DMC2161 Installation instructions on Microsoft Windows Vista Operating System Lorex mCam software version 2.0.1 and above is compatible with Microsoft Windows Vista™ Operating System. The Video Driver for DMC2161 has been upgraded to work on Windows Vista and a dedicated driver directory “DVS Driver for Vista” is included on your installation CD and posted to the Lorex website (www.lorexcctv.com/support). While Lorex is continuing its efforts to upgrade the audio driver of the DMC2161 camera to work in a Windows Vista environment, mCam software does support audio using any external audio device (e.g. microphone) that is compatible with Windows Vista. Please note that both video and audio are fully supported in Windows XP. If during your installation on a Microsoft Windows Vista Operating System you get a message that your driver was not successfully installed OR Please follow the steps below to complete the installation: 1. Open the Device Manager: • Click Start / Settings / Control Panel / Device Manager • Click the ‘Continue’ Button on the ‘Microsoft Management Console’ window to continue. The Device Manager window will open. • A list of all System Devices will be displayed. Right Click on the “DVS Composite Device” listed under Universal Serial Bus Controls, and select “Update Driver Software” NOTE: If the device is not displayed, click on the ‘+’ beside the Universal Serial Bus Controllers option. 2. Browse for the Driver location www.lorexcctv.com Copyright © 2007 Lorex Technology Inc. 3. Click the ‘Browse’ button to select the Driver Location. This will typically be either the CD ROM drive, or the location where you saved the “DVS Driver for Vista” (.after downloading from the website) 4. You will get a status message indicating that the installation was successful. Click the ‘Close’ button to exit the Update Window. 5. If prompted with the ‘Found New Hardware’ window, select the option ‘Don’t show this message again for this device’. The Window will close after selecting this option. NOTE: You will see a yellow exclamation mark near the audio device on the Device Manager screen. This indicates that the audio from the camera is not active. 6. Launch the mCam application by clicking Start / Programs / Lorex mCam) www.lorexcctv.com Copyright © 2007 Lorex Technology Inc. .