<p>Setup</p><p>1. Turn on the equipment you would like to program your remote to operate.</p><p>2. Press the corresponding button on the remote. (TV, VCR, Cable, Audio)</p><p>3. Press and hold the SETUP button on the remote until the red light blinks twice, then release SETUP.</p><p>4. Enter the four digit code for you brand of television. (See Remote Codes)</p><p>5. Aim the remote at the component and press POWER. The equipment should turn off. If it does not, repeat steps 2-4 until the power turns off. </p><p>NOTE: If the customer's remote does not have an All On/All Off button, the red power button the top of the remote will act as the All On/All Off button if the TV and receiver are programmed into the remote correctly. </p><p>If TV and receiver become out of sync with the All On/All Off function, press Cable button then Power. If this step does not bring up a picture, press All On/All Off. All Search Instructions Use the all search method if all of the codes listed for your brand of equipment do not allow you to operate the equipment.</p><p>1. Repeat steps 1, 2, and 3.</p><p>2. Press 9-9-1.</p><p>3. Slowly alternate pressing POWER and TV until your TV turns off. There are up to 100 different codes.</p><p>4. When the TV turns off, press the SETUP button on the remote. This saves the code. </p><p>Finding the Code You Just Entered</p><p>1. Press the button corresponding to the code you just entered, then press and release SETUP.</p><p>2. Press 9-9-0.</p><p>3. For the first digit of your code, press 1, and wait three seconds. Count the number of times the red light blinks and that will tell you the first number of your three-digit code.</p><p>4. For the second digit, press 2, wait three seconds, and count the number of times the red light blinks. This is the second digit of your code.</p><p>5. Repeat the same steps using number three. If the light does not blink at all, then the number is 0. </p>