Use & Care Instructions
Total Page:16
File Type:pdf, Size:1020Kb
Start Here - BUBBLING LED KIT 3 GALLON HALF MOON Quick Setup Guide 1 Part Identification 2 Filter Setup 3 LED Airstone Setup Airline Tubing Air Pump A. Remove Filter Cartridge E. Using Suction Cups A. Connect a 36” Airline Tubing to Adjustable from package and rinse. attach Filter inside Aquarium. the LED Airstone’s Air Port Inlet. Connector Valves B. Insert Filter Cartridge 6 LED Airstone into Housing. B. Connect the other end Power Cord 36” Qt. 2 Air Inlet Port to the other Adjustable 3” Lid Connector Valve. 3” Power 6” Cord E 36” A B Adjustable Filter Assembly B Air Port Inlet T-Connector 36” Connector Valve Valve Cover A (Preassembled) C. Connect a 36” D 3 Gallon Airline Tubing to the Adjustable Half Moon Suction (Diffuser Tube) Connector Valve Cups C Diffuser Tube Aquarium Air Port Inlet. 3” Housing 3” Air Port Inlet T-Connector D. Connect the other Valve 3” end to one of the 3” (Preassembled) Air Inlet Diffuser Tube Adjustable Connector 6” Port 6” Filter O-Ring Valves. T-Connector Cartridge Valve (Preassembled) 4 Air Pump Setups (Typical or Above Tank) 5 Prepare Aquarium and Start Air Pump 6 Start Up A. Connect the 6” Tube coming from the A. Place Lid on Aquarium. Route Air Tubes T-Connector Valve to the Air Pump Air Port Outlet. and LED Airstone power cord through T-Connector cutouts in Lid. B1. Typical Setup: Place Air Pump lower than Valve water level in aquarium. Use a Check- (Preassembled) B1 Air Port Valve (Sold Separately) between the Air Outlet Pump and the T-Connector Valve. 6” Water NEVER: Place Air Pump directly Level at below aquarium. Check-Valve Filter Room NOTE: To avoid water siphoning into Stops water siphoning Spillway Temperature the Air Pump during electrical power A. Fill Aquarium with failure or when removing filter, a Check- B. Plug Air Pump B2 6” gravel and décor. Valve (Sold Separately) is recommended. Air Port & LED Airstone Outlet B. B2. Above Tank Setup: Add water and power cords into Tetra AquaSafe. Place Air Pump 12” higher than water level in aquarium. power outlet. T-Connector Water level should be This helps prevent water siphoning into Air Pump. Valve (Preassembled) at the Filter Spillway. NOTE: A Check-Valve (Sold Separately) is optional Make with the (Above Tank) setup. NOTE: Bury LED Airstone edges Drip Loops NEVER: Place Air Pump directly above aquarium. with gravel, to keep it in place. (for safety) For questions and concerns contact Customer Support 800.526.0650 • www.tetra- fish.com 02/11 29041-901.