Remanent Magnetization of Oolitic Ironstone Beds

Remanent Magnetization of Oolitic Ironstone Beds

Earth Planets Space, 50, 733–744, 1998 Remanent magnetization of oolitic ironstone beds, Hazara area, Lesser Himalayan thrust zone, Northern Pakistan: Its acquisition, timing, and paleoenvironmental implications Mitsuo Yoshida*, Ibrar H. Khan, and Mirza Naseer Ahmad Geoscience Laboratory, Geological Survey of Pakistan, Shahzad Town, P.O. Box 1461, Islamabad, Pakistan (Received January 27, 1997; Revised May 15, 1998; Accepted May 19, 1998) Chamosite-hematite type oolitic ironstone is distributed in the Cretaceous-Tertiary (K-T) boundary zone of the Hazara area, Lesser Himalayan thrust zone, in the northwestern margin of the Indo-Pakistani subcontinent. A total of 52 oriented samples were collected from 6 beds in two open pit mines, Nathia Gali and Bagnotar. Ferromagnetic properties of the oolitic ironstone are dominated by fine-grained hematite that possesses a characteristic remanent magnetization (ChRM). The ChRM is a chemical remanent magnetization (CRM) acquired by the hematite which formed from Fe-rich initial materials (iron hydroxides) during early diagenesis of the ironstone bed. The direction of the remanent magnetization indicates that the magnetization was acquired in an equatorial region (average inclination = 2°, paleolatitude = 1°N), which is consistent with the paleoposition of the Indian subcontinent during early Paleocene time, as estimated by previous data. The initial Fe-rich sediments were deposited under anoxic conditions, probably in a non-marine or brackish environment. During early diagenesis, after development of oolitic textures, the paleoenvironment became arid, where the CRM was acquired through the conversion of amorphous hydroxides or goethite to fine-grained hematite. The paleomagnetic results reveal complicated local rotational movements of oolitic ironstone blocks about vertical axes, which might be a result of intense thrusting within the terrane after early Tertiary collision between India and Asia. 1. Introduction Oolitic ironstones are widely distributed in Mesozoic to Phanerozoic sedimentary ironstones are usually thin se- early Tertiary formations in the northwestern Lesser quences with oolitic textures which were deposited in shal- Himalayas, Pakistan (Ahmad, 1969; Maynard, 1983; Hallam low-marine or non-marine environments (Young and and Maynard, 1987; Garzanti, 1993). In this study, we Taylor, 1989; Taylor, 1992). The oolitic texture (or oolite) describe results of mineralogical, rock-magnetic, and pa- in sedimentary ironstones consists of concentric rings of Fe- leomagnetic analyses of one of the major oolitic ironstones 3+ bearing minerals generally from the hematite (Fe 2O3)- exposed in Hazara area in the Lesser Himalaya of Northern chamosite ((Mg,Fe)3Fe3(Si3Al)O10(OH)8) assemblage or the Pakistan. The paleoenvironment of the oolitic ironstone 3+ 2+ goethite (Fe OOH)-berthierine ((Fe4 Al2)(Si2Al2) formation, in the light of our results, is also discussed. O10(OH)8) assemblage (Tucker, 1991). It has been widely believed that the concentric rings of oolite were initially 2. Geologic Setting and Sampling formed by a chemical precipitation process. The Hazara area lies in the crescent-shaped NE-SW The occurrence of oolitic ironstones generally corre- trending Lesser Himalayan terrane which forms the western sponds to times of high relative sea-level, when climate was limb of the Hazara-Kashmir Syntaxis, at the northwestern generally considered to have been warm and humid, which margin of the Indo-Pakistani subcontinent (Fig. 1). The facilitated chemical weathering (Blatt et al., 1980; Gilbert Hazara area (or “Hazara Arc”, cf. Butt, 1989) is bounded by and Park, 1986). These observations suggest that oolitic two major thrust faults, the Panjal Thrust and the Main ironstones, especially hematite-bearing types, may be able Boundary Thrust (MBT), and a number of local thrust fault to maintain a chemical remanent magnetization (CRM) that lie in a similar NE-SW trend (Fig. 2). which may be useful for paleomagnetic studies. However, We studied oolitic ironstone beds which are referred to as the process by which oolitic textures form and the timing of the Langrial iron ore deposits (Khan and Ahmad, 1966) crystallization of hematite in these rocks is still a matter of which are currently being exploited by local small-scale debate (Maynard, 1983; Young and Taylor, 1989; Kimberley, open pit mines. The ironstone beds are overlain by limestone 1994). beds of the Lockhart Formation and are underlain by lime- stone beds of the Kawagarh Formation. The Lockhart For- mation contains abundant foraminifera which indicate a *Present address: Geoscience Analysis Center, Geoscience Co., Ltd., Paleocene age, while the Kawagarh Formation has been 13-14, Moto Asakusa 3, Taito, Tokyo, Japan. dated as Late Coniacian to Campanian (Late Cretaceous), Copy right The Society of Geomagnetism and Earth, Planetary and Space Sciences based on limited paleontological data (Fatmi, 1974; Ibrahim (SGEPSS); The Seismological Society of Japan; The Volcanological Society of Japan; The Geodetic Society of Japan; The Japanese Society for Planetary Sciences. Shah, 1977). The oolitic ironstone beds are residual deposits 733 734 M. YOSHIDA et al.: REMANENT MAGNETIZATION OF OOLITIC IRONSTONE = number of measured n Fig. 1. Tectonic sketch map of Northern Pakistan (modified from Kazmi and Rana, 1982), and the study area. = number of samples used for statistics, N which mark a significant time gap across the Cretaceous- Tertiary (K-T) boundary. The ironstone beds generally consist of 2 to 5 cm layers of dark brown lenticular ferrous materials within poorly sorted massive brown sandy silt- stone. The oolitic ironstone beds have a maximum thickness of 3 m in the area and are highly deformed and sheared by a number of NE-SW trending thrust faults which form an imbricated thrust structure (Fig. 2). The beds form a SE- dipping monoclinal structure in the Bagnotar and Nathia Gali open pit areas. A total of 52 oriented samples were collected from the ferrugenous layers that are exposed at two sites (beds) at the Nathia Gali open pit and at four sites (beds) at the Bagnotar open pit in the eastern part of the Hazara area (Fig. 2). 