Lay out All Your Parts and Match Them to the Parts List

LCD-PV

Lay out all your parts and match them to the parts list.

Take extension tube (2) and use the ¾” screw (10) and ¾” washers (11) and attach the support tube (3) to the extend tube (2). Use the brake screw (17) and the M3 allen key (20) to secure the ¾” screw (10) by tightening the brake screw (17) in the ¼” threaded hole in the extend tube (2). Use the 3/8” screw, washer, and nylon nut (16, 15, and 8) to secure the swivel bracket (4) to the support tube (3).

Determine which VESA standard your TV follows (200, 100x200, 100, or 75mm). 200 mm corresponds to roughly 8 inches between the mounting holes, 100 mm corresponds to roughly 4 inches, and 75 mm corresponds to roughly 3 inches. Once you determine which VESA standard your TV is determine the screw size necessary for your TV. The TV should accept either M4 or M5 (22 or 21) screws which are provided. Once both of these pieces of information are determined screw on the appropriate mounting plate with the appropriate screws (the big mounting plate (6) is for VESA 200 and 100x200 and the small mounting plate (5) is for VESA 100 and 75).

Note: For the next step and the step after it is important to attach the brackets to a solid surface (i.e. wall plate, double wall studs, concrete or other support system) that will support the weight of your TV and mount.

To use the ceiling mast provided

Mark the ceiling or desired mounting surface in preparation of installation of the ceiling plate (1) to desired surface. Pre drill if necessary and mount ceiling plate (1) to desired surface. Make sure the ceiling plate (1) is secure on the mounting surface. Attach the extend tube (2) to the ceiling plate (1) using the 5/16” screw and nylon nut (18 and 19).

To use the AK-1 and CP-1

Mark the ceiling or desired mounting surface in preparation of installation of the plate (42). Pre drill if necessary and mount the plate (42) to the desired surface. Make sure the plate (42) is secure on the mounting surface. Remove the ¾” screw (10) which attaches the support tube (3) to the extend tube (2). Next place a washer (39 and 40) on top and bottom of the support tube (3) and use the 5/8” screw (41) to through bolt the support tube (3) to the threaded pipe adaptor (37 and 38) using a spring washer and nut (35 and 34) to secure the connection. Take 1-½” standard N.P.T. plumbing pipe and thread it between the threaded pipe adaptor (37) and the plate (42). Use brake screws (36) to secure the plumbing pipe at both ends and the bottom half of the plumbing pipe adaptor (38). Next attach the mounting plate which is attached to your TV (5 or 6) to the swivel bracket (4) using the M6 screw and nylon nut (9 and 7). Screw the adjustable screw (12) into the swivel bracket (4) to tilt the TV. Use cable clips (13) at your discretion for cable management by snapping them into the holes in the side of the support tube.

To use the camera bracket

Determine the position that you want your camera to be in (under your TV or to the side). Next determine how far you want your camera to stick out to determine which of the connectors you wish to use. (25, 26, and/or 32). Once you have determined both assemble the bracket as shown in the parts list using the appropriate connectors. Make sure to use the brake screws (31) in the swivel metal (29) to prevent the camera from coming lose.

Please verify all nuts and screws and securely and completely fastened

Enjoy your mount