P.O. Box 1404 Joplin, MO 64802-1404 Typical Balcony/Breezeway Detail 800-641-4691 1 inch TW-15 All logos are cmyk tamkowaterproofing.com If needed, TAMKO red is PMS185 1.5 inch FINISHED WALL When to use:Or metal counterflashing at openings. page up to 6 inches = 1 inch TWM-1 MASTIC WEATHER RESISTANT BARRIER or other appropriate, page up to 12 inches = 1.5 inch Positioned to lap TW-60 12" flashing in shingle fashion. compatible sealant at page up to 18 inches = 2 inch membrane and metal page over 18 inches = 2.5 inch flashing terminations. TW-60 12" FLASHING 2 inch Positioned with 4" minimum on horizontal leg and PRIMED 26 GA. 2" minimum beyond vertical leg of metal flashing. The use of TW-60 18" Flashing is (MINIMUM) GALVANIZED recommended in regions that experience heavy snow fall and ice buildup. METAL L-FLASHING (4" × 4" MINIMUM) TW-60 SHEET WATERPROOFING MEMBRANE Prime metal flashing prior to TAMKO red is PMSPlywood 185, or OSB deck must be fully covered. installation with TWP-1 or CONCRETE which according to the TWP-2 primer. 2.5 inch logo standards breaks TWM-1 MASTIC down to be M100, Y80 or other appropriate, compatible sealant at TW-60 termination as a cant. ADHESIVE PRIMER* METAL FLASHING EXTRUDED ALUMINUM BALCONY EDGING (T-BAR) FASTENERS Cross-sectional shape varies. Fasten per Positioned 1" from the PLYWOOD or OSB DECK manufacturer’s recommendations. outside edges of the 1/4":12" minimum positive slope 1 inch flashing. Fastener type required away from wall to drain and and spacing as prevent ponding water. prescribed by a design professional. METAL DRIP-EDGE APPROPRIATE, COMPATIBLE WEEP SYSTEM Or other appropriate, compatible, [discontinuous spacers (shown), a prefabricated system, or a system prefabricated drip-edge, or a system developed by a design professional], as required for proper performance. *Refer to application instructions with regards developed by a design professional. 1.5 inch to priming and coverage rates. BALCONY/BREEZEWAY 2 inch ©2018 TAMKO Building Products, Inc. TAMKO and the TAMKO logo are registered trademarks of TAMKO Building Products, Inc. Rev. 12/03/18 2.5 inch.