each leg and flatten them out forming a pentagon.</p><p>6. Lift up the front flap (just to the triangles underneath) exposing the backside of the dollar and fold straight across just under the pyramid picture.</p><p>7. Turn over and repeat step 6 with the other side. The result is a rectangle.</p><p>8. Take the upper left corner and the upper right hand corner and fold them down to meet in the center. You will see 2 small right isosceles triangles bisecting the “1” on the backside corners of the bill.</p><p>9. Turn over and repeat step 8 with the other side. The result is a small pentagon.</p><p>10. Insert your fingers between the flaps along the straight edge, pinch the triangles, and carefully pull outward while flattening into a bow tie. The president’s face should be in the center.</p>