It is recommended that you refer to a qualified service center if you are unfamiliar with vehicle chassis and suspension repair work. This instruction is intended as a guideline for the safe installation of Energy Suspension polyurethane bushings Installation instructions after original equipment has been removed from the vehicle. Reference the vehicle manufacturer's service manual for component removal and replacement R procedures and torque specifications. Before beginning work, read installation 1131 VIA CALLEJON, SAN CLEMENTE, CA 92673 63-67 Corvette instructions and verify parts received match P/N's and quantities in the parts list. In the case of a discrepancy, contact Energy Suspension Customer Service (949- 361-3935). Energy Suspension parts are designed to work with vehicles in a good 3.4102 Coupe (hard top) state of repair. We cannot be held responsible for suspension or steering related C 2018 Energy Suspension. All rights reserved. problems occurring due to poor vehicle maintenance. Wheel alignment is altered May not be reproduced, in any form, or by any means, when suspension components are removed and replaced. It is highly without the written consent of Energy Suspension. 3.4152 Roadster () recommended that your vehicle is checked and adjusted by a qualified alignment shop prior to use.

Read these instructions carefully before installing mounts. 63-64 Seat belt cushion NOTE: Be sure on disassembly to note the quantity and positions of any shims or spacers that may have been inserted for body alignment. These shims or spacers positions NOT INCLUDED. 17/SEP/18 BRH ECN 18068

17055 will have to be re-used to insure proper body alignment. Position # 2 is for convertible only. 63-64 Corvettes used cushions at the seat belt mounts, be sure to remove the bolts from this position before raising body. Install mounts one side at a time with bolts on other side loosened only! Customer must reuse or replace if O.E. hardware is unuseable (bolts, lock washers, shims, spacers and nuts). REMEMBER: Only raise body high enough to remove & replace mounts. Always watch the fan shroud for sufficient clearance when raising body. When jacking 3 4 body use a long enough 2x4 - 4x4 for maximum support. Never put jack directly on 2 body panels. Re-torque to factory specifications. 1 NOTE: Actual parts may vary from graphical depiction below. Frame Position Diagram

NOTE: Position # 2 Body is for convertible only and is supplied Note the Quantities and positions of shims and in set # 3.4152 re-use. Note the Quantities and positions of shims and Supplied flat washer Supplied flat washer 1.750”x .438” x .120” Body 2.00” x .500” x .125” re-use. Part#15.03.13.39 Part#15.03.05.39 Frame #4007 Supplied sleeve #4006 Frame Supplied flat washer .688” x .500” x .937” 2.00” x .500” x .125” Part#15.10.99.39 Supplied sleeve Part#15.03.05.39 .688” x .500” x .937”

#4006 #4006 Part#15.10.99.39 Supplied sleeve .688” x .500” x .937” Supplied flat washer #4007

Part#15.10.99.39 2.00” x .500” x .125” #4007 Part#15.03.05.39 Supplied flat washer Body 1.750”x .438” x .120” Supplied flat washer Note the Quantities and Frame Part#15.03.13.39 1.750”x .438” x .120” positions of shims and Position 1 Part#15.03.13.39 re-use. Positions 2&3 Position 4