3. Petrography and Mineralogy The ironstone appears as fragile dark brown sandy silt- stone, with oolitic texture in hand samples. To determine the mineralogical composition and petrologic nature of the ironstone, petrographic observation, X-ray diffraction (XRD) analysis, and electron probe micro analysis (EPMA) were samples, ChRM* = site-mean ChRM directions before tilt correction, ChRM** after correction. applied to selected samples. Table 1. Site mean directions of NRM and ChRM before after tilt correction. 3.1 Petrographic observation Petrographic observations using a polarized optical mi- croscope indicate that the ironstone comprises ooids and subangular to subrounded quartz grains (0.4~0.02 mm di- ameter, average 0.1 mm diameter) in a calcareous cement (Plate 1). The matrix color is due to the presence of hematite pigment and goethite. The ooids are generally larger than the quartz grains and are highly variable in shape, varying from spherical to irregular ellipsoidal. Although most of the M. YOSHIDA et al.: REMANENT MAGNETIZATION OF OOLITIC IRONSTONE 735 Fig. 2. Location of sampling sites of the Langrial iron ore deposits. The distribution of thrust faults is from Khan and Ahmad (1966). grains are symmetrical, some show distinct asymmetry tated as gelatinous material which was compacted during (Plate 1). The size of the ooids is mostly between 0.8 mm and early burial, while still soft. The presence of ooid fragments 0.2 mm in diameter, but smaller size ooids (0.2 mm to 0.05 as nuclei of other ooids (see Plate 1) indicates that the mm in diameter, it is similar size of quartz grains) are also formation of ooids occurred repeatedly in a dynamic envi- present. The larger ooids sometimes contain several smaller ronment. ooids or a fragment of another ooid is present at their center The center of the ooids is sometimes replaced by carbon- which may have acted as a nucleus. Surrounding laminae ates which cut across the lamellae. Carbonates are also have concentric structures, as indicated by dark (opaque) observed in radial fissures in ooids and in veins, which and light bands of minerals at 0.05~0.01 mm intervals. Very formed after consolidation of the bed. fine chamosite grains are commonly enclosed in the lami- 3.2 XRD analysis nae, and the opaque parts are composed of hematite. XRD analysis was made using a RIGAKU/Geiger Flex Asymmetrical and unbroken ooids are affected by neighbor- ME-20 system, and the interpretation of diffraction charts ing ooids, which suggests an effect of deformation before was conducted using selected JCPDS (ASTM) cards for complete consolidation but after the formation of the oolitic common minerals. The mineral species identified from the structure. These features suggest that the ooids formed in XRD charts include: quartz (SiO2), chamosite situ (or not transported far) and that they initially precipi- ((Mg,Fe)3Fe3(Si3Al)O10(OH)8), hematite (α-Fe2O3), with a 736 M. YOSHIDA et al.: REMANENT MAGNETIZATION OF OOLITIC IRONSTONE Plate 1. Photomicrographs of oolitic ironstone (sample B-1-1 from Bagnotar open pit) under transmitted polarized light (parallel nicols). Light-colored rings are mainly composed of chamosite and the dark (opaque) parts are composed of hematite. The symmetrical shape of the ooids is more or less affected by neighboring ooids, which indicates that the deformation occurred before consolidation, but after formation of the oolitic structure. Some ooids contain a fragment of another ooid (at their center) which may have acted as a nucleus. (a) Plate 2. Compositional maps of the distribution of (a) Fe, (b) Si, and (c) Al in terms of the relative X-ray intensities of Fe Kα, Si Kα, and Al Kα lines, with intensity ranges of each element displayed as pseudocolors in the form similar color pallette for each map. Brightness is an indication of elemental abundance. minor amount of goethite (α-FeOOH), smectite 3.3 EPMA analysis ((Ca,Na)0.7(Al,Mg,Fe)4(SiAl)8O20(OH)4H2), and siderite Because the ooids have layers with different composi- (FeCO3).

View Full Text

Details

  • File Type
    pdf
  • Upload Time
    -
  • Content Languages
    English
  • Upload User
    Anonymous/Not logged-in
  • File Pages
    12 Page
  • File Size
    -

Download

Channel Download Status
Express Download Enable

Copyright

We respect the copyrights and intellectual property rights of all users. All uploaded documents are either original works of the uploader or authorized works of the rightful owners.

  • Not to be reproduced or distributed without explicit permission.
  • Not used for commercial purposes outside of approved use cases.
  • Not used to infringe on the rights of the original creators.
  • If you believe any content infringes your copyright, please contact us immediately.

Support

For help with questions, suggestions, or problems, please contact us