MAGNASPHERE MSS-300S SERIES INSTALLATION INSTRUCTIONS: All Models of MSS300S-Series

Required Tools and Components Provided by Manufacturer (per module set) Provided by Installer 1 MSS-3XXS switch module Power drill 1 MSS-3XXS magnet module #36 Drill Bit or 7/64 4 #8 (x7/8" MIN) Flat Head Screws

MSS-3XXS 24" (60cm) Specifications CONTACT STATE SHOWN WITH MAGNET IN PLACE ARMORED BLK Max Current: 0.25 A Resistive CLOSED LOOP 4x #8 FLAT HEAD Max Voltage: 30 VDC BLK Max Power: .25 W Resistive WHT Suitable for Indoor and Outdoor use, for CLOSED LOOP U.S. and Canadian applications. The WHT Magnasphere MSS-3XXS series is

MODEL MSS-330S RED intended to be connected to a UL Listed CLOSED LOOP compatible control panel for US RED applications and a ULC Listed compatible control panel for Canadian applications. SWITCH MODULE CONTACT STATE SHOWN WITH MAGNET IN PLACE NOMENCLATURE BLK OPEN LOOP Surface mount BLK # of closed loops WHT OPEN LOOP MSS - 3 X X S-[‡] WHT MAGNET MODULE Triple loop capacity

MODEL MSS-303S RED OPEN LOOP # of open loops RED ‡ See p.2 for optional embedded resistor schemes

Installation Plan & Switch Orientation BEST PLACEMENT

Note: Modules are sensitive in one direction. Logos indicate the proper orientation as illustrated.

Note:

This orientation will 2" reduce the "MAX GAP" (51mm) 1" and should be tested (25.4mm) for function. Installation: The 3xxS should be mounted close to the latch side of the door for optimal performance. In order to meet UL 681 requirements, contact .3 (7 mm) .3" (7 mm) shall be installed so door cannot be opened more than 2 inches without MAX GAP

causing an alarm. Intended for operating gaps of up to 5/16” (8mm). 1/2" Ensure that the modules are well aligned. When synchronous switching (12.7mm) of the contacts is important, position modules to operate as depicted. Hold the switch module in position and drill one pilot hole; drive the #8 screw in until the module is seated. Repeat for the second hole. Repeat * these steps for the magnet module to insure accurate positioning. 1.5" Wire the switch according to the schematic. Check the operation of the (38mm) installed switch.

Patents #5977873, #RE39731, #6506987, #6303845, #6603378 & Other Patents Pending 05-2018 MSS-300S-INST REV. C MAGNASPHERE N22 W22931 Nancys Ct. Ste 3, Waukesha, WI 53186 tel 262.347.0711 fax 262.347.0710 www.magnasphere.com MAGNASPHERE MSS-300S SERIES INSTALLATION INSTRUCTIONS: Base Models P2 and Resistor-Embedded Models of MSS-300S-Series Schematics: All Base Model Infixes End-Of-Line Resistor Standard Models ( -### suffix)

CONTACT STATE SHOWN WITH MAGNET IN PLACE CONTACT STATE SHOWN WITH MAGNET IN PLACE CONTACT FORM DEFINED BY INFIX CONTACT FORM DEFINED BY INFIX CONTACT FORM DEFINED BY INFIX

BLK OPEN BLK OPEN BLK Circuit LOOP LOOP BLK Circuit BLK Circuit A A A

BLK BLK BLK BLK BLK

Circuit WHT OPEN WHT Circuit B WHT LOOP B

WHT WHT WHT

MODEL MSS-303S MODEL MSS-301S MODEL Circuit RED OPEN RED C 2 CIRCUIT POSITION KEY LOOP 3 CIRCUIT POSITION KEY 1 CIRCUIT POSITION KEY

RED RED

CONTACT STATE SHOWN WITH MAGNET IN PLACE CONTACT STATE SHOWN WITH MAGNET IN PLACE CONTACT FORM DEFINED BY INFIX MSS-3##S-001: CONTACT STATE SHOWN WITH MAGNET IN PLACE Series & Parallel 1k BLK CLOSED BLK CLOSED BLK Circuit BLK CLOSED LOOP LOOP 1kΩ 1kΩ 1kΩ 1kΩ A resistors on circuit A. LOOP

