Electronic Acoustic Drum Module Owner’s Manual Quick Guide page 6 Features of the EAD10 page 10 EN For EAD10 SPECIAL MESSAGE SECTION This product utilizes batteries or an external power supply (adapter). Battery Notice: DO NOT connect this product to any power supply or adapter other This product MAY contain a small non-rechargeable battery which (if than one described in the manual, on the name plate, or specifically applicable) is soldered in place. The average life span of this type of recommended by Yamaha. battery is approximately five years. When replacement becomes nec- WARNING: Do not place this product in a position where anyone essary, contact a qualified service representative to perform the could walk on, trip over, or roll anything over power or connecting replacement. cords of any kind. The use of an extension cord is not recommended! This product may also use “household” type batteries. Some of these If you must use an extension cord, the minimum wire size for a 25’ may be rechargeable. Make sure that the battery being charged is a cord (or less ) is 18 AWG. NOTE: The smaller the AWG number, the rechargeable type and that the charger is intended for the battery larger the current handling capacity. For longer extension cords, con- being charged. sult a local electrician. When installing batteries, never mix old batteries with new ones, and This product should be used only with the components supplied or; a never mix different types of batteries. Batteries MUST be installed cor- cart, rack, or stand that is recommended by Yamaha. If a cart, etc., is rectly. Mismatches or incorrect installation may result in overheating used, please observe all safety markings and instructions that accom- and battery case rupture. pany the accessory product. Warning: SPECIFICATIONS SUBJECT TO CHANGE: Do not attempt to disassemble, or incinerate any battery. Keep all bat- The information contained in this manual is believed to be correct at teries away from children. Dispose of used batteries promptly and as the time of printing. However, Yamaha reserves the right to change or regulated by the laws in your area. Note: Check with any retailer of modify any of the specifications without notice or obligation to update household type batteries in your area for battery disposal information. existing units. Disposal Notice: This product, either alone or in combination with an amplifier and Should this product become damaged beyond repair, or for some rea- headphones or speaker/s, may be capable of producing sound levels son its useful life is considered to be at an end, please observe all that could cause permanent hearing loss. DO NOT operate for long local, state, and federal regulations that relate to the disposal of prod- periods of time at a high volume level or at a level that is uncomfort- ucts that contain lead, batteries, plastics, etc. If your dealer is unable able. If you experience any hearing loss or ringing in the ears, you to assist you, please contact Yamaha directly. should consult an audiologist. NAME PLATE LOCATION: IMPORTANT: The louder the sound, the shorter the time period before The name plate is located on the bottom of the product. The model damage occurs. number, serial number, power requirements, etc., are located on this Some Yamaha products may have benches and / or accessory mount- plate. You should record the model number, serial number, and the ing fixtures that are either supplied with the product or as optional date of purchase in the spaces provided below and retain this manual accessories. Some of these items are designed to be dealer assem- as a permanent record of your purchase. bled or installed. Please make sure that benches are stable and any optional fixtures (where applicable) are well secured BEFORE using. Benches supplied by Yamaha are designed for seating only. No other uses are recommended. NOTICE: Service charges incurred due to a lack of knowledge relating to how a Model function or effect works (when the unit is operating as designed) are not covered by the manufacturer’s warranty, and are therefore the owners responsibility. Please study this manual carefully and consult your dealer before requesting service. Serial No. ENVIRONMENTAL ISSUES: Yamaha strives to produce products that are both user safe and envi- ronmentally friendly. We sincerely believe that our products and the Purchase Date production methods used to produce them, meet these goals. In keep- ing with both the letter and the spirit of the law, we want you to be aware of the following: 92-BP (bottom) PLEASE KEEP THIS MANUAL COMPLIANCE INFORMATION STATEMENT (DECLARATION OF CONFORMITY PROCEDURE) Responsible Party : Yamaha Corporation of America Address : 6600 Orangethorpe Ave., Buena Park, Calif. 90620 Telephone : 714-522-9011 Type of Equipment : Electronic Acoustic Drum Module Model Name : EAD10 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received including interference that may cause undesired operation. See user manual instructions if interference to radio reception is suspected. * This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. (FCC DoC) S-1 EAD10 Owner’s Manual For AC adaptor and EAD10 FCC INFORMATION (U.S.A.) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! not guarantee that interference will not occur in all installations. If This product, when installed as indicated in the instructions con- this product is found to be the source of interference, which can be tained in this manual, meets FCC requirements. Modifications not determined by turning the unit “OFF” and “ON”, please try to elimi- expressly approved by Yamaha may void your authority, granted by nate the problem by using one of the following measures: the FCC, to use the product. Relocate either this product or the device that is being affected by 2. IMPORTANT: When connecting this product to accessories and/ the interference. or another product use only high quality shielded cables. Cable/s Utilize power outlets that are on different branch (circuit breaker or supplied with this product MUST be used. Follow all installation fuse) circuits or install AC line filter/s. instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA. In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the 3. NOTE: This product has been tested and found to comply with the lead-in to co-axial type cable. requirements listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance with these requirements provides a reason- If these corrective measures do not produce satisfactory results, able level of assurance that your use of this product in a residential please contact the local retailer authorized to distribute this type of environment will not result in harmful interference with other elec- product. If you can not locate the appropriate retailer, please contact tronic devices. This equipment generates/uses radio frequencies Yamaha Corporation of America, Electronic Service Division, 6600 and, if not installed and used according to the instructions found in Orangethorpe Ave, Buena Park, CA90620 the users manual, may cause interference harmful to the operation The above statements apply ONLY to those products distributed by of other electronic devices. Compliance with FCC regulations does Yamaha Corporation of America or its subsidiaries. * This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. (class B) EAD10 Owner’s Manual S-2 For AC adaptor This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3 (B)/NMB-3(B) (can_b_02) Explanation of Graphical Symbols The lightning flash with arrowhead symbol within CAUTION an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” RISK OF ELECTRIC SHOCK within the product’s enclosure that may be of suffi- DO NOT OPEN cient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral trian- CAUTION: TO REDUCE THE RISK OF gle is intended to alert the user to the presence of ELECTRIC SHOCK, DO NOT REMOVE important operating and maintenance (servicing) COVER (OR BACK). NO USER-SERVICEABLE instructions in the literature accompanying the PARTS INSIDE. REFER SERVICING TO product. QUALIFIED SERVICE PERSONNEL. IMPORTANT SAFETY INSTRUCTIONS 1 Read these instructions. 11 Only use attachments/accessories specified by the manu- 2 Keep these instructions. facturer. 3 Heed all warnings. 12 Use only with the cart, stand, tri- 4 Follow all instructions. pod, bracket, or table specified by 5 Do not use this apparatus near water. the manufacturer, or sold with the 6 Clean only with dry cloth. apparatus. When a cart is used, 7 Do not block any ventilation openings. Install in accor- use caution when moving the cart/ dance with the manufacturer’s instructions. apparatus combination to avoid 8 Do not install near any heat sources such as radiators, heat injury from tip-over. registers, stoves, or other apparatus (including amplifiers) 13 Unplug this apparatus during light- that produce heat. ning storms or when unused for long periods of time. 9 Do not defeat the safety purpose of the polarized or 14 Refer all servicing to qualified service personnel. Servicing grounding-type plug. A polarized plug has two blades with is required when the apparatus has been damaged in any one wider than the other. A grounding type plug has two way, such as power-supply cord or plug is damaged, liquid blades and a third grounding prong.