IP Pro™ Solution Single Electric Strike Application

1 Access Control AC IP Network IP Controller Mains

IPDCE

1 2

2 Power Supply 12 and 24VDC Output

OPTIONAL BATTERY BACKUP RB12V4-2

602RFX12VR 3 3 Wiegand Reader Options (Choose one): Prox Reader or Keypad-Prox Combo 4

OPTIONAL CREDENTIALS Fobs - HID1346-10 Cards - HID1326-25 IPRW 920PW 923PW

4 Electric Strike (Choose one): Centerline Entry or No Center Line Relocation* SYSTEM OPERATION

* Door is normally closed and Emergency Override: The door secured by an electrifed . may be accessed by key override.

Authorized Access: Presenting Low Voltage: System is a valid card or entering a valid powered by a regulated & 45-A 25-4U 55-ABCU fltered power supply with user code on the reader will 12VDC output for access control momentarily unlock the door for equipment and 24VDC output for access. The unlock time will locking hardware to maximize be confgured by the access effciency. Loss of power will control programming. The door result in unsecure door, unless may also be programmed for equipped with optional battery maintained access. back-up.

Authorized Egress: Free egress IP-based Access Control: is available at all times by turning User-friendly programming interface via a built-in web the inside lever, retracting the server, accessible from any latchbolt, and opening the door. networked PC.

■ (800) 413-8783 www.SDCsecurity.com SDC P/N: 602RFX12VR IP Network AC Mains Cat5 (or better) (3) COND 602RF 12VR TO 120VAC PRIMARY 602RF VOLTAGE CONNECTION IP Pro (2) 18/2C Power Door Supply Controller x 12VR +- +- 24 12 VOLTAGE SELECTION SWITCHES (SET FOR 24VDC) DC Voltage Battery Input 18/4C Output SDC P/N: IPRW Terminals Terminals FACTORY INSTALLED JUMPER

12VDC + - + - C (REMOVE ONLY IF FIRE ALARM 22/6C INTERFACE IS CONNECTED)

24VDC

+ - + - SDC P/N: RB12V4 RB12V4

A B A B 5 AMP HOUR 5 AMP HOUR 0V 0V 0V 0V PB DC

Entry 920PW MAINS OP3 OP2 BATTERY BATTERY PRESENT B/GL AUX 1 AUX +12V Card 2-16 17-32 TAMP Reader SDC P/N: RB12V4-2 SENSE CLOCK/D1 SDC P/N: IPDCE DATA/D0 +12V IP Pro™ Door Controller 0V (Door #1) Ethernet Electric Strike RED GREEN SDC P/N: AUX RELAY MAIN RELAY RJ-45 923PW DHCP NC C NO NC C NO 12 OFF

DEFAULT To PC or Local Network

System Components: (1) 602RFX12VR –1 Amp Regulated Power Supply w/ Fire Alarm Interface & 12VDC Output Module. (1) IPDCE –IP Pro™ Single Door Controller

55 Series Strike Choose (1) Card Reader: SDC P/N: 45-A IPRW – Indoor/Outdoor Proximity Card Reader (Fail-secure) BLU (Fail-secure, 920PW –Single Gang Indoor/Outdoor Proximity Card Reader RED (+) BLK 24VDC Configuration) 24VDC w/ integral Keypad Pigtail 923PW –Frame mount Indoor/Outdoor Proximity Card Reader MOV* SDC P/N: 55-AU (included) w/ integral Keypad (Fail-secure, WHT(-) Power RED Choose (1) Electric Strike: Connector 24VDC Configuration) SDC P/N: 25-4U MOV* 45-A –Universal Electric Strike for use with having up WHT (Fail-secure, to 3/8" latchbolts, UL Listed, 630 RED (+) 24VDC Configuration) 55-AU –Universal Heavy-duty Grade 1 Strike for cylindrical BLU locks, mortise locks without deadbolts and mortise exit devices MOV * Power 25-4U –Low-Profile Electric Strike, 630 BLK GRN(-) Connector *To protect against inductive kickback, MOV (1) RB12V4-2 –Two 5Ah 12VDC Backup Batteries (Optional) must be installed as close to strike as possible. (1) HID1346-10 –Ten Proximity Key Fobs (Optional) © 2015 Security Door Controls Printed in U.S.A MOV included with IPDCE and strike.

NOTE: ALL WIRING MUST BE REVIEWED AND APPROVED BY THE PROJECT NAME: TITLE: SO NO.: REV PROJECT ENGINEER ASSIGNED TO THE LOCATION FOR ITS IP Pro™ 1-Door System with Electric Strike - - 801 Avenida Acaso CORRECTNESS AND SUITABILITY FOR THE APPLICATION IN WHICH IP Pro Single Door Applications Camarillo, CA 93012 THE EQUIPMENT IS INSTALLED AND OPERATED. ALL WIRING MUST LOCATION.: DIST.: CONTACT: DATE: DRAWN BY: DWG. NO.: t 805.494.0622 ~ f 805.494.8861 CONFORM TO NATIONAL, STATE, AND LOCAL CODES FOR CLASS 2 Page 11 of 11 www.sdcsecurity.com FIRE PROTECTION AND CONTROL DEVICES. -- - [email protected] 07/2015 - IPPRO Apps