BLK BLK BLK One instance shown at BLK

WHT OPEN WHT CLOSED WHT Circuit right: WHT CLOSED LOOP LOOP B LOOP

WHT WHT WHT WHT MSS-3##S-001 MODEL MSS-330S MODEL MODEL MSS-312S MODEL

RED OPEN RED OPEN RED Circuit RED OPEN

LOOP LOOP C MSS-321S-001 MODEL LOOP

RED RED RED RED

CONTACT STATE SHOWN WITH MAGNET IN PLACE CONTACT STATE SHOWN WITH MAGNET IN PLACE CONTACT FORM DEFINED BY INFIX MSS-3##S-002: CONTACT STATE SHOWN WITH MAGNET IN PLACE Series & Parallel 1k BLK OPEN BLK CLOSED 1kΩ 1kΩ BLK CLOSED LOOP LOOP 1kΩ 1kΩ BLK Circuit A resistors on circuit A, LOOP

BLK BLK BLK BLK Series 1k resistor on

WHT CLOSED WHT OPEN WHT CLOSED WHT Circuit Circuit B. One instance 1kΩ 1kΩ LOOP LOOP LOOP B shown at right: WHT WHT WHT WHT MSS-3##S-002 MODEL MSS-302S MODEL MODEL MSS-320S MODEL RED OPEN RED Circuit C MSS-321S-002 MODEL LOOP

RED RED

CONTACT STATE SHOWN WITH MAGNET IN PLACE CONTACT STATE SHOWN WITH MAGNET IN PLACE CONTACT FORM DEFINED BY INFIX MSS-3##S-003: CONTACT STATE SHOWN WITH MAGNET IN PLACE Series 1k resistor on BLK CLOSED BLK CLOSED LOOP LOOP BLK Circuit 1kΩ BLK CLOSED A Circuit A. One instance LOOP

BLK BLK BLK shown at right: BLK

WHT CLOSED WHT Circuit WHT CLOSED LOOP B LOOP

WHT WHT WHT MSS-3##S-003 MODEL MSS-321S MODEL MSS-310S MODEL

RED OPEN 1kΩ RED Circuit RED OPEN LOOP C MSS-321S-003 MODEL LOOP

RED RED RED

CONTACT STATE SHOWN WITH MAGNET IN PLACE CONTACT FORM DEFINED BY INFIX MSS-3##S -004: CONTACT STATE SHOWN WITH MAGNET IN PLACE Series 1k resistor on BLK CLOSED BLK CLOSED LOOP BLK Circuit 1kΩ 1kΩ LOOP A Circuit A and on Circuit BLK BLK BLK B. One instance shown

WHT OPEN at right: Circuit WHT CLOSED LOOP 1kΩ WHT B LOOP

WHT WHT

MSS-3##S-004 WHT MODEL MSS-311S MODEL

RED OPEN

RED Circuit MSS-330S-004 MODEL LOOP C

RED RED

End-Of-Line Resistor Custom Models ( -i#-#-#-#-#-# suffix) i#-#-#-#-#-# Scheme: CONTACT FORM DEFINED BY INFIX Examples: CONTACT STATE SHOWN WITH MAGNET IN PLACE CONTACT STATE SHOWN WITH MAGNET IN PLACE

"-i" precedes custom resistor (kΩ) 1 MSS-321S Circuit 2 BLK 300Ω 180Ω BLK CLOSED A -i.18-.3-1-N-N-1 LOOP 1kΩ BLK CLOSED values separated by hyphens. The LOOP

BLK BLK sequence of entries correlates to the At right. BLK 3

WHT Circuit MSS-330S WHT CLOSED WHT CLOSED positions depicted in the key. "N" is 4 1kΩ 1kΩ B LOOP LOOP used as a null place-holder (No resistor -i1-N-1-N-N-N WHT WHT WHT

for this position). Contact Magnasphere 5 as an alternate ID MSS-321S MODEL -i.18-.3-1-N-N-1

RED Circuit RED OPEN MSS-330S-004 MODEL RED CLOSED 6 1kΩ

RESISTOR POSITION KEY POSITION RESISTOR C to MSS-330S-004, LOOP LOOP for nomenclature guidance and for or MSS-330S-i1-N-1-N-N-N resistor value availability. RED last to the right. RED RED