<p> Legal Description & Site Plan Requirements and Layout Quiz</p><p>Name:______</p><p>1. Which plan shows the location of a house from an areal view. a. floor plan b. electrical plan c. plot plan d. foundation plan</p><p>2. List the 15 items on a site plan:</p><p>1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15.</p><p>3. T/F Floor joist spacing is shown on a plot plan.</p><p>4. T/F The site plan should identify trees that are to remain on the site after construction.</p><p>5. Briefly define the term easement:</p><p>6. Define the term “setback”:</p><p>7. Briefly define the following terms:</p><p>Plat:</p><p>Plot: 8. Name three basic types of legal descriptions.</p><p> a.</p><p> b.</p><p> c.</p><p>9. Metes are: ______</p><p>10. Bounds are: ______</p><p>11. Metes are measured in ______,______,______, and ______.</p><p>12. One rod is equivalent to ______yards or ______feet.</p><p>13. One surveyor's chain is equivalent to ______feet.</p><p>14. T/F Property boundaries are sometimes established as bearings, the bearing being a direction with reference to one of the quadrants of the compass.</p><p>15. There are ______minutes in one degree and ______seconds in an angular minute.</p><p>16. T/F Bearings are measured either clockwise or counterclockwise from either North or South.</p><p>17. The metes and bounds land survey begins with a monument known as ______.</p><p>18. If the property corner begins or ends on a bench mark it is usually identified with a special ______.</p><p>19. In great land surveys, the imaginary parallel lines running East and West are called lines of latitude and are also called ______. Imaginary lines running North and South are called lines of longitude and are also called ______.</p><p>20. The point of beginning of each great land survey is where two basic reference lines cross. The lines of latitude (parallels), are termed the ______, and the lines of longitude (meridians), are called ______.</p><p>21. The baselines and meridians were divided into blocks called ______. </p><p>22. Each township measures ______square miles.</p><p>23. The townships are numbered by ______and ______.</p><p>24. Tiers run ______or ______of a principal base line.</p><p>25. Ranges run ______or ______of a principal meridian.</p><p>26. Townships are broken down into one mile by one mile areas called ______.</p><p>27. One acre equals ______square feet and one section of land contains ______acres.</p><p>28. Each section is divided into ______quarters. 29. Each quarter is divided again into 4 ______.</p><p>30. ______are divided into each quarter section.</p><p>31. Define the lot and block system:</p><p>32. A ______is established as a legal plot and recorded in the local county records.</p><p>33. The subdivision is given a name and broken into blocks of ______.</p><p>34. Briefly define topography:</p><p>35. Briefly define contour lines:</p><p>36. The vertical distance between contour lines is known as ______.</p><p>37. T/F When contour lines are very close together they represent a relatively flat or gentile sloping land area.</p><p>38. T/F In most cases the only contour-related information required for a plot plan is property corner elevations, street elevation at a driveway, and the elevation of the finished floor levels of the structure. Slope may be defined and labeled with an arrow.</p><p>39. When designing your site you should plan for a minimum driveway slope of ______inch per foot</p><p>40. A single-car driveway should be a minimum of ______feet wide and a double-car driveway should be a minimum of ______feet wide.</p><p>41. The minimum turn radius for a driveway should be ______feet although ______feet would be preferred if space permits.</p><p>42. Which of the following would be a system that you would put in if there wasn't a community sewer system. a. septic b. private waste c. leach d. gravity</p>