Safety Information Important Safety Instructions This owner’s guide includes information for Regulatory Model(s): RVF-Y1 SAVE THESE INSTRUCTIONS EN WARNING: When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USE WARNING: To reduce the risk of injury or damage, read and follow the safety precautions when setting up, using and maintaining your robot. This appliance can be used by children aged from eight years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. This is the safety alert symbol. It is used to alert you to potential physical injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. Risk of electric shock Class II equipment Short-circuit-proof safety Read operator’s General symbol for isolating transformer manual recycling Risk of fire For indoor use only Switch mode power supply Keep out of reach BFP Backfeed Protection of children Separate Supply Unit WARNING: Indicates a hazardous situation that, if not avoided, could • Do not use in extremely hot or cold result in death or serious injury. environments (below -5˚C/23˚F or above CAUTION: Indicates a hazardous situation that, if not avoided, could result in minor or moderate injury. 40˚C/104˚F). NOTICE: Indicates a hazardous situation that, if not avoided, could • Keep hair, loose clothing, fingers, and all EN result in property damage. parts of body away from any openings and moving parts. GENERAL • Do not operate the Appliance in a room WARNING where an infant or child is sleeping. • The Appliance must be used in • Do not use Appliance on wet surfaces or accordance with the directions in this surfaces with standing water. Instruction Manual. iRobot cannot be held • Do not allow the Appliance to pick up liable or responsible for any damages or large objects like stones, large pieces injuries caused by improper use. of paper or any item that may clog the • For the purposes of recharging the battery, Appliance. only use the Charging Station Model • Do not use Appliance to pick up ADH-N1 provided with the appliance. flammable or combustible materials such • The supply terminals are not to be short- as petrol, printer or copier toner, or use in circuited. areas where they may be present. • Please make sure your power source • Do not use Appliance to pick up anything voltage matches the power voltage that is burning or smoking, such as marked on the charging station. cigarettes, matches, hot ashes, or • For INDOOR household use ONLY. Do not anything that could cause a fire. use the Appliance in outdoor, commercial • Take care not to damage the power cord. or industrial environments. Do not pull on or carry the Appliance or • Do not operate the Appliance in an area charging station by the power cord, use where there are lit candles or fragile the power cord as a handle, close a door objects. on the power cord, or pull power cord around sharp edges or corners. Do not • Remove the Appliance from the charging run Appliance over the power cord. Keep station and turn OFF the power switch power cord away from hot surfaces. to the Appliance before removing the • Do not use with a damaged power cord battery. or receptacle. Do not use the Appliance • Exhausted batteries are to be removed EN or charging station if it is not working from the Appliance and safely disposed properly, has been dropped, damaged, of. left outdoors, or come in contact • Please dispose of used batteries with water. It must be repaired by the according to local laws and regulations. manufacturer or its service agent in order to avoid a hazard. • The power supply is not to be repaired and not to be used any longer if it is • If the power cord is damaged, it must damaged or defective. be replaced by the manufacturer or its service agent in order to avoid a hazard. • Do not incinerate the Appliance even if it is severely damaged. The batteries can • The plug must be removed from the explode in a fire. receptacle before cleaning or maintaining the charging station. • Do not charge other iRobot robots with the provided Home Base charging station. • Turn OFF the power switch before cleaning or maintaining the Appliance. CAUTION • The robot contains batteries that are only • Clear the area to be cleaned. Remove replaceable by skilled persons. To replace power cords and small objects from the or remove the battery, please contact floor that could entangle the Appliance. Customer Care. Tuck rug fringe under the rug base, and lift • Use only the original rechargeable battery items such as curtains and