Transmission Range (TR) Sensor
Total Page：16
File Type：pdf, Size：1020Kb
TRS replacement
AX4S
Section 07-01A: Transaxle, Automatic—AX4S 1997 Taurus, Sable—3.0L (2V) Workshop Manual IN-VEHICLE SERVICE
Transmission Range (TR) Sensor
SPECIAL SERVICE TOOL(S) REQUIRED Description Tool Number Transmission Range (TR) Sensor (MLPS) Alignment Tool T92P-70010-AH
Removal
1. Disconnect battery ground cable (14301). Refer to Section 14-01 .
2. Place manual control lever (7A256) in NEUTRAL.
3. Remove engine air cleaner (ACL) (9600) and air cleaner outlet tube (9B659). Refer to Section 03-12 .
4. Disconnect electrical connector from transmission range (TR) sensor.
5. Remove manual control lever from transaxle.
6. Remove two TR sensor retaining bolts.
7. Remove transmission range (TR) sensor. Installation
1. Make sure manual control lever is in the NEUTRAL position.
2. Install transmission range (TR) sensor and loosely install two retaining bolts.
3. Align TR sensor slots using Transmission Range (TR) Sensor (MLPS) Alignment Tool T92P-70010-AH. 4. Tighten TR sensor retaining bolts to 9-12 Nm (80-106 lb-in) and remove tool.
5. Connect electrical harness to transmission range (TR) sensor.
6. Install transaxle manual control lever. Tighten to 11-16 Nm (98-141 lb-in).
7. Install air cleaner outlet tube and engine air cleaner. Refer to Section 03-12 .
8. Connect battery ground cable. Refer to Section 14-01 .
9. Check for proper operation with parking brake control (2780) engaged. The engine should start only in PARK or NEUTRAL.
AX4N Section 07-01B: Transaxle, Automatic— 1997 Taurus, Sable—3.0L (2V), 3.0L (4V), 3.4L SHO AX4N Workshop Manual IN-VEHICLE SERVICE
Transmission Range (TR) Sensor
SPECIAL SERVICE TOOL(S) REQUIRED Description Tool Number Transmission Range (TR) Sensor (MLPS) Alignment Tool T92P-70010-AH
Removal
1. Disconnect battery ground cable (14301). Refer to Section 14-01 .
2. Place manual control lever (7A256) in NEUTRAL.
3. Remove engine air cleaner (ACL) (9600) and air cleaner outlet tube (9B659). Refer to Section 03-12 .
4. Disconnect electrical connector from transmission range (TR) sensor.
5. Remove manual control lever from transaxle.
6. Remove two TR sensor retaining bolts.
7. Remove transmission range (TR) sensor. Installation
1. Make sure manual control lever is in the NEUTRAL position.
2. Install transmission range (TR) sensor and loosely install two retaining bolts.
3. Align TR sensor slots using Transmission Range (TR) Sensor (MLPS) Alignment Tool T92P-70010-AH. 4. Tighten TR sensor retaining bolts to 9-12 Nm (80-106 lb-in) and remove tool.
5. Connect electrical harness to transmission range (TR) sensor.
6. Install transaxle manual control lever. Tighten to 11-16 Nm (98-141 lb-in).
7. Install air cleaner outlet tube and engine air cleaner. Refer to Section 03-12 .
8. Connect battery ground cable. Refer to Section 14-01 .
9. Check for proper operation with parking brake control (2780) engaged. The engine should start only in PARK or NEUTRAL.