tablecloths off and charging station provided with the the floor. Appliance from the manufacturer. Non- rechargeable batteries are prohibited. • Do not put objects into the suction intake. device operation. To ensure compliance, Do not use if the suction intake is blocked. operation at any distance closer than the Keep the intake clear of dust, lint, hair, or stated minimum is not recommended. The anything that may reduce air flow. antenna used for this transmitter must not be co-located or operated in conjunction EN NOTICE with any other antenna or transmitter. • The battery must be removed and • To disable the Wi-Fi module on Roomba discarded according to local laws and Combo, turn the robot’s power ON. Place regulations before recycling or disposal of the robot on the charging station, making the Appliance. sure that the charging contacts on the • Do not use non-rechargeable batteries. robot and the charging contacts on the Use only the rechargeable battery supplied charging station make a connection. with the product. For replacement, Press and hold the CLEAN button on purchase identical iRobot battery or the robot for 20 seconds, until Roomba contact iRobot Customer Care for Combo emits 3 beeps. To enable the Wi- alternative battery options. Fi module on Roomba Combo, turn the robot’s power OFF, and then back ON. • If the robot will not be used for a long time, The Wi-Fi module will be enabled when fully charge the robot and power OFF for Roomba Combo is restarted. storage and unplug the charging station. • When not using the charging station for a long period of time, please unplug it. • Do not use without dust bin and/or filters in place. • To satisfy RF exposure requirements, a separation distance of 20 cm (7.9 in) or greater should be maintained between this device and any persons during Specifications Model RVF-Y1, Roomba Combo™ Rated Input 20V - 0.8A EN Charging Station Model ADH-N1 Rated output Rated Input Voltage 100-240 V AC 20 V DC voltage Rated Output Current 0.8 A Rated power 25 W Frequency Bands 2400-2483.5 MHz Maximum EIRP Output 15.46 dBm at 2442 MHz Power Off Mode Power Less than 0.50 W Networked Standby Power Less than 2.00 W Output power of the Wi-Fi module is less than 100 mW. * Technical and design specifications may change as we continue to improve our product. About Your Roomba Combo™ Robot Vacuum & Mop Top View Buttons & Indicators Tank Release Status Indicator EN Button Cover Wi-Fi Indicator CLEAN Button LiteTouch® Sensor Under the Cover Bottom View Charging Contacts Cliff Sensor Caster Wheel Edge-Sweeping Battery Door Brush Edge-Sweeping Brush Cliff Sensor Cliff Sensor RESET Button Main Brush Power Switch Water Outlets Multi-Function Wheels Cleaning Tool Rear Wheel Dust Bin and Filter Tank 1 For more information, visit global.irobot.com Dust Bin and Filter Advanced Mopping System Dust Bin Handle Water Inlet EN Tank Pre-Filter Dust Bin Lock Cleaning Pad Plate Sponge Filter High Performance Filter Washable Microfibre Cleaning Pad Home Base Charging Station IR Sensor Window Charging Contacts Roomba Combo™ Owner’s Guide 2 Setting Up Your Roomba Combo™ Robot Vacuum & Mop Positioning the Home Base Charging Station Charging CLEAN Button Lights While Charging EN Good Wi-Fi® Coverage Pulsing: Charging Off: Fully Charged • Make sure to turn your robot’s power switch to the ON position before charging. ‘I’ = power ON, ‘O’ = power OFF • Place your robot on the charging station making sure the metal charging contacts on your robot and charging station make a connection. 0.5 m (1.6 ft) 0.5 m (1.6 ft) Note: Charge your robot for at least four hours before the first use. both sides both sides • Empty any remaining water from the tank and remove the cleaning 1.5 m (5 ft) pad plate before charging your robot. in front • When your robot is not cleaning, it is best to keep it powered ON and charging instead of powered OFF. • For long-term storage, fully charge your robot, turn off the robot by switching the robot’s power switch to the OFF position and unplug the *Objects are not to scale. charging station. Place the charging station on a level floor surface against the wall. Keep the immediate area 1.5 m (5 ft) in front of the charger and 0.5 m (1.6 ft) on both sides of the charging station clear of objects and reflective surfaces. 3 For more information, visit global.irobot.com iRobot Home App Home Prep Download the iRobot Home App and connect to Wi-Fi ® Before you start cleaning, remove any obstacles from